Current Attempt in Progress In the figure, a wire loop of dimensions L = 42.6 cm and W = 26.7 cm lies in a magnetic field. What are the (a) magnitude 8 and (b) direction (clockwise or counterclockwise-or "none" if 8 = 0) of the emf induced in the loop if B = (5.00 x 10-2 T/m)yk? What are (c) and (d) the direction if B = (6.21 x 10-2 T/s)tk? What are (e) and (f) the direction if B = (8.00 x 10-2 T/m-s)ytk? What are (g) and (h) the direction if B = (3.02 x 10-2 T/m-s)xtj? What are (i) and (i) the direction if B = (5.00 x 10-2 T/m.s)yti?

Current Attempt in Progress In the figure, a wire loop of dimensions L = 42.6 cm and W = 26.7 cm lies in a magnetic field. What are the (a) magnitude 8 and (b) direction (clockwise or counterclockwise-or "none" if 8 = 0) of the emf induced in the loop if B = (5.00 x 10-2 T/m)yk? What are (c) and (d) the direction if B = (6.21 x 10-2 T/s)tk? What are (e) and (f) the direction if B = (8.00 x 10-2 T/m-s)ytk? What are (g) and (h) the direction if B = (3.02 x 10-2 T/m-s)xtj? What are (i) and (i) the direction if B = (5.00 x 10-2 T/m.s)yti?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter11: Magnetic Forces And Fields

Section: Chapter Questions

Problem 89AP: The current through a circular wire loop of radius 10 cm is 5.0 A. (a) Calculate themagnetic dipole...

See similar textbooks

Similar questions

The armature and field coils of a series-wound motor have a total resistance of 3.0 . When connected to a 120-V source and running at normal speed, the motor draws 4.0 A. (a) How large is tire back emf? (b) What current will the motor draw just after it is turned on? Can you suggest a way to avoid this large initial current?
The current through a circular wire loop of radius 10 cm is 5.0 A. (a) Calculate themagnetic dipole moment of the loop. (b) What is the torque on the loop if it is in a uniform 0.20-T magnetic field such that p and B are directed at 300 to each other? (C) For this position, what is the potential energy of the dipole?
Verify the units obtained for magnetic field strength B in Example 24.1 (using the equation B=Ec ) are in fact teslas (T).
Check Your Understanding A long solenoid of cross-section area 5.0 cm2is wound with 25 turns of wire pet centimeter. It is placed in the middle of a closely wrapped coil of 10 turns and radius 25 cm, as shown below. (a) What is the emfInduced In the coil when the current through the solenoid Is decreasing at a rate dl/dt= -0.20A/s? (b) What Is the electric field Induced In the coil?
Is the direction of the magnetic field shown in Figure 24.6 (a) consistent with the right—hand rule for current (RHR-2) in the direction shown in the figure?
Identical currents are carried in two circular loops; however, one loop has twice the diameter as the other loop. Compare the magnetic fields created by the loops at the center of each loop,
Is an emf induced in the coil in Figure 23.54 when it is stretched? If so, state why and give the direction of the induced current. Figure 23.54 A circular coil of wire is snatched in a magnetic field.
A metal bar of mass m slides without friction over two rails a distance D apart in the region that has a uniform magnetic held of magnitude B0 and direction perpendicular to the rails (see below). The two rails are connected at one end to a resistor whose resistance is much larger than the resistance of the rails and the bar The bar is given an initial speed of vg. It is found to slow down. How far does the bar go before coming to rest? Assume that the magnetic held of the induced current is negligible compared to B0
A square bar of mass m and resistance R is sliding without friction down very long, parallel conducting rails of negligible resistance I see below) The two rails are a distance ' apart and are connected to each other at the bottom of the incline by a zero-resistance wire. The rails are inclined at an angle , and there is a uniform vertical magnetic field B throughout the region, la) Show that the bar acquires a terminal velocity given by vmgRsinB2I2cos2 Calculate the work per unit time done by the force of gravity. (c) Compare this with the power dissipated in the Joule heating of the bar (d) What would happen if B were reversed?
The accompanying figure shows a conducting ring at various positions as It moves througli a magnetic field. What is the sense of the induced em! for each of those positions?
Draw a diagram and use RHR-l to show that the forces on the top and bottom segments of the motor’s current loop in Figure 22.34 are vertical and produce no torque about the axis of rotation.
The accompanying figure shows a metal disk of inner radius r1 and other radius r2 rotating at an angular velocity while in a uniform magnetic field directed parallel to the rotational axis. The brush leads of voltmeter are connected to the dark's inner and outer surfaces as shown. What is the reading of the voltmeter ?