Curved panel BC in Fig. P2.96 is a 60° arc, perpend lar to the bottom at C. If the panel is 4 m wide into paper, estimate the resultant hydrostatic force of the w on the panel. 2 m B R = 3 m Water 60° P2.96 C

Curved panel BC in Fig. P2.96 is a 60° arc, perpend lar to the bottom at C. If the panel is 4 m wide into paper, estimate the resultant hydrostatic force of the w on the panel. 2 m B R = 3 m Water 60° P2.96 C

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter14: Lateral Earth Pressure

Section: Chapter Questions

Problem 14.7P

See similar textbooks

Related questions

Q: Examine the rotational stability of the wall below 3 m 32 y=20 kN/m' $ = 36° For the right side: 6 =…

A: Given: A retaining wall as shown below Required: To examine rotational stability

Q: What is the vertical reaction at point A? 37.286 KN 35.0 KN 40.714 KN 39.0 KN What is the…

Q: A 3-m-high, 9.5-m-wide rectangular gate is hinged at the top edge at A and is restrained by a fixed…

Q: P.6.3 The three-pinned arch shown in Fig. P.6.3 is parabolic in shape. If the arch carries a uniform…

A: Given data:

Q: 18 kN/m A 5.8m 17 m 22.7 kN/m 10.6m 75 KN D 1. Calculate the reactions at B and C 2. Calculate the…

Q: Find the support reactions and join force of the construction. If q=24 kNlm M = 10kNm and L=3

A: Given, the construction with UVL, joints and supports q=24 kNlm M = 10kNm L=3 m To find Support…

Q: Determine the magnitude of the projected component of the 3 kN force acting along the axis BC of the…

A: Given: The force is 3 kN. Consider the figure,

Q: Q4: A 4-m-high, 5-m-wide tangular plate blocks the end of a 4-m-deep freshwater channel the plate is…

Q: Solve the axial forces of the members indicated in the box below 50 KN 75 KN 25 KN 3.00 m 3.00 m…

A: To find force in member AE,BC,CE,FG

Q: Determine the Vertical Reactions at A and B, (Av, Rb) 50 kN/m 50 kN/m "A – 4.5 m- 4.5 m-

A: This is a case of propped cantilever where one end is fixed and other end is propped.

Q: Using area moment method, find the reactions of the structure. 75 kN - m 120 kN B 6 m 6 m

Q: Problem nr.2 Compute the A, C reactions for the 3 hinged arc. below. Determine HD, VD, MD. lokips B…

A: Given :

Q: A horizontal force P = 69,651 N is pushing an inverted L-frame supported by a foundation at the…

Q: 2 m 1 m 25KN

A: To find out the shear for at T.

Q: Problem 2. Determine the hinge reactions (in kN) at point B on the beam shown. 20 KN 20 KN 20 KN 20…

Q: Q.02. The floor beam in below figure is used to support 6 meters width of a plain concrete slab…

A: The given data is: Width of plain concrete slab (bc) = 6 m Thickness of plain concrete slab (hc) = 4…

Q: Analyze the structure below using cantilever beam method 25KN C 3m 50KNB H 4m 6m -8m- SOLVE the…

A: Given data in question Frame Horizontal loading To find out Centroidal distance from column ABC

Q: Determine the slope at A and vertical displacement at B 10 kN/m B 3 m 4 m A - 4 m Resultant reaction…

A: As a result of vertical displacement, uplift and subsidence occur as the result of moving land…

Q: THEORY OF STRUCTURES Using the Portal method of analysis , determine the vertical reactions at the…

Q: A force of 60N is provided by a jet of water of cross-section area 10cm² which strikes a wall and…

A: In the problem Given data: Force provided by the jet to the wall F = 60N Cross-section of the jet A…

Q: An elliptical plate, major axis 6 ft, minor axis 4 ft, is submerged vertically until its center is 2…

Q: 9, = 22.5 kPa %3D H, = 2.5 m Yr = 17 kN/m3 O = 25° %3D H2 = 4.5 m Ysat = 18.5 kN/m3 O = 30° %3D a)…

Q: Problem 1. Determine the hinge reactions (in kN) at point B for the beam shown. 100 KN/m 60 KN/m AB…

A: The length of beam = 10mThe beam is simply supported with hinge at left end and roller at right…

Q: Gate AB in Fig. P2.51 is 1.2 m long and 0.8 m into the paper. Neglecting atmospheric-pressure…

Q: A rectangular plane, 1.2 m by 1.8 m is submerged in water and makes qn angle of 30° with the…

Q: vertical displacement of joint C of the steel truss show 05i-

A: ## Determination of Vertical deflection at joint C ##

Q: 1. Solve the axial forces of the members indicated in the box below. be 00.ne 150 KN 175 KN 125 KN…

Q: 2m WIDE PI 3m Find the magnitude of the hydrostatic force. a. 146.7 kN b. 199.3 kN Im 4m c. 294.3 KN…

Q: A flat plate (4m * 1m ) hinged at the top 1m edge serves as a wide wall of tank containing oil of…

A: Horizontal Force on the bottom: F = SρgAx¯, whereS = sp gravityρ = density of water, 1000 kg/m3g =…

Q: The top of a rectangular gate 1.20 m wide rest against a vertical wall at A. The bottom of the gate…

Q: P.6.4 In the three-pinned arch ACB shown in Fig. P.6.4 the portion AC has the shape of a parabola…

Q: 125mm Determine the maximum and minimum shearing 25mm stress developed in the web of the wide-flange…

A: Shear stress is the type of shear that creates the shearing surfaces glide towards in opposite…

Q: ground surface y = 16.5 kN/m3 $ = 30° %3D 3m water table Ysat = 19 kN/m3 $ = 30° 3m

A: The answer of this problem is found to be Force=132.18KN per metre length For explanation please see…

Q: An equilateral triangular plate of side 2.4m placed horizontally in a liquid (sp. gr. 0.80) in such…

A: Length of side of the triangle, a=2.4m Area of the equilateral triangular plate…

Q: Calculate the support reactions? b) Immediately after support A, just before point B and immediately…

Q: 2 The dam in Fig. P2.92 is a quarter circle 50 m wide Into the paper. Determine the horizontal and…

A: The horizontal component of force may be projected on to a vertical plane, it calculated as below,…

Q: 8 KN/m 2m B D 4m A 3m 3m

A: Given data:

Q: Analyze and find all reactions at supports due to a vertical settlement of (5 cm) at point (C) for…

A: Given -

Q: Using the Portal method of analysis , determine the vertical reactions at the support caused by the…

Q: A circular plate 2m in diameter is submerged in water with its higher and lower edges located at 2m…

A: Given :

Q: 10 kN B 6 m 3 m D 3 m A 60 kN Determine the magnitude of the vertical reaction force (in kN) at C.

Q: 30 kN Find the reactions in datums A and B for the threshold shown in Figure 3. +10m+ 3.0m 2- Answer…

Q: Q1) Determine the reactions at point A and B for the steel bar shown. A 300 mm 250 250 KN 250 m 600…

Q: 9, = 18 kPa H = 3 m Ysar = 18 kN/m3 %3D O= 25° H2 =4.5 m Ysat = 19.5 kN/m3 %3D O' = 30° %3D

Q: Problem 2: The shaft is supported by smooth journal bearings at A and B that only exert vertical…

A: allowable bending stress is 200 MPa.

Q: # 6] A closed cylindrical tank 2m in diameter and 8m deep with axis vertical contains 6m deep of…

A: The pressure exerted on the cylindrical tank: The pressure on the bottom of the tank depends on the…

Q: 2.65 Gate AB in Fig. P2.65 is semi- circular, hinged at B, and held by a horizontal force P at point…

Question

Curved panel BC in Fig. P2.96 is a 60° arc, perpend
lar to the bottom at C. If the panel is 4 m wide into
paper, estimate the resultant hydrostatic force of the w
on the panel.
2 m
B
R = 3 m
Water
/ 60°
P2.96
C

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A verical gate 1.6m wide and 2m high has water on side and is inclined 45° with the horizontal. Water is 1.50m above the top of the gate. With the gate hinged at B. Determine the hydrostatic force acting on the gate
d. Total earth thrust (in kN per meter length of wall) Fa = e. Location of the total earth thrust from the base of wall (in meter) ya = Thanks
When the water at tide A descends, the tide gate automatically rotates by opening to drain the water from swamp B. For the high tide condition shown, determine the horizontal reactions developed in joint e and stop D. The length of the gate is 22 cm and its height is 4 m. ρ agua = 1 .0 Mg/m3.
Dam is concrete gravity dam that impounds water both on the upstream and down stream sides. if the coeffient of friction between the base and the dam is 0.34, determine the following: 1. total vertical reaction in kN 2. total horizontal reaction in kN 3. factor of safety against sliding 4. factor of safety against over turning 5. if the hydrostatic uplift varies linearly from 0 at the heel to zero at the toe, determine the foundation pressure.
For the frame and loadings shown P=2240 KN, and F=1120 magnitude of verticalreaction at E magnitude of verticalreaction at A magnitude of verticalreaction at C
Application of Equilibrium Solve for the value of unknown variables Given : P1 = 10KN W1 = 5 KN/m P2 = 6 KN W2 = 10 KN/m θ= 58° a.Unknowns: RAy , RBy , RBx , MB b. compute the internal shear 1.35 m to the right of support A
Given Figure E1, draw the active earth pressure distribution. Use gw = 9.81 kN/m3. Determine the magnitude and location of the active thrust.
A rectangular scow 6.5 meter wide, 10 meter long and 4 meter high is submerged in fresh water by 2 meter. Its center of gravity is fixed at 3.2 meter above the bottom of the scow lying at the vertical axis of symmetry. An additional weight was placed in the scow causing it to submerge further. If the additional weight is equal to 360 kN and is placed 3 meter to the right of the axis of rotation, solve the following:1. Total draft2. Angle of tilt3. Moment arm, x4. Metacentric Height
A concrete gravity dam has the following data: Maximum water level = 300.00 m Bed level = 220.00 m R.L top of dam = 304.00 m %3D The d/s slope of 0.67:1 starts at RL of 295.00 m U/s face is vertical. Center line of the drainage gallery = 8.0 m from u/s face. Consider only weight of dam, water pressure and uplift pressure. Calculate only the normal stresses at the toe and heel of the dam, assuming 100% uplift pressure at the h eel and 50% at the gallery and zero at the toe.
Determine the resultant force (kN) due to water acting on the 4m by 1m triangular area CD. The apex of the triangle is at C. (γwater = 9.81 kN/m3). Solve for magnitude N and the location (m) of the resultant force due to water acting on the 4m by 1m triangular area CD. The apex of the triangle is at C. theta = 27 degrees.
The corner plate of the hull of the ship is curved on the arc of a circle with a 1.5 m radius. If the bottom of the hull is 4.3 m below the seawater (S.G. = 1.03) surface, what is the magnitude of the force acting on the curved corner plate for 1-meter length of the hull section?
A smooth backed vertical wall is 6.3m high and retains a soil with a bulk unit weight of 18 KN/m^3 and angle of friction 18 degrees. The top of the soil is level with the top of the wall and is horizontal. If the soil surface carries a uniformly distributed load (surcharge) of 4.5 KN/m^2, what is the difference in active moment at the base of the wall with surcharge and without surcharge.