Answered: D-For the circuit shown, find the value…

D-For the circuit shown, find the value of R such that the power supplied by the 100-volt source is the same as the power supplied by the 5 A source. V 3R en Ole SA lloov

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 11PP: In an R-L parallel circuit, ET=208 volts, R=2.4k, and XL=1.8k. Find IT.

See similar textbooks

Related questions

Q: For the network below: a. Find currents Is, 12, and 16. b. Find voltages V1 and VS. C. Find the…

Q: If the power absorbed by the 4-kQ resistor in the circuit shown is 36 mW, find VS. 9 k2 4 k2 12 k2…

Q: A network delta is shown in figure below. Find the resistances of an equivalent wye (Y) network. R,…

A: Delta to Y- conversion

Q: In the network below, find the power associated to the current source, for V1 = 12 V. V1 + 24 +41 2…

A: Given, The circuit is, V1=12 V

Q: Find the currents passing through the resistors in the circuit given below and the power dissipated.…

A: Assure node voltage V1,V2,V3 and V4 as shownFrom circuit:- V1=E1=157V Vx=V2-V3…

Q: For the circuit shown below, a) find the load resistance, RL, to obtain maximum power transfer in…

A: This question belongs to circuit theory . It is based on maximum power transfer theorem . For this…

Q: Q3) For the circuit shown, find the condition for maximum power transfer to the load. Then, find the…

Q: +- | 1 :3Ω V, +-) V3 (+1

Q: for the circuit shown, determine t Ui cVz . ) Power at (3u) & (2011) t. Sust 10MA Зил 20ks V2

A: We can find voltage drop by considering a node voltage V and then applying nodal analysis. After…

Q: A little help with this Thevenin's Theorem question be appreciated. Thanks

Q: Q2: Find the current flowing through the RL= 1kQ resistor for the circuit shown in Figure below…

A: Find the current in the resistance 1k ohm We are solving this problem using the Thevenin theorems…

Q: 3. Determine the Resistance (R) to be added for the electrical circuit to supply maximum power…

Q: Q2)Solve the following problem In the network shown in figure below, find the value of RL such that…

A: In this question we need to find maximum power and load resistance for transfer maximum power to…

Q: Find the power dissipated in the 12-ohm resistor and the power delivered by the current source. 3Ω…

A: In this question, Find the power across the 12 ohm resistance. And power across the 2A current…

Q: SOLVE FOR MAXIMUM POWER( PMAX) AS SHOWN IN THE NETW OR K BELOW: 40요 15 V- 1600 RL

A: First calculate thevenin equivalent circuit from the RL terminals. For maximum power transfer to…

Q: R5 16 V ,4Ω 4Ω E, 30 ET R1 12 V 10 Ω R6 R43 E3 15 V

Q: Q2: For the circuit shown below, find the maximum and minimum power consumed by the load resistance.…

A: (i) Vs=60 vhence Vo=1k1k+5k×60V0=10vFor this Zener diode was not conduct(ii) If Vs=100…

Q: In the network shown, the power absorbed by the 4-0 resistor is 100 W Find VS + Vs Select one: O a.…

Q: Q1: Find the power of the 10-V voltage source? Is it supplying energy to the circuit or absorbing…

A: In the circuit, independent voltage and current source are consist. Find the power in the 10V…

Q: For the circuit in the figure, find the ones requested in the questions by using the following…

A: Here it is asked to find the minimum and maximum load resistance with the informations given. Here…

Q: Q2) For the circuit shown, find the condition for maximum power transfer to the load. Then, find the…

Q: Q2: For the network in following Figure: a. Calculate Z7. Xe b. Determine Is. c. Calculate VR and Vc…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: 2. In the circuit of the figure below, the source resistance R, is variable between 5 ohms and 50…

A: For maximum power total circuit resistance should be equal to the load resistance. The load…

Q: *Q2: For the circuit shown, find v1 throu 15 V 25 V 10 V 20 V None of the mentione

A: As, per bartleby guidelines for more than one question asked only first is to be answered please…

Q: Use the rode - voltage methad to find the power developed by the 20v Source in the arcuit. Va 252…

A: First we will find out the node voltage by nodal analysis then we will find out current delivered by…

Q: For the circuit shown below, a) find the load resistance, RL, to obtain maximum power transfer in…

A: The solution solution is given

Q: For the below circuit, determine the value of RLoad which results in the maximum power transfer, and…

A: Given: In the above given question they have mentioned an electrical circuit having independent…

Q: Find V, and the power absorbed by the dependent source in the given circuit. Assume / = 21 A. 1092…

A: Given circuit:

Q: Example: Find the current in the 12 k2 load resistor in the circuit shown in Figure below. 1 mA 2 mA…

A: Given, The circuit is

Q: Q2/ For the network shown in figure, the value of current through 202 resistor is? 60 V 200 120 80

Q: In the network below, find the power associated to the current source, for V1 = 12 V.

A: In a closed loop network total voltage across loop is equal to the sum of all the voltage drop…

Q: Q) Using nodal analysis, find current i, and the power dissipated in the 4-ohm resistor in the…

Q: From the given circuit, find I, the power dissipated by the resistor, and the power supplied by each…

A: Perform the following steps to get the required answers: 1. Apply the KVL in the given close loop to…

Q: Use the node-voltage method to find power associated with each source in the circuit shown in figure…

A: Here, by using nodal equation From the given figure take one node as V1 and another node as V2…

Q: For the circuit find voltages v, and v2. www 20 V

A: KVL (Kirchhoff's Voltage Law) states that the algebraic sum of all voltage in a closed loop is zero.…

Q: 2. Find the value of R shown in the circuit such that the power supplied by the 100 V source to the…

A: In the circuit, the voltage across 20Ω resistor is equal to 100 V because the 100 V voltage source…

Q: Using Norton's theorem, find the current flowing through the resistor RL of the network in milli…

A: I HAVE EXPLAINED IN DETAIL

Q: Q2/ For the network shown in figure, the value of current through 200 resistor is? 60 V 202 120

A: First we need to find current I. then by current division we can find current through 20 ohm. let…

Q: Q2/ For the network shown in figure, the value of current through 200 resistor is? 60 V 200 120

A: First we need to find the current I. Then we will use current division to find current through 20…

Q: Using Kirchhoff’s Law: In the circuit shown below, the 3A of current running through the 4Ω Resistor…

A: The above circuit can be solved using either of the circuit theories mentioned below: Kirchhoff's…

Q: Q2/ For the network shown in figure, the value of current through 200 resistor is 60 V 200 120 80

A: The given circuit is:

Q: Homework: For the network depicted in the figure below, determine the load resistance value to…

A: The given circuit is,

Q: H.W. 2.7: current supplied by battery in the circuit shown in Figure by using Kirchhoff's' laws.…

A: Kirchhoffs Voltage Law or KVL, states that “in any closed loop network, the total voltage around the…

Q: Find the Thévenin equivalent circuit for the network in the shaded area of the network of figure…

A: In the given question two electrical circuits are given and it is required to obtain Thevenin's…

Q: a) Use delta-star conversion to find a resistance between terminals 'AB' of the circuit shown in…

A: Series Connection of Resistors: When n no. of resistors are connected in series, their equivalent…

Q: Consider the circuit of resistors shown. Find the equivalent resistance Re • Find the currents…

Q: Practice Problem Find the currents and voltages in the eireuit shown, using Kirchoffi laws. 2n 1, 4A…

A: Nodal Analysis - It is used to find node voltage using Kirchhoff's current law. Kirchhoff's current…

Q: Example: Find the current I, in the network in Figure below. 6 k2 ww 2V 12 k2 V2 12 k2 6 kn V +)6V…

A: The given circuit is,

Concept explainers

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.

Question

I need the answer as soon as possible

D-For the circuit shown, find the value of R such that the power supplied by the
100-volt source is the same as the power supplied by the 5 A source.
SA
V 3R
lloov

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A load is connected to a network. At the terminals to which the load is connected, Rth = 10 Ω and Vth = 40 V. The maximum possible power supplied to the load is
The resistance of a certain aluminum power line is 150 Ω at 200 Find the line resistance when the sun heats up the line to 420C. First, use the inferred zero resistance temperature formula and then the temperature coefficient of resistance formula to show that the two formulas are equivalent.
A small plant has been constructed and the costs are known. A new plant is to be estimated with the use of the exponential (power sizing) costing model. Major equipment, costs, and factors are as shown in the shown table. (Note MW = 106 Watts.) If ancillary equipment will cost an additional $200,000, find the cost for the proposed plant.
Be able to state and use Ohm’s law For the circuit shown, If vg=1 kV and ig=5 mA, find the value of R and the powerabsorbed by the resistor.
Using Kirchhoff’s Laws, calculate the current flowing through each branch of the circuit shown inFig. 15.2
In an R-L parallel circuit, ET=208 volts, R=2.4k, and XL=1.8k. Find IT.
In the circuit shown, a) obtain the condition from maximum power transfer to the load Rl. Hence, determine the maximum power transferred.
Using the DC circuit trainer, connect the circuit shown in Fig. (2). take E =10V, R1=82Ω and R2 = 100Ω . Use CDR to calculate currents of "R1 , R2 .
With no load attached, the voltage at the terminalsof a particular power supply is 50.8 V. When a 10-Wload is attached, the voltage drops to 49 V.a. Determine vS and RS for this nonideal source.b. What voltage would be measured at the terminalsin the presence of a 15- load resistor?c. How much current could be drawn from this powersupply under short-circuit conditions?
Using the DC circuit trainer, connect the circuit shown in Fig. (1), take E =10V, R1=82Ω, R2 = 100Ω and R3 =150Ω, use VDR to calculate voltages of the "R1 , R2 & R3".
Determine the value of the load resistance RL as shown in the circuit below that gives maximum power dissipation and calculate the value of the maximum power .
Give four farming operations requiring electrical power. Discuss the advantages anddisadvantages of using electricity in each farm operation.