(D2-40 +4)y=ex

Q: 49. The following data are given for the laboratory sample. o = 175 kPa; e = 1.1;o+Ao = 300 kPa; e =…

A:

Q: Using the e-log (effective stress) plot explain the stages of preloading in civil engineering…

A: Consolidation is the process of removing the pore water by applying the load and the settlement…

Q: A reinforced concrete beam has the following properties:  Beam width = 320 mm  Effective depth =…

A:

Q: The EPA regulates water in the US. supply and sets standards for drinking water. The. water…

A: Solution (a)  The EPA regulates water in the US drinking water  supply and sets standards for…

Q: 9-61. Determine the location y of the centroid C of the beam having the cross-sectional area shown.

A: Given : Determine the location y of the centroid C of the beam ?

Q: A simple horizontal curve has 35 degrees of curvature and subtends an angle of 110 degrees.

A: Given: Degree of curvature, D = 35 Degrees Angle subtended, Δ = 110 degrees Station PC = 3+65.00 ft…

Q: Cross-sectional area of 0.0026 m² of a horizontal jet of water hits a fixed vertical plate with a…

A: Given,  Cross sectional area (A) = 0.0026 m² Velocity of water jet (V) = 3 m/s   To find out the…

Q: 5. Replace the loading system by an equivalent resultant force and specify where the resultant's…

A:

Q: A 1,065 ft", / in. thick concrete wall has inside and outside surface temperatures of 25°C and 9°C.…

A:

Q: From the given closed, adjust the bearing assume that the error is the for each anghe. Line 1-2 2-3…

A: Given: LINE REDUCED BEARING  WHOLE CIRCLE BEARING (WCB) 1-2 N 45° E 45° 2-1 S 45° 20' W 225°…

Q: 1.2 A catchment area of 140 km² received 120 cm of rainfall in a year. At the outlet of the…

A:

Q: amount of hydrated cement equal

A: Given: Amount of cement = 120 g Water to cement ratio, w/c =0.48 Degree of hydration = 50% To…

Q: A foundry has a fixed daily cost of Rs. 50,000 whenever it operates and a variable cost of Rs. 800…

A: Given, Fixed daily cost=  Rs. 50000 Variable cost = 800Q,

Q: A pitched roof to be provided for a workshop of effective span 18 m. The trusses are spaced at 4 m…

A:

Q: Utilize conjugate beam method. (moment by parts for BMDiagram) Identify the deflection and slope at…

A: A beam ABC with AB as overhang potion and simply supported at B and C The overhanging portion is…

Q: A vertical curve is needed to join to tangents; G₁=1% and G2-4%. Assuming a level grade (0%) for…

A:

Q: The diameter of the shaft, shown below, is 60 mm and it is made of A-36 steel (E = 200 GPa and G =…

A:

Q: 3) The 4 KM load is hoisted at a constant speed using motor M, which has a weight of 0.45 KN.…

A: Given: Load hoisted on the motor = 4kN Weight of motor = 0.45 kN Self-weight of the beam = 0.6 kN/m…

Q: The cantilevered beam pictured below has a solid 1 mm x 1 mm square cross-section. How far will the…

A: Given: Load P=100 N Length of of cantilever beam L=10 m Dimension of square cross section =1mm×1mm…

Q: 300 N 100 N/m -1.5 m 1.5 m B -3 m 300 N-m

A:

Q: 20. A steel section is subjected to a combination of shear and bending actions. The applied shear…

A: Using IS800-2007

Q: An equation for the hydraulic head in the unconfined aquifer between the two canals. An estimate of…

A: To find flow rate and equation of hydraulic head

Q: Determine the reactions at the support And C of the following beam. Note that there is an internal…

A:

Q: The 4-mm-diameter cable BC is made of a steel with E = 200 GPa. Knowing that the maximum stress in…

A: tan θ=ACABtan θ=6.58.5θ=37.405°BC=AC2+AB2      =6.52+8.52      =10.700 mDiameter of cable, d=12…

Q: A 3 - hinged parabolic arch of 16m span has its abutments A and B at a depth of 4m and 8m…

A:

Q: The water level in a large aquifer with a surface area of 10000 km2 has dropped by 10 m on average…

A: Using formula

Q: One Side of a regular pentagon is 120.00 meters long. The elevation of each corner are respectively…

A: Given:-  Side length of pentagon = 120.00 m Elevation of corner 1 = 10.6 m Elevation of corner 2 =…

Q: g(x) = 2x2 +3-32

A: Let gx be a continuous function defined on a,b such that ga<s<gb  then there exist some x∈a,b…

Q: 49. The following data are given for the laboratory sample. o=175 kPa; e = 1.1; +Ao = 300 kPa; e =…

A:

Q: Using double-integration method, determine the slope and the displacement at the end of the C of the…

A:

Q: 2. Determine the magnitude of the resultant force acting on the screw eye and its direction measured…

A: Ni

Q: PROBLEM: A built up section of A992 steel is made from plates fully welded together. The flanges…

A:

Q: x² + cos x x-x5+x-2x² lim

A: Squeeze theorem states that for  fx≤gx≤hx and at some point x=k we have limx→h fx=limx→h hx=l then…

Q: The minimum value of 15 minute peak hour factor on a section of a road is A. 0.10 B. 0.20 C. 0.25 D.…

A:

Q: Calculate the deflection at B in terms of El. Express your answer in two decimal places and do not…

A: Using Macualay's method Considering EI is in KN/m2

Q: Q-Water is flowing a critical depth at a section in a A shaped channe with side lopes of 0.5 H:1V.…

A:

Q: Design an axially loaded short square tied column for Pu = 2600 kN if f’c = 28 MPa and fy = 350 MPa.…

A:

Q: Refer to column cross-section show below and determine column design capacity. Design column ties…

A:

Q: IDETIFY THE TENSION DEVELOPED IN 3 CABLES REQUIRED TO SUPPORT THE TRAFFIC LIGHT WITH THE MASS OF…

A:

Q: Calculate the deflection at B in terms of El. Express your answer in two decimal places and do not…

A: Given: A simply supported beam carrying number of point loads. Where, support A is hinged and B is…

Q: A 10 inch long silver wire is stretched to a total length of 11.50 inches. Find the value of strain

A: Introduction : The given question is related with solid mechanics . The question is provided total…

Q: Problem 4 --- A soil sample from a certain excavation has the following grain size characteristics;…

A: GI=17 Liquid limit (LL)= ? Plasticity index(PI)=24

Q: bearing strength of concrete

A: Given,  Determine the bearing strength of concrete in limit state method.Grade of steel column= Fe…

Q: For a beam of cross-section, width = 230 mm and effective depth = 500 mm, the number of rebars of 12…

A: Given: Width of beamb=230 mm Effective depth of beam d=500 mm Diameter of barD=12 mm Grade of steel…

Q: The minimum value of 15 minute peak hour factor

A: Given data,  Find the minimum value peak hour factor.  Time is =15 minutes

Q: For a beam of cross-section, width = 230 mm and effective depth = 500 mm, the number of rebars of 12…

A:

Q: An axially loaded short spiral column is subjected to axial dead load of 620 KN and axial live load…

A: dead load=620kN live load = 880kN f'c=27.6MPa fy=414MPa ρ=0.025 clear cover=40mm

Q: the wastewater and fist components of wastewater. Describe the function of a wastewater treatment…

A:

Q: in optimum gypsum content i need clear ans and solve very very fast in 20 min and thank you | DYBALA…

A: Mgo is a byproduct used as a raw material in portland cement . Cao Calcium oxide

Q: acting at point O. 100 N y 600 mm 90 N Replace the three forces with an equivalent force-couple…

A:

Beams and Frames

A beam is a horizontal structure or a member which is always subjected to transverse shear loads.