define series and shunt regulator

Q: Perform transient circuit simulation for an RC (R=1k, C=1uF) circuit shown in Figure 12 to determine…

A: The solution is given below

Q: Explain the two types of feedback system (positive and negative types)

A: In this answer we will try to explain two predominant types of feedbacks that are employed in the…

Q: 7. The slew rate for an open loop op-amp configuration is 0.66V/us and the input voltage is 10 mVa.…

A: The slew rate for an open-loop op-amp configuration is 0.66 V/μs and the input voltage is 10 mVpk.…

Q: Cascade Compensation is done by connecting the compensator of a Control system in parallel with the…

A: In this question , we will write about cascade compensation...

Q: Q4) A) For the given closed-loop system, determine the values of K for stability. R(s) (6-2) B)…

A: According to our rules , we will answer only the first question. If you want solution for the other…

Q: Cascade Compensation is done by connecting the compensator of a Control system O in parallel with…

A: Cascade  compensation means adding block in series with gain block.

Q: Unity feedback control system is characterized by an open loop transfer function. k G(s)= 3[s+4)…

A: Given open loop transfer function, G(s)=KS(S+4) Unity feedback, H(s)=1 Damping factor, ζ=0.5

Q: A feedback system root locus graph shown in figure below. The system is type... Root Locus 3 -3 -4…

A: In the question,  Feedback system root locus graph shown in the figure. What is type of the system?

Q: Consider the total harmonic distortion of a closed loop system is 5%. Distortion without feedback is…

A: As per the question, it is given that Distortion of a closed loop system = 5% Distortion without…

Q: 7

A:

Q: (c) Figure Q2(c) is the shunt voltage regulator system. Characteristic of the system can be found by…

A:

Q: In the figure shown below, the type of feedback is . . ..... ..... Vcc Ai Gm Rm no option is correct…

A: Choose the correct option The type of the feedback in the circuit?

Q: Define CMRR and slew rate of OPAMP.

A: CMRR - The common-mode gain ratio to the differential-mode gain is the op-amp common-mode rejection…

Q: Define form factor and peak factor.

A: Form factor is the ratio of RMS value of the signal to the average value of the signal.

Q: (a) Give a component block-diagram for a practical temperature feedback system. kplain how the…

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please…

Q: Q. Why is the phase shift through the RC feedback circuit in a phase-shift oscillator 180°? *

A: Although , it is known that a single stage anplifier provides  180 degree phase to the input signal…

Q: The working of feedback unit in PE system is a. to generate digital coding b. to control the input…

A: The feedback in PE system is used to control the input to the load. It is used for the controlling…

Q: A unity feedback system has a forward path transfer function G(s)=16/(s2+8s). Find the value of…

A: In this question, A unity feedback system has a forward path transfer function G(s)=16/(s2+8s).…

Q: For a negative unity feedback system. R(s) + s+1 where G(s)= S²+45+5 the poies of the closed loop…

A: For calculate poles of closed loop system  first find closed loop transfer funtion of given system.

Q: Explain how poles and zeros are important in a feedback control system and t differences between…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Define the following parameters for an Op-amp. Input offset voltage; Bias current; Slew rate; Output…

A: For this discussion let us consider Op-Amp circuit- as below

Q: The characteristic equation of a feedback control system is s'+Ks²+9s+18. When the system is…

A: Given characteristic equation is, s3 + Ks2 + 9s + 18 = 0

Q: а, R C R, R II

A:

Q: For the collector feedback configuration of Figure a. Determine re. b. Find Zi and Zo. 12 V C.…

A: Answer-

Q: SN Component 1 Comparator Double ended Differential 2 mode of operation Cross Over Distortion is…

A:

Q: Root locus Control system Define following terms: - Z, P, gain margin, and phase margin

A: Here are the following terms related to the root locus diagram of any transfer function of a control…

Q: The closed loop transfer function of a unity feedback control system is veivw . C (s) Ks+B R (s) s…

A: Given: The close loop transfer function: CsRs=Ks+βs2+αs+βInput Rs=Lrt=1s2

Q: Design a circuit consisting of three stages, with the output of the first stage being a square wave,…

A: The required circuit diagram is shown in the below figure:

Q: Compare the classical Op-Amp parameters with modern Op-Amp.

A:

Q: Control system :- Define N Z P gain margin and phase margin

A: According to Nyquist Stability Criterion Z =N+P Where, Z is the number of roots of  characteristics…

Q: Do you think that the design procedure is easy using multiplexer?

A: Multiplexer: The multiplexer is a common sensetool that switches one in allseveraenterstrains to a…

Q: a) A position control system with load angular position as output and motor armature voltage as…

A: Given : G(s)=ks(s+p)

Q: Routh Hurwitzof closed loop system with variable gain.

A:

Q: What are the problems in an ordinary op-amp differentiator

A: Operational Amplifier as a differentiator -  An op-amp differentiator is just an inverting amplifier…

Q: what is the output waveform and phase shift of the Differentiator circuit

A: Differentiator circuit Relationship between output waveform and input waveform  phase shift of the…

Q: the Advantages and Disadvatages DC-TO-DC Converter.

A:

Q: . refers to inherent stability that prevails without the aid of voltage regulator. ....... O a.…

A: The explanation is as follows.

Q: =. The block diagram of a multiple-loop feedback control system is shown in the following figure,…

A:

Q: Q3: Determine for the following closed-loop feedback control system: (a) The value of K for the peak…

A:

Q: 7. Which type of preamplifier plays a crucial role in reducing the effect of thermal noise? (a) Low…

A: High impedance preamplifier is used in communication system to reduce the added noise

Q: List at least five op-amp parameters

A: The explanation is as follows.

Q: what is the output waveform and phase shift of the integrator circuit given?

A: The output waveform for the integrator is D.C. voltage Gain,  AVo=-RfR1=1010AVo=1

Q: For the following unity feedback system with parabolic input r(t) = t2/2, then k(s+ 2) R(S) C(S)…

A: Parabolic input, rt=t22 Unity feedback system Gs=ks+2ss2+7s2+12s

Q: 5. What is static synchronous compensator (STATCOM)? What is the main advantages/disadvantages of…

A: STATCOM and SVC: STATCOM is also known as a static synchronous compensator which is a controlled…

Q: How many type of shunt compensators exist?

A: Compensators are used in transmission lines for the protection of the equipment. Two types of…

Q: In a . output signal fed back so that it subtracts from the reference signal. * multiloop feedback…

A:

Differential amplifier

There are two amplifying stages with common degeneration in a differential amplifier.