degree-Ul-lreet aq/m1 F ki/m1-w²+jc1/m,w az/m2 kz/ m2-w²+jcz/m,W Y + where w is the excitation frequency. The system is tested and system identification is performed to determine that a1/m1=0.9, k1/mı=4, c1/m1=0.07, a2/m2=0.7, k2/m2=18 andc2/m2=0.08. Find the frequency at which anti-resonance occurs. Express your answer to 2 decimal places.

degree-Ul-lreet aq/m1 F ki/m1-w²+jc1/m,w az/m2 kz/ m2-w²+jcz/m,W Y + where w is the excitation frequency. The system is tested and system identification is performed to determine that a1/m1=0.9, k1/mı=4, c1/m1=0.07, a2/m2=0.7, k2/m2=18 andc2/m2=0.08. Find the frequency at which anti-resonance occurs. Express your answer to 2 decimal places.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Determine the magnitude and phase of the output from a system when subjected to a sinusoidal input of sin 3t if it has a transfer function of G(s) = 2/(s +1).
Vibrations Question The governing equation of motion of a single degree–of–freedom (SDOF) system is given by 5xdoubledot(t)+20xdot(t)+1800x(t)=10cos(15t)+30sin(5t)(assume the units are Newtons) and the initial conditions of the system are given asx(0)=0.02m and v(0)=0.95m/sAnalytically obtain the total response of the system
In this Problem, the system of Fig. 5.4.14 (Attached) is taken as a model for an undamped car with the given parameters in fps units. (a) Find the two natural frequencies of oscillation (in hertz). (b) Assume that this car is driven along a sinusoidal washboard surface with a wavelength of 40 ft. Find thetwo critical speeds. m = 100, I =1000, L1 =6, L2 = 4, k1 = k2 = 2000
A two degree of freedom damped system has natural frequencies 2 rad/s and 3 rad/s and corresponding mode shapes {21}{ 2 1 } and {1−1}{ 1 − 1 } . A damping ratio of 2% is assumed for both modes. The initial displacement is {10}{ 1 0 }mm and initial velocity is {21}{ 2 1 }mm/s. The displacement of the first degree of freedom in mm at time t=3 s is
A block with a speaker bolted to it is connected to a spring having spring constant k=20.0N/m as in figure P17.40 The total mass of the block and speaker is 5.00lg and the amplituted if this unit's motion is 0.500m. a) If the speaker emits sound waves of frequency 440Hz, determine the highest and lowest frequencies heard by the person to the right of the speaker b) If the maximum sound level heard by the person is 60.0 dB when he is closed to the speaker, 1.00m away, what is the minimum sound level heard by the observer? Assume that the speed of sound is 343m/s
The response of a system is given by xt=0.003cos 30t +0.004sin 30t m. Determine (a) the amplitude of motion, (b) the period of motion, (c) the frequency in Hz, (d) the frequency in rad/s, (e) the frequency in rpm, (f) the phase angle, and (g) the response in the form of xt=Asin (ωt+φ)
a string is attached to a mechanical vibrator, which has a frequency of 30Hx. the sttring is 3.0m long and has a linear density of .4 g/cm. the tension is varied by adding weights to teh string passing over the pully. What tension is needed to cause the string to resonate with the vibrator in four segments. assume that he points where the string meets the vibrator and the pulley are approx nodes.
Investigate the complex potential function f(z) = U∞ z +m ln [(z + a)/(z-a)] and interpret the fl ow pattern.
2- I need answer of all sub-parts questions. Thanks The figure shows a simple model of a motor vehicle that can vibrate in the vertical direction while traveling over a rough road. The road surface varies sinusoidally with an amplitude of 0.01 m and a wavelength of 6 m. The vehicle has a mass of 1007 kg. The suspension system has a total spring constant of 40 kN/m and a damping coefficient of 20 kN.s/m. The vehicle average speed is v = 100 km/hr. The objective is to determine the vehicle steady-state displacement amplitude as well as the respective transmitted force. Calculate the resultant frequency ratio of the above model. Calculate the steady state amplitude of the vehicle. Determine the force amplitude that will be felt in the vehicle at the steady-state due to the bumpiness of the road.
Use a system with a single degree of freedom to determine the fundamental natural frequency of the aircraft wing shown in Figure 6.32. If the average cross-section of the wing can be idealized as a hollow box 300 mm x 2000 mm with 2 mm thickness, as shown, and the wing is considered to be fixed to the fuselage at one end and free at the other, use E = 70 GPa and p = 2770 kg/m3.
A spring-mass system with m = 50kg and k = 4000N/m shown in Figure Q3(a).If the mass is released from its equivalent position and results in simpleharmonic motion (SHM),(i) Starting from a free body diagram, derive the equation of motion.(ii) Determine the natural frequency. (iii) Explain on how you can reduce the natural frequency of the spring-masssystem.
1- I need answer of all sub-parts questions. Thanks The figure shows a simple model of a motor vehicle that can vibrate in the vertical direction while traveling over a rough road. The road surface varies sinusoidally with an amplitude of 0.01 m and a wavelength of 6 m. The vehicle has a mass of 1007 kg. The suspension system has a total spring constant of 40 kN/m and a damping coefficient of 20 kN.s/m. The vehicle average speed is v = 100 km/hr. The objective is to determine the vehicle steady-state displacement amplitude as well as the respective transmitted force. Calculate the forcing frequency of the pumpy road. Calculate the natural frequency of the vehicle SDOF system. Calculate the damping ratio of the vehicle SDOF.