Delta-Detla transformer works satisfactorilywhenLoad is balanced onlyLoad is unbalanced onlyOn balanced as well as unbalancedloadsNone of these

Delta - Delta transformer works satisfactorily when on balanced as well as unbalanced loads.

Answered: Delta-Detla transformer works…

Delta-Detla transformer works satisfactorily when O Load is balanced only Load is unbalanced only On balanced as well as unbalanced loads None of these

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.5MCQ: For an ideal 2-winding transformer, an impedance Z2 connected across winding 2 (secondary) is...

See similar textbooks

Related questions

Q: AMoving to another question will save this response. uestion 8 Which of the following is the phase…

A: In this question we need to choose a correct option.

Q: In step down transformer, secondary turns are less than primary turns. Select one: O True O False

Q: A step up transformer has more number of turns in the primary side. Select one: O True O False

A: In power system, there are various different voltage levels of working. Transformers are used to…

Q: To improve the load power factor, a Delta-Connected capacitor bank is connected on the low voltage…

Q: Problem: For the given circuit as shown in figure a) Find the equivalent reactance b) Draw the…

A: Solution !!

Q: If the turn ratio of a step-up transformer is 1:15 and the full-load secondary current is 300 A, the…

Q: Vs VL C1 HH 47µF V1 L1 R1 27mH 100 T1 120Vrms 60HZ 0° R2 400 1:4

A: given: k=4 , Vi=169.71Sin(ωt) =169.71∠0° The primary winding current =I1…

Q: 7. What is the no-load voltage when the full-load secondary voltage is 108 V and transformer…

A: Given: In a transformer, Full load secondary voltage V2fl=108 V. Transformer regulation VR=10%.

Q: In the short circuit test to be made on the high voltage winding of the 220 / 24V 315VA transformer,…

A: Given data, Volt-ampere rating is, S = 315 VA. Primary Voltage, Vp = 220 V. Secondary Voltage, Vs =…

Q: Two single-phase transformers with equal ratings and turns ratlo are operated in parallel to supply…

Q: In the transformer circuit below, determine the value of Vp and Ip to maintain a voltage of 230V…

Q: 13 B. Which of the following transformation ratio(k) can increase the secondary voltage of…

Q: 13.i. The turns ratio of a Step-Down Transformer is 220/110.ldentify the ratio of current in the…

A: find explanation below

Q: The DC motor is start by using the four point starter. Delta-Star connection of transformer is best…

A: In this we will see starter for dc motor and lighting connection...

Q: 9- While conducting short-circuit test on a transformer the following side is short- circuited a) -…

Q: Which of the following is true for secondary current in a step-down transformer? A) is less than the…

A: Transformer is a device which will used to step up or step down the power supply Depending on…

Q: 20:5 派 a) find B and P b) if the transformer is put in bachwords Sud P and R (N

Q: 05 V/ 129 V single-phase transformer has a core loss of 124 W and the no-load current is 0.8 A. The…

Q: 1. If the load of wye connected transformer are: IA = 10 cis(-30°) IB = 12 cis (215°) Ic= 15 cis…

A: Positive components are symmetrical components. The phase sequence is same in balanced 3-phase…

Q: In a relation to a transformer the ratio 6/1%3B indicates that O Primary current is 6 times greater…

Q: Magnetizing reactance (Xm) of a transformer is determined by * O short-circuit test open-circuit…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 18. A 100-kva 2,400/240-volt 60-cycle transformer has the fo Rp 0.42; Хр - 0.72;B Rs 0.0038; Xs -…

A: RP=0.42Xp=0.72Rs=0.0038Xs=0.0068 n=2400240=10

Q: A 3-phase 10OOKVA, 11000/416 transformer is delta-connected on the primary and star connected on the…

A: A transformer is an electrical machine which is used in AC circuit to either step up or step down…

Q: if three-winding transformer is connected as in figure bellow , the value of the output voltage Vo…

A: Fig: Given circuit Although in the secondary side of the transformer current…

Q: 1. If the load of wye connected transformer are: IA = 10 cis(-30°) IB = 12 cis (215°) Ic = 15 cis…

A: Positive Sequence:- In positive sequence balanced three phase current and voltage have same…

Q: The primary winding of a 50 Hz single phase transformer has 480 turns and is fed from 6400V supply.…

A: Given : A single phase transformer , f = 50 Hz With N1 = 480 turns N2 = 20 turns E1 = 6400 volts To…

Q: primary of a certain transformer takes 1 a at a power factor of 0.4 when it is connected acrossa…

A: Primary current: It is a current that flows on the primary side of the transformer.

Q: - Determine the reflected impedance in a transformer if the turns ratio is 4:1 step-down and Z1=250…

A: From the Ideal Transformer Concept

Q: Differental Protection of a three-Phase A-Y two winding transformer.

A: Given & to find: Differential protection of a three-phase delta-star two winding transformer.

Q: A 100VA single-phase transformer inside a refrigerator has 100 turns in its primary coil and 20…

Q: 3/A single phase transformer has 250 primary turns connected to a 500 V. The output voltage is 150…

A: Given, Single phase transformer has, Primary turns, N1 = 250 turns Primary Voltage, V1 = 500 V…

Q: 3-phase 1000KVA, 11000/416 transformer is delta-connected on the primary and star connected on the…

A: A transformer is an electrical machine which is used in AC circuit to either step up or step down…

Q: 33. Determine the secondary curent (I5) for the transformer shown in Figure 10.53a. Is 80 mA 12:1 mA…

A: This problem is of electrical machines. Please look the attached image.

Q: 5. Two single-phase transformers with equal ratings and turns ratio are operated in parallel to…

Q: 100 Kva transformer has 400 turns on the rimary and 80 turns on the secondary. The rimary and…

Q: The table below shows some performance parameters of a certain power transformer. Full-load voltage…

A: The voltage regulator is required to maintain voltages within the permitted range that the…

Q: In a transformer 480 V input and 208 V output and 100 turns in the secondary. Determine the turns of…

Q: The efficiency of a transformer at load 0.8 p.f. Lag is -- at load 0.8 p.f. Lead * equal less than…

A: When transformer work at lagging power factor the flux in secondary of transformer is demagnetizing…

Q: 10.a. Most of the power transformers that you will find in commercial and industrial applications…

A: Answer 10 (a): Most of the power transformers that you will find in commercial and industrial…

Q: 4. Two 100KW, 1phase transformer are connected in parallel both on the primary and secondary. One…

Q: 3- A transformer will have zero efliciency at --. a) Full-load b) half-load c) no-load d) none of…

A: Disclaimer: Since you have asked multiple questions, we will solve the first question for you. If…

Q: 10. With a step-up transformer with a turns ratio of 6 and a primary voltage of 100V, what is the…

A: For step up transformer, secondary voltage is more than primary voltage and turn ratio is greater…

Q: A generator supplies a motor through a Y-A transformer. The generator is connected to Y side of the…

Q: 12. Two transformers, A and B re connected in parallel on both the HV side and the LV side. Show…

Q: A voltage multiplier has 12 stages Capacitances, all equal to 0.08 µF. The supply transformer…

Q: A 2/0.4 kV, single-phase transformer takes a no-load current of 1 A and the core losses is 500 W.…

Q: A single phase transformer has an output of 720 VA. The primary voltage is 120V. What is the primary…

Q: In step up transformer, secaondary turns are less than primary turns. Select one: O True O False

A: We need to tell about turns ratio of stepup transform .

Q: The full-load efficiency of transformer at 0.85 lagging p.f. is 97%. Its efficiency at full load…

A: The efficiency for a leading or lagging remains same.

Q: A Transformer has turns ratio of 2:15. When the secondary turns is 300, what is the primary turns? O…

A: Given data Turns ratio K= 2:15 K= 2/15 K= 0.13333…

Question

Delta-Detla transformer works satisfactorily
when
Load is balanced only
Load is unbalanced only
On balanced as well as unbalanced
loads
None of these

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Match the following: (i) Hysteresis loss (a) Can be redud by constructing the core with laminated sheets of alloy steel (ii) Eddy current loss (b) Can be reduced by the use of special high grades of alloy stl as core material.
n 7 In step up transformer, secondary turns are less than primary turns. out of Select one: O True uestion O False VION MS team link Jump to... search Chp
The table below shows some performance parameters of a certain power transformer. Full-load voltage regulation Full-load copper loss Load power factor 5% 0.5 Lagging Zero voltage regulation is obtained at a load power factor of: 0.9176 leading 08 leading 0.397 lagging 2% 0.703 leading
In a step-down transformer ratio, which is larger the number of ratio O the number of turns O Secondary Voltage O Primary Voltage
The table below shows some performance parameters of a certain power transformer. Full-load voltage regulation Full-load copper loss Load power factor 0.5 Lagging 5% The Maximum noccihle voltage regulation of the trane former is: 5.033 96 5.385 9 3 96 4.134 % 21 21
A 2/0.4 kV, single-phase transformer takes a no-load current of 1 A and the core losses is 500 W. Find the magnetizing component current 0.35 A 0.15 A O 0.25 A 0.45 A
O Van lags Vbn. and V bn lags Ven- O Van lags Vbn, and Vin leads Ven- Question 11 A transformer with a primary voltage V = 15Z15° V has a turns ratio of 1:5. What is the secondary voltage, V2? O 75/75° V O 3/15° V O 3275° V O 75/15° V PrtScn F5 F6 F7
A IcA The voltage ratio in the following transformer equals to, Inc VAN/N1 Van/N2 Van/N1 Vab/N2
A multitap transformer has 100 turns on the primary, 100 turns between B and C, 1000 turns between A and D, and 600 turns between A and C. Calculate the secondary voltage between C and D if a 240V RMS source is connected to the primary. -OD -OC 1 -OB O 333V RMS O 960V RMS Ⓒ240V RMS O 507V RMS
For the following circuit if the secondary voltage of the transformer is 20V rms, the output voltage is ZV +11 C₂ D₂ DA D₁ HE 2V 123.2 V O 113.1 V O 130.1 V O 55.5 V O ele 000000000 + SE C₂ Ht 2V + D₂ + I
transformators topic In a transformer 480 V input and 208 V output and 100 turns in the secondary. Determine the turns of the primary
In your own understanding what do you understand by step down transformer