dense silt has the following properties: void ratio = 0.64, specific gravity = 2.5. Free ground water = 10.23m below the ground. Capillary action rise will reach 5.6m. The soil above the capillary action rise is dry while within the zone, it is saturated at 51.53%. Determine the effective pressure (in kPa) at a depth of 7.42m from the ground surface.

dense silt has the following properties: void ratio = 0.64, specific gravity = 2.5. Free ground water = 10.23m below the ground. Capillary action rise will reach 5.6m. The soil above the capillary action rise is dry while within the zone, it is saturated at 51.53%. Determine the effective pressure (in kPa) at a depth of 7.42m from the ground surface.

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter9: In Situ Stresses

Section: Chapter Questions

Problem 9.6P

See similar textbooks

Similar questions

A dense silt layer has the following properties: void ratio = 0.67, specific gravity = 2.55. Free ground water is 10.96 m. below the ground. Capillary action rise will reach 5.81 meters. The soil above capilary action rise is dry while within the zone, it is saturated at 51.78%. Determine the effective pressure (in kPa) at a depth of 7.21 meters from the ground surface. Round off to three decimal places.
Question 32 A dense silt layer has the following properties: void ratio = 0.66, specific gravity = 2.5. Free ground water is 9.47 m. below the ground. Capillary action rise will reach 6.66 meters. The soil above capilary action rise is dry while within the zone, it is saturated at 52.77%. Determine the effective pressure (in kPa) at a depth of 7.42 meters from the ground surface. Round off to three decimal places.
A dense silt layer has the following properties: e=0.30, D10=10µm and capillary constant = 0.20cm2 Free ground water level is 8m below the ground surface. Determine the vertical effective stress (kPa) at 5m depth (point A). Assume unit weight of solids = 26.5 KN/m3 and that the soil above the capillary rise and ground surface is partially saturated at 50%.
A dense silt layer has the following properties: void ratio e = 0.50, effective Diameter D10 = 10 μm, capillary constant C = 0.20 cm2. The free groundwater level is 8m below the ground surface. Assume unit weight of solids y= 26.50kN/m3. Find the vertical effective stress at 10m depth. Assume that the soil above the capillary zone is partially saturated at 50%.
a dense silt layer has the following properties: void ratio = 0.50, effective diameter d10 = 10 um, capillary constant c = 0.20 cm2. free ground water level is 8.0 m below the ground surface. find the vertical effective stress in kpa at 5m depth. assume unit weight of solids = 26.5 kn/m3 and that the soil = 26.5 kn/m3 and that the soil above the capillary action rise and ground surfaces is partially saturated at 50% from the problem above, find the vertical effective stress at 10m depth. assume unit weight of solids=26.5kN/m3 and that the solid above the capillary action rise and ground surface is partially saturated at 50%.
A dense silt layer has the following properties.void ratio = 0.30eff. Diameter ?10 = 10??capillary constant (c)=0.20 cm²Groundwater level is 8.0m below the ground surface 1. Calculate the height of capillary rise in the silt. 2. Calculate the vertical effective stress in kpa at 5m depth, assume ?? = 26.5 ??/?³and that the soil above the capillary action rise and ground surface is partially saturated at 50%. 3. Calculate the effective vertical stress at 10m depth assuming ?? = 26.5 ??/?³and that the soil above the capillary action rise and ground surface is partially saturated at 50%.
Estimate the lateral earth pressure at a depth 20 ft (6.1 m) below the ground surface in a loose sand deposit. The wet unit weight of the sand is 115 pcf (19 kN/m3). What would the total lateral pressure be if the water table rose to the ground surface (in psf or kPa)?
The subsoil strata at a site consist of fine sand 3.0 m thick overlying a stratum of clay 2.8 m thick. Under the clay stratum lies a deposit of coarse sand extending to a considerable depth. The water table is 2.8 m below the ground surface. Assuming the top fine sand to be saturated by capillary water, calculate the effective pressures at ground surface and at depths of 3.0 m, 5.8 m and 8.0 m below the ground surface. Assume for fine sand G = 2.65, e = 0.83 and for coarse sand G = 2.79, e = 0.53. What will be the change in effective pressure at depth 3.74 m, if no capillary water is assumed to be present in the fine sand and its bulk unit weight is assumed to be 16.88 kN/m3 . The unit weight of clay may be assumed as 19.75 kN/m3. Comment on the effect of the present of groundwater on design of earth structures?
A uniform soil deposit has a void ratio 0.6 and specific gravity of 2.65. The natural ground water is at 2.5 m below natural ground level. Due to capillary moisture, the average degree of saturation above ground water table is 50%. Determine effective pressure in kPa at a depth of 6 m. a. 46.40 b. 323.9 c. 80.66 d. 117.9
A dense silt has the following properties: Void ratio (e) = 0.40, SpecificGravity (Gs) = 2.70, Effective diameter ??? = ????−??, Capillary constant (C) =?. ?? ???. Free groound water level is 8.0 m below the ground surface. a. Find the height of capillary rise in the silt.b. Find the vertical effective stress in kPa at 5m depth. Assume that the soil abovethe capillary zone or capillary action rise to be dry soil and the soil within thecapillary action be partially saturated (degree of saturation, S) at 50%.c. Find the vertical effective stress at 10m depth. Assume that the soil above thecapillary zone or capillary action rise to be dry soil and the soil within the capillaryaction be partially saturated (degree of saturation, S) at 50%
A uniform soil deposit has a void ratio of 0.6 and specific gravity of 2.65. The natural ground water is at 2.5m below natural ground level. The average degree of saturation above ground water table is 50%. What is the effective pressure at 6.0 m depth?
A 2m clay layer has values of e = 0.92 , Gs = 2.72 and liquid limit of 40%. Above the clay is a 3m thick layer sand with e = 0.50 and Gs = 2.62. The water table is located 1.6 m below the ground surface having a unit weight of 17.3 kN/cu. Meter, determine the following: a. Compression index of clayb. Effective pressure at the midpoint of clayc. Primary settlement for normally consolidated clay.......