•Derive and analyse relation of capacitance for 3- core cables What is grading of cables, explain.

Q: What is the dispersion taking place in long transmission lines? State the condition to obtain…

A: In long transmission lines frequency dispersion takes place. In which transmission lines have…

Q: (e) A 3-phase double circuit line is shown in the given figure. The diameter of each conductor is 2…

A: In this question,  Determine the capacitance and chargeing current?  We know  Charging current I=…

Q: Q4: A power distribution station consisting of 100KVA, 4500V/225V, and 50 cycles per second…

A: In the given scenario, single-phase transformer is used. The EMF equation for the single-phase…

Q: Theoretically solve an unknown resistance for Transmission line conductor by using any two methods…

A: Wheatstone bridge  This bridge is used to calculates the unknown resistance by balancing two legs of…

Q: g) Why the Capacitance effect is neglected in Short Transmission Line.

A: As per the guidelines, we supposed to answer one question at a time so, please ask other question…

Q: Discuss basic character of smart grid

A: Smart grid is one type of the electrical grid that is used efficiently and able to integrate the…

Q: The maximum and minimum stresses in the dielectric of a single core cable are 40 KV/cm (rms) and 10…

A:

Q: Derive and analyse relation of capacitance for 3 core cables.

A: Three core cables are those cables in which all the three line conductors are arranged in the lines…

Q: What do you understand by impedance matching? Also write the formula of characteristic impedance for…

A: Impedance Matching:The term “impedance matching” is defined as the procedure of making one impedance…

Q: PRELIMINARY QUESTIONS: 1) What is the phase angle between the phases in an ideal 3-phase system?

A: Bartleby has policy to solve only first question.  For rest questions re-upload them only.

Q: Q4: A power distribution station consisting of 100OKVA, 4500V/225V, and 50 cycles per second…

A: Write the expression for the number of turns,

Q: 2) Capacitance of a three-phase line with equilateral spacing, and a three-phase 60-Hz line has flat…

A: Given Conductor diameter,d =3.2×cmr=d2=3.22=1.64 cmDistance between conductors…

Q: A three phase symmetrical double circuit line is arranged in a horizontal plane as shown in figure…

A: expression for the transposed line for the inductance.    Given line is double circuit.   Assume…

Q: please write introduction about Analysis of 3 Phase star connected circuit Note:please write details…

A:

Q: What is the difference between modules and ways ? and how many ways we need to construct a…

A: The Electrical distribution system consists of some standardized terminologies in which the…

Q: Calculate the line to line capacitance per km of a single-phase overhead line having copper…

A:

Q: 2. A 3-phase, 132 KV , 50 Hz, 100 Km, single circuit bundle conductor transmission line as shown in…

A:

Q: "A 66 kV single core cable has a conductor diameter of 1.75 cm and a sheath of inside diameter 5 cm.…

A: As per the guidelines of Bartleby we supposed to answer first three subparts of the question for…

Q: calculate capacitane, inductance, resistance and conductance of one type of transmission line by…

A: Transmission lines are conductors that serve as a channel for electrical waves (energy) to be…

Q: Derive the equation of Capacitance per phase for the 3-phase double circuit line with hexagonal…

A: Let us assume that the p is very far from the system of conductor and at point P potential is almost…

Q: Q2. What is the benefit of using stranded conductors in transmission systems?

A: The benefits of stranded conductors are listed below:

Q: For grounded systems, the _ for the service and the system bonding jumper for separately derived…

A: The equipment grounding conductor connections at the source of separately derived systems are done…

Q: What are the Salient Features of Indian Grid Codes for Wind Power Generation

A: The Salient Features of Indian Grid Codes for Wind Power Generation are given below- IEGC stands…

Q: 3. What are the classifications of Core Loss and Copper Loss?

A: Electrical machines can be either generator or motors and transformers. They can be either Ac…

Q: A-Define the sag of T.L and derive an expression for the total length of a Conductor and the tension…

A:

Q: A single phase 2 conductor operates at 50Hz, the diameter of each condcutor is 60mm and spacing…

A: The inductance is expressed as the ratio of the flux linkage with the magnitude of the current. It…

Q: 2- Explain the effect of changing the load (inductive-capacitive- resistive) on SG terminal voltage?

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Which Transmission Line Parameter is neglected or ignored in most classifications of Transmission…

A: The G boundary is liable for the spillage current stream between the conductors and the ground. As…

Q: A three phase, 33 KV, underground cable system, consider a single core of conductor radius 0.8 cm…

A:

Q: Write a conclusion about voltage drop and power loss calculations for Ring d.c distribution system.

A: Ring DC distribution system: It is the system for distributing the power. In this system, the first…

Q: Consider the 500 kV, three phase bundled conductor line as shown in the figure below. Find the line…

A:

Q: Lumped and Distributed elements ?

A: Lumped element are considered as the circuit elements which a very small in size, they are…

Q: Explain the following items i) Steps used to draw the equivalent impedance diagram of the network…

A: i) Procedure to draw impedance diagram 1. Establish Base Voltage through the System 2. Calculate the…

Q: 3. Find the capacitance per unit length of the single-phase line shown below. Conductors a, b, c are…

A: It is given that: ra=rb=rc=0.2cmrd=re=0.4cm

Q: In nominal-T method of medium transmission line what is the assumption about the capacitance

A: In a nominal T model of a medium transmission line, the series impedance is divided into two equal…

Q: Consider an isolated spin- paramagnet in an

A: Total spins =N Let no of spin ups=n up       no of spin downs=n down        N=n up+n down

Q: -Derive and analyse relation of capacitance for 3- core cables [CLO-2,

A: Capacitance of 3 core cables: Let Cc be the capacitance between 2 cores and Ce between core and…

Q: Compare the effect of varying resistance, capacitance and inductance in parallel and series AC…

A: Note: circuit compenets are not specified. we assume following AC circuits RLC parallel circuit RLC…

Q: What do you understand by impedance matching? Also write the formula of characteristic impedance for…

A: For maximum power transfer in transmission line, impedance of transmission line is equal to surge…

Q: Question - Compare the effect of varying resistance, capacitance and inductance in a pararllel and…

A: In this question   Compare the effect of varying resistance, capacitance and inductance in a…

Q: define the conductor with examples

A: An electrical conductor is defined as substances that permit energy to float via them without…

Q: a. Derive the total inductance of a single current carrying conductor? b. Determine the inductance…

A: As you are not mentioning which part you want wewill answer the 2 part for you In this question we…

Q: In single phase AC distribution system, the net drop is the difference of the drop in resistance due…

A: In a single phase system, the net Voltage drop is equal to product of phasor current flows through…

Q: 1. A Single-phase, two-wire overhead line has solid cylindrical copper conductors with 2.4 cm…

A:

Q: Why the Capacitance effect is neglected in Short Transmission Line.

A: The explanation is as follows.

Q: Q2: A single-phase transmission line consisting of two conductors, the radius of each conductor is…

A:

Q: 5/The phase angle between magnetizing component current and core loss component current is 180o…

A: The phase angle between magnetizing component current and core loss component current is 900.

Q: a) A 240V single phase circuit is run in conduit in 2 core 70°C PVC/PVC cable having live conductor…

A: Given: A 240V single phase circuit is run in conduit in 2 core 70°C PVC/PVC cable having a live…

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.