Derive the kinetic energy equations and the mass equivalents of the system shown.

Q: (12) A 50mm shaft is 3.0m long& receives 45kW from a pulley mounted @ 2.0m form the left end. A…

A:

Q: The 250-kg wheel has a radius of gyration about its center O of ko = 260 mm, and radius r = 0.4 m.…

A:

Q: A 19 ft long, simply supported beam is subjected to a 5 kip/ft uniform distributed load over its…

A: Here, Length of the beam = L = 19 ft = 228 in Uniform loading = w = 5 kip/ft = 0.4167 kip/in = 416.7…

Q: Hw/find the transfer function wher S S G₁ = 1 , G2 = G3 = J S +1 S +1 5² +2 H₁= 1 H₂ = S, H3 = 3 >…

A:

Q: Determine the principal stresses and the absolute maximum shear stress.

A: Determine the principal Stress and absolute maximum shear stress

Q: The hydraulic cylinder imparts a constant upward velocity VA = 0.27 m/s to corner A of the…

A:

Q: An object has a volume of 1 cubic meter. If its specific gravity is 1.2, what is its weight…

A: GivenVolume of the object V=1m3specific gravity =1.2

Q: How can you apply the concept of linear combination in engineering or real-life situations?

A: To find :- How can you apply the concept of linear combination in engineering or real-life…

Q: A sky lantern which a child tied to a piece of stone on the ground at the side of a tall multi-…

A: Given:v1=2.7 m/st=2.5 sec

Q: A gas with density 1.25kg/m and dynamic viscosity Aair force on one side of the plate is Fs = 4N.…

A:

Q: 3/100 The 1.5-lb collar slides with negligible friction on the fixed rod in the vertical plane. If…

A:

Q: what its compressor, its working principle, its types, and applications also, what is the compressor…

A: Compressor :  A compressor is basically defined as it is a device which increases the pressure of a…

Q: Water is flowing in a circular pipe of varying cross-sectional area. At one point in the pipe the…

A:

Q: 1. Determine the pressure acting on the upper and lower surfaces of a flat plate inclined at a 12°…

A:

Q: Mohr's circle is shown for a point in a physical object that is subjected to plane stress. Each grid…

A: We can answer the first part because it is already has 3 unknowns so we will answer the part (a).…

Q: A sky lantern which a child tied to a piece of stone on the ground at the side of a tall multi-…

A: Given:v1=3.7 m/st=3.5 sec

Q: The 186-kg wheel has a radius of gyration about its center of ko = 300 mm, and radius r = 0.4 m.…

A: Givenm=186kgko=300mm=0.3mr=0.4mM=92Nmg=9.81m/s2

Q: 2/63 A particle which moves in two-dimensional motion has coordinates given in inches by x = ² - 4t…

A: Find the velocity and acceleration .

Q: A set of three blocks are pulled up a rough incline (us = 0.55000 and uk (not shown in the figure)…

A: Given : To find : Lower limit of the applied force

Q: 1. Calculate the corrosion rate (in mm/yr and mpy) for iron in an acid if the iron loss is 0.01 gms…

A:

Q: The hydraulic cylinder imparts a constant upward velocity VA = 0.27 m/s to corner A of the…

A:

Q: Air enters the diffuser of a turbojet engine with a mass flow rate of 70 lb/s at 9 lbf/in2, 420°R,…

A: T-s diagram of the system is Given data, Mass flow rate of air, m˙=70 lb/s Pressure at state 1, P1…

Q: In a lake, two boats A and B are leaving Station1 at the same time, Boat A is directed straight to…

A: Given data Boat A moves towards Station 2 at a velocity 7 m/sBoat B moves in the North West…

Q: 3/118 The 15-lb cylindrical collar is released from rest in the position shown and drops onto the…

A:

Q: Why is there a need for us to generate straight line in mechanism? note: answer in 6-8 sentences…

A:

Q: The 1.5-lb collar slides with negligible friction on the fixed rod in the vertical plane. If the…

A:

Q: Calculate the forces, in Newtons, for the following 1.  member FG 2. pin H 3. hydraulic cylinder AB…

A: Given Data : p=789 θ=37.4 a ) take a moment about H…

Q: Water at 25 deg C (998 kg/m3) flows at 10 m3/s through a straight pipe of an ID of 1.38 m to 2 m-ID.…

A: Given data Volume flow rate of water = 10 m3/s Inner diameter of pipe of section 1 = d1 = 1.38…

Q: length values of 1.5 × 10-2 mm and 7.5 mm, respectively. Given a fiber strength of 3500 MPa and a…

A: Tensile strength is the highest load a material can withstand without cracking when stretched,…

Q: Determine the coordinates of the centroid of the trapezoidal area shown. Assume a = 245 mm, b = 465…

A:

Q: 3. For a single element beam as shown in figure below, its equivalent nodal load matrix should be W…

A:

Q: The cross sectional dimensions of a beam are shown. If the flange thickness, h, is 15.5 mm,…

A: ANswer = 43.859 mm

Q: Would the losses decrease if a cooling fan is mounted on the motor shaft?

A: cooling fan is mounted on the motor shaft

Q: Water at 60°F is pumped from a reservoir to the top of a mountain through a 6-in. Schedule 120 pipe…

A:

Q: 3. In the figure below, the coefficient of sliding friction for all contact surfaces is 0.20. When…

A:

Q: Prove that the pressure 'p' is independent of the transverse coordinate 'y' in the boundary layer…

A: The basic property of a static fluid is pressure. For a static fluid, as shown by the following…

Q: what is the vector reparesentation of the tension at J?

A:

Q: 2/59 At time t = 10 s, the velocity of a particle moving in the x-y plane is v= 0.1i + 2j m/s. By…

A: Given data: t1=10 su=0.1i+2j m/st2=10.1 sv=-0.1i+1.8j m/s Need to determine the average acceleration…

Q: The beam shown has an second moment of area of 9,500,000 mm and a controlling section modulus of…

A: Given data : Maximum moment=M Second moment of area=I Section modulus=Z   Required : Maximum…

Q: Josh threw the marble vertically upward with a speed of 66 ft/s from a bridge. On the way down, the…

A:

Q: A straightforward condition may be established in a variety of ways.

A: Autosomal dominant, autosomal recessive, X-linked dominant, and X-linked recessive are the four…

Q: Find the strain in rod if initial length of rod is 190 mm and change in length of rod is 0.0112 mm

A: Given data : Initial length=L Change in length=∆L   Required : Strain

Q: A motorist is travelling at 72km/hr when he observes that a traffic light ahead of him turns red.…

A:

Q: (Protit) What is the impact of decreasing/increasing radius kettle (m) with regarding to heat time?…

A: The ways by which heat transmission happens are equally as fascinating as the effects of heat…

Q: A pump is moving soybean oil through a 1-in. (nominal) pipe. The 110-volt motor is using 285 watts.…

A: Given dataDiameter of pipe = 1 inch = 0.0254 mVoltage of motor = 110 VPower of motor = 285 WOverall…

Q: HW QI) Knowing that the coefficient of friction between the 25-kg block and the incline is μ = 0.25,…

A:

Q: Determine the principal stresses and the absolute maximum shear stress. 2.5 ksi 4 ksi 5 ksi

A:

Q: A ventilating fan discharges 5 cubic meter/sec of air through a 87cm diameter duct against a static…

A: Given data, Discharge rate, Q = 5 m3/s Diameter of the duct, d = 0.87 m Static pressure head, hs =…

Q: In the following system, Explain the function of each part of the system. Explain t feedback action…

A: A spool-valve assembly's inner section is made up of input from the steering shaft. It connects…

Q: The simply supported beam consists of a W14 x 34 structural steel wide-flange shape [E = 29,000 ksi;…

A: