Design a circuit using two op-amps to implement: Vo = 3.5v1 + 4.2v2 - 5.5v3. Show all the assumptions, calculation and the circuit illustration. Marking Scheme: Circuit Design Assumptions Calculation

Q: Solve the output voltage Vo of the given circuit below. ID1 Ge 31.3 V 17.6 V 39.3 V 32 V 31.7 V Si…

A:

Q: Must an air conditioner installed in a window opening be grounded if a person on the ground outside…

A: FIND: Must an air conditioner installed in a window opening be grounded if a person on the ground…

Q: In a test for a fault to earth on a 600 m length of cable having a resistance of 18 per 1000 m. the…

A: We have an data of the test for a fault to earth with, Length of the cable is 600 m Cable resistance…

Q: A 4 pole d.c. motor takes a 38.6 A armature current. The armature has lap connected 350 conductors.…

A: We have an DC motor with, Poles = 4    Also P = A so, A = 4 Armature current (Ia) = 38.6 A Armature…

Q: Solve the following: 1. Three resistors R1, R2, and R3 are connected in series with a constant…

A: We need to find out the supply voltage for given circuit

Q: A digital system has a clock generator that produces pulses at a frequency of 80 MHz. Design a…

A: Given data, Frequency, f=80 MHz=80×10-6 Hz

Q: 3. According to Equal Area Criterion method, please explain how series capacitive compensation…

A:

Q: Is R₁ www. Cap, A R₂ Is= 12 R1=7 R2=8 Use current division to find the power absorbed by the…

A: The given circuit is, IS=12 A,R1=7 Ω,R2=8 Ω .

Q: Question 2 Find the average value of the voltage in the figure "inn L V ov+ O 1.59 V O 63.7 V O 6.37…

A: Given data, Waveform is given as, From the waveform peak value of voltage, Vm=5 V

Q: Find the current through the resistor R = 522 in the following circuit 102 202 Answer: 3 A 30 70 ww…

A:

Q: - Calculate the value of the current I needed to setup a flux of 0.1 mwb in the airgap. The magnetic…

A: The MMF is measured in ampere-twists and is equal to the quantity of wire turns to carry an electric…

Q: Q4) Evaluate both sides of divergence theorem for D=3sino a + 2z az - and the sylinder(p=50< < 2π…

A:

Q: Vin Vout 1.25 2.50 3.75 5.00 -1.25 -2.50 -3.75 -5.00

A: The given circuit is a biased clipper circuit and it clips both positive and negative cycle.of input…

Q: If a three phase load consumes apparent power of 40KVA and active power of 30 KW, power factor of…

A: Given: A three phase load consumes, Apparent power, S=40 kVA. Active power, P=30 kW.

Q: The maximum power dissipation capacity of a transistor is 50 mW. If the collector emitter voltage is…

A: Given: A transistor has,  Maximum power dissipation capacity, Pdmax=50 mW. Collector emitter…

Q: Vo below. the given cir ID1 Ge 31.3 V 17.6 V 39.3 V 32 V 31.7 V Si ID2 6.8 kohms 4 V Vo

A:

Q: the The gross sectional area of the core in a single phase 230/110 V transformer is 44.4 cm2. If…

A: solution: Given data; A single phase: 230/110 V, E1=230 V      E2=110 V; Gross sectional area…

Q: 3.1 Find in From the circuit in Figure 3. 3.2 Find Q b ww Σ10 Ω ข้อที่ 3 รูปที่ 3 10 mH 3.3 If a…

A:

Q: Create five(5) Maxwell Mesh problem with figure and solve it(Show complete solution)

A: The Maxwell mesh analysis is used to find the unknown current in the mesh present in the circuit.…

Q: Find the average value of the voltage in the figure in 5 V ov+ O 1.59 V O 63.7 V O 6.37 V O 10.5 V

A:

Q: A complex communication satellite has an inbuilt microwave repeater unit, having a mean time to…

A: According to the question, a complex communication satellite has an inbuilt microwave repeater unit.…

Q: *Explain the process here; how to determine the resistor value using the color coders and nominal…

A: Color code of the resistor: Gold and silver color denoted the 5% and 10% tolerance respectively.

Q: B₁ E₁=12V H R₁=2 D I₁ B G E₂=9V R₂=4 12 R6=12 B₂ F R4=8 R3=6 13 B3 E3=6V D E R5=10

A:

Q: A 250 V DC shunt generator has a constant loss of 1250 W. Find the load current for maximum…

A: Solution: Shunt generator; V=250 v, Constant loss =1250 W, Find the load current for maximum…

Q: + 100 F un 16+ No is чий + 240kn 360kn Rea

A: Circuit is given as:

Q: 2) Determine the current (Ix) in the following circuits.

A: The required current Ix can be calculated by using the mesh analysis. The mesh equation can be…

Q: 5. Find the minimum bandwidth of a FDM system which multiplex five devices, each requiring 4000 Hz.…

A:

Q: 2) Determine (V%) for the Iwo circuits below using superposition. 20 V www 6Ω www 24 2 Ω ΤΑ να 3 Ω…

A:

Q: 4.69 Determine io and v, in the circuit shown in Fig. P4.69 when R, is a resistor from Appendix H…

A: Simplified circuit: 100Ω≤R0&lt;200Ω

Q: When negative voltage feedback is applied to an amplifier of gain 200, the overall gain falls to…

A: We got an amplifier with, Amplifier gain (Av) = 200 Overall gain (Avf) = 100   We have been asked to…

Q: 12 V Ex5: Find the current (1) using superposition. O 24 V 452 D 852 ww @ I 452 ww 32 3 A

A:

Q: Two capacitors of 20 μF and 30 μF are connected in parallel to a 300 volt DC supply. Then find (1)…

A:

Q: Using Nyquist criterion, study the closed loop stability of the system, whose open loop transfer…

A:

Q: Consider the figure shown below with all values in mm and the uniform thickness of 20 mm. If the…

A: GIVEN: thickness=20mm              flux density=1T              number of turns of coil=500 FIND:…

Q: What justifies the need for plenumrated cabling above the ceiling tile?

A: ANSWER                            There are several reasons why we use…

Q: Example In the following cases, the x-axis carries a scale of t in milliseconds. (a) у 4 (b) (c)…

A: Time period: Time period is known as the time taken for one complete oscillation to occur. It is…

Q: 2. The total inductance for this circuit is, mh. 4₁ Sh L₂ 10 h 10 h

A: Given data, Given circuit diagram is,

Q: A fiber optic cable with a numerical aperture of 0.65 is to be spliced to a second fiber optic cable…

A: Given Numerical aperture of first fiber optic cable (NA1) = 0.65 Numerical aperture of second fiber…

Q: 2) Determine (Vo) for the two circuits below using superposition. 20 V 6Ω www 2Α ΣΩ IA να 3 Ω TO 125…

A: When multiple source act on circuit then circuit parameter can be obtained by using superposition…

Q: P7.4: Compare the response of two critically damped systems for different initial conditions and…

A: Given,  A=-110-1, A=-100-1B=11, C=11x01⇀0=11, x02⇀0=-1-1, x03⇀0=-11, x04⇀0=1-1 Here, we have to find…

Q: system. Check if the system y(n) = x(-n) is time variant or time invariant

A:

Q: A string of insulators in a 132 kV line consists of 5 units. If the value of the mutual capacitance…

A:

Q: The voltage signals VA and VB from two sensors need to be conditioned to obtain an output voltage…

A: Given : Output voltage VOUT=AVA-VB Gain A is between 0 to 100 Find : Circuit used to perform the…

Q: Three Provent Shiropari Transmission Lines are taked on three disk suspension insulator. Potentials…

A:

Q: . Two 3300 V star-connected alternators running in parallel supply the following loads : 800 kW at…

A:

Q: 138 Techniques of Circuit Analysis 4.18 a) Use the node voltage method to find vo for the circuit in…

A: Given:Circuit diagram

Q: I want this soln as soon as possible  Kindly draw k-map for function F1(A,B,C,D) =…

A: The reduced boolean expression can be obtained by using the k-map. The result is k-map is a sum of…

Q: The ac equivalent circuit of a crystal has these values: L= 3 H, C= 0.03 pF R = 1000 ohm and…

A: We have an AC equivalent circuit of a crystal, Equivalent circuit of AC crystal is as below,…

Q: 9. The time constant of the circuit shown in the figure below is A. 25 sec. B. 0 sec. C. 025 sec. D.…

A: Given data, Circuit diagram is given as, This is the series RC circuit,

Q: Jai + Ja₂ = I₁ + 1₂ + 13 Ja₂ = I₁ + 1₂ +13 - IG₁ Jaz = 139.96 20° +131.22 2-36.86 +98.982-45' -…

A: Given  IG2 = 200∠20.44  V = 3300 P = ?

Voltage Division Method

In the electronics branch, a voltage divider is required to produce a section of its input voltage as an output. This basic circuit may be prepared with two resistors or any passive elements along with the voltage source. The circuit resistors are attached in series and a voltage source is braced across these resistors. The input voltage can be transferred between the resistors in the circuit for the voltage division to occur. The SI unit of electrical resistance is ohm (Ω) or kilo-ohms (kΩ).