Design a system called a parallel binary comparator, that compares the 4 – bit binary string A to the 4 – bit binary string B. If the strings are exactly equal, provide a HIGH – level output to drive a warning buzzer.

Q: What are some applications for the logic synthesis tool?

A: • CPU: Applications can be implemented in software            and can be executed in one CPU. While…

Q: Use three MSI circuits,construct a binary parallel adder to add 12 bit binary numbers.

A: Addition of two one-bit numbers and an input carry can be carried out by single full adder The…

Q: What does a binary digital signal consist of?

A:

Q: B. Write a VHDL code for designing (2-to-1) 1-bit Multiplexer using an TI statement.

A: Let input to mux are i0,i1 Select line is s Output y

Q: Implement Four-to-one-line multiplexer with Logic diagram and Function table.

A:

Q: 5. For the figure below, with a CLK buffer delay of 2.0 ns, other buffer delays o 1.5 ns,…

A: Setup time is the time duration for which the data should be stable before the clock edge arrival.…

Q: 3- Design the decimal to BCD Encoder ?

A: In general an encoder is a device or process that converts data from one format to another.

Q: 2- Design with drawing an octal-to-binary Encoder ?

A:

Q: Design and draw the circuits below at flip-flop level. a) A 3-bit synchronous binary counter with…

A:

Q: Explain why we need both Analogy as well as Digital signals? Also elaborate the process of…

A: The continuous range of the values is used by the analog signals, which show the information…

Q: Draw a block diagram of Execution and Bus interface units of 8086 microprocessors.

A: Bus Interface Unit (BIU)  The capacity of BIU is to:  Get the guidance or information from memory.…

Q: What is the difference between synchror binary counter and asynchronous binary counter?

A: Counters can be classified into two typed based on how clock signal is applied.

Q: Explain the function of Multiplexer and, Draw the 2 x 1 multiplexer logic circuit diagram and…

A:

Q: Find the binary assignment table for the following circuit, then re-design it using JK flip flops. R…

A: Given circuit diagram: To find: Binary assignment table for the following circuit and re-design it…

Q: 1. How are encoders used in the measurement of speed? Explain the encoder with a neat diagram.

A: An encoder is a transducer that is used to measure angular displacement. The encoder can be used to…

Q: Plot a graph of the voltage gain Av of the ideal inverter  as a function of input voltage vI .(Av =…

A: The voltage gain is defined as the ratio of the output voltage to the input voltage.

Q: RD* = 0 for a memory read bus operation.  True  False

A:

Q: Compare the architectural features of an 8-bit and 16-bit microprocessor.

A:

Q: Write an entity declaration and architecture for the 4-bit priority encoder:

A: VHDL for Priority encoder: entity Priority_Encoder_A is    Port ( INPUT : in STD_LOGIC_VECTOR (3…

Q: Problem 2 Generate the PLA programming table for the combinational circuit that squares a 3-bit…

A: …

Q: design 2 to 8 bit binary comparator and write it's summary?

A: 2 bit comparator A comparator used to compare two binary numbers each of two bits is called a 2-bit…

Q: Example Assuming that a 3-bit ADC channel accepts analog input ranging from 0 to 5volts, determine…

A:

Q: A- How many clock states are in a read bus cycle that has no wait states? What would be the duration…

A: According to the question, we need to explain the following

Q: Explain why we need both Analogue as well as Digital Signals? Also, elaborate the process of…

A: Generally we have two types of signals analogue and digital signals.Both the signals are used to…

Q: b) Briefly describe the function of an encoder. You may use a 4 to 2 decoder to explain the…

A:

Q: Q1: A/ Design and draw a logic circuit that compares between two 3-bit binary numbers. The circuit…

A: To design a circuit which has two 3-bit binary inputs and gives output as logic 0 when both numbers…

Q: Design a three bit synchronous binary counter that counts two by two with T-flipflops,

A: Here you have two draw a three bit synchronous counter by using two flip-flops A). first draw…

Q: what is the advantages of memory segment.

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: 4) Illustrate the generation of noncoherent version of PSK signal for the input binary sequence…

A: Non-coherent PSK Generation : Initially, we are giving the input binary stream and delayed output…

Q: 1a. If an 8-bit binary number is used to represent an analog value in the range from 010 to 10010,…

A:

Q: he difference between the RET and RETI instructions? Explain why we can not use RET instead of RETI…

A: Both perform the same actions of popping off the top two bytes of the stack into the program counter…

Q: Q4. Consider the QPSK digital modulation scheme (a) What does the abbreviation QPSK stand for? (b)…

A:

Q: 8085 microprocessor, the ISR for handling trap interrupt is at which location?

A: In this question we will write about the ISR for handling trap interrupt is at which location in…

Q: The initial state of the four-bit synchronous binary addition counter Q3Q2Q1Q0 is 1100. After 8 CP…

A: Solution . After 8 CP clock pulses, its state Q3Q2Q1Q0 changes to 0101

Q: In digital design, how important are priority encoder, decoder, and multiplexer circuits? Give 3…

A: According to the question, we need to discuss the importance of the priority encoder, decoder, and…

Q: "Microprocessor based system programming concepts and coding examples"

A: Microprocessor programming dialects can normally be separated into three principal types: machine…

Q: Make a counter with the irregular binary count sequence given in diagram.

A: Counter is a  sequential circuit made up of flip flop which are connected to count the pulses .…

Q: Write a simple complete program with LOOP instruction for 8086 microprocessor, and explain the…

A: Loop instruction comes under the iteration control instructions. It's objective is to achieve…

Q: 1- Explain the meaning and operation of CMC instruction ?

A: Since, You ask Multiple questions but we are only allowed to answer one question at a time . so…

Q: (b) Given the function Z (A+B(C+D+ E)+FG.Using static combinational CMOS logic circuit technique,…

A:

Q: 5. Write a pseudocode program for the process by which two numbers, say 4 and 3, could be multiplied…

A: Below find the solution !!

Q: Derive the Boolean expressions for the output P & Q of Figure1. Convert the circuit in Figure 1 to a…

A: Given

Q: (b) Given the function Z = ((A+B (C + D+E)+FG.Using static combinational CMOS logic circuit…

A: The function is given below, Z=A¯+B¯C+D+E+FG¯

Q: The values of A and B as 4 bit binary number and the value of M has been given regarding to…

A: Given: A3A2A1A01000 and B3B2B1B01001.

Q: From the binary number 2's Complement (10011001), write it as a decimal number. andj specify the +…

A: The solution can be achieved as follows.

Q: Design a BCD to 7-segment converter by using logic gates?

A: We need to design a BCD to 7 segment converter by using logic gates.

Q: For a binary pcm, if the number of bits per sample is 8, then estimate the signal to quantization…

A: Given information: For the pulse code modulated system, the number of bits transmitted per sample is…

Q: Q1. Design asynchronous (ripple ) binary counter and timing diagram for the following sequence…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Detail the stages of executing the MOV instructions assuming an 8 bit processor and a 16 bit IR and…

A: To give the details of executing MOV instruction, take an example as, MOV: B, C Where opcode is MOV…

Q: Discussion: 1. What are the advantages of PCM system over other types of modulation systems? 2. What…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask rest again.