Design the nozzle of a fuel injector, which has to expand 2.5 g/s of methane (R = 518 J/kgK; k=1.31) from p,-9 bar, T,= 300 K, c,~0, down to the pressure p,-3.5 bar. Also, evaluate the flow outlet velocity under design conditions. In off-design operations, the pressure upstream of the nozzle is reduced to p,'=3.9 bar, by keeping the same inlet temperature. The downstream pressure remains constant. Determine, under off-design conditions: The mass-flow rate expanded by the nozzle3B The flow outlet velocity, The produs fou denei

Design the nozzle of a fuel injector, which has to expand 2.5 g/s of methane (R = 518 J/kgK; k=1.31) from p,-9 bar, T,= 300 K, c,~0, down to the pressure p,-3.5 bar. Also, evaluate the flow outlet velocity under design conditions. In off-design operations, the pressure upstream of the nozzle is reduced to p,'=3.9 bar, by keeping the same inlet temperature. The downstream pressure remains constant. Determine, under off-design conditions: The mass-flow rate expanded by the nozzle3B The flow outlet velocity, The produs fou denei

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

8.. Nitrogen gas is compressed . Pressure rises from 100 kPa to 1500 kPa. Initial temperature of 25 deg C. The required mass flow is 1000 kg/hr. Would you recommend single stage or multi-stage compression? Justify your recommendation with appropriate calculations. For Nitrogen, R = 0.297 kJ/ kg K, g = 1.4, r = 1.25kg/m3, µ = 17.4 µPa s, cp = 1.039 kJ/kg K
Assuming the clearance is negligible for a single stage compressor with the following data : Atmospheric pressure = 90 kPa, Atmospheric temperature = 17 degrees, Delivery pressure = 7 bar, Free air delivery flow rate = 0,2 m³/min. Take n= 1,3, Cp=1,005 KJ/Kg K, Cv=0,718 KJ/Kg K Determine the following : A) Which formula is used to evaluate the delivery temperature for an isentropic? B) the delivery temperature of air for a polytropic compression process with n=1,25 in Kelvin to 1 decimal place? C) the mass flow rate of air inside the compressor operating isentropically in kg/min to 3 decimal places? D) the power input to the compressor in kW to 2 decimal places if the compression is polytropic compression process with n=1,25? E) the power input to the compressor in kW to 3 decimal places if the compression reversible isothermal? F) the power input to the compressor if the compression is isentropic in kW to 3 decimal places? G) the delivery temperature of air for an isentropic…
A single stage turbo blower compresses 1000 m/min of air at 1 bar and 15° C through a pressure ratio of 1.33 with an index of compression n = 1.6, assuming the power input to the blower to be 800 kw and C,= 1.005 Calculate Isentropic efficiency of blower R=287 J/kg-K.
12- Combustion gases (k=1.33) enter a convergent nozzle at a stagnation temperature of 350 oC and a stagnation pressure of 430 kPa and are vented to the atmosphere at 20 oC, 100 kPa. Which of the following is the lowest pressure that will occur in the nozzle?
Steam enters a nozzle at pressure of 1.2 MPa, temperature of 500 oC, and a velocity of 38 m/s and leaves as saturated vapor at 75 kPa, what is the exit velocity (m/s) when a heat loss of 19.5 kJ/kg is present? a. 1263.3 b. Not listed c. 159.9 d. 1273.4 e. 1276.8
Combustion gases with k=1.35, Cp =1107 J/(kg.K) and R= 287 J/(kg.K) flow at stagnation pressure and stagnation temperature of 390kPa and 1150 K respectively, flow through a 90o IFR turbine to an exit static pressure of 100 kPa. The total to static efficiency is 80% and the flow leaves the stator choked (Mach Number=1). The relative velocity at the inlet to the rotor is radial and the flow leaves the turbine without a swirl. Find (a) the work delivered per unit flow rate, (b) the impeller tip velocity and (c) the flow angle at the inlet to the rotor.
A ramjet drives a missile at V0=966m/s at an altitude of 33.5km (air density 0.01kg/m3 and T0=232K). If the missile inlet captures a stream tube of air A0=1,1m2 in area, the fuel-to-air ratio is 0,049, and the fuel heating value is 50MJ/kg. if the ramjet engine produces net thrust Fn= 8,9 kN , What is the useful power that the engine introduces to the missile?
Assess the capabilities of a hydroelectric power plant from the following field data: Estimated water flow rate, 40 m3/s River inlet at 1 atm, 10 C Discharge at 1 atm, 10.2 C, 200 m below the intake
A gas turbine having single stage rotates at 10000 tpm. At entry to the nozzles the total head to the temperature and pressure of the gas i8 700°C and 4.5 bar respectively and at outlet, from the nozle the static pressurc is 2.6 bar. At the turbine outlet annulus the static pressure is 1.5 bar. Mach number at outlet is limited to 0.5 and gas leaves in an axial direction. The outlet nozzle angle is 70° to the axial direction and the nozzle friction loss may be assurfied to be 3% of the isentropic temperature drop from total head at entry to static conditions at outlet nozzle pressure. Calculate (i) the gas angles at entry and outlet from the wheel showing them on velocity diagrams for mean blade section, (ii) output power developed by the turbine shaft. Assume the mean blades diameter as 64 cm, gas mass flow rate as 22.5 kg/s, turbine mechanical efficiency = 99%, C; = 1147 kJ /ke K and v = 1.33.
Air is expanded in a multi-stage axial flow turbine, and the pressure drop across each stage is very small. Assuming that air behaves as a perfect gas with ratio of specific heats γ, derive pressure-temperature relationships for the following processes: A) Reversible adiabatic expansion: B) Irreversible adiabatic expansion, with small stage efficiency ᵑp ; C) Reversible expansion in which the heat loss in each stage is a constant fraction k of the enthalpy drop in that stage.
4. Air flows isentropically through the channel To = 300 ° C. both ends have an identical area that is A = 25 cm², pressure p1 = 120 kPa and p2 = 60 kPa. Determine : a). Mass flow rate, b). Throat area C). Ma2
In a turbine system, states A and B are homologous. If the net head ratio HA/HB =16 , volume flow rate ratio VA˙/VB˙=9. What is the diameter ratio DA/DB ? a) 3/2 b) 6 c) 12 d) 2/3