Determine the amount of energy necessary to raise 51 kg of aluminum by 156 degrees Celsius. Report your answer in units of Joules using scientific notation (#.##E#). Assume that no phase change takes place. Use the specific heat values listed in table 11.1 from the textbook.

Determine the amount of energy necessary to raise 51 kg of aluminum by 156 degrees Celsius. Report your answer in units of Joules using scientific notation (#.##E#). Assume that no phase change takes place. Use the specific heat values listed in table 11.1 from the textbook.

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter21: Heat And The First Law Of Thermodynamics

Section: Chapter Questions

Problem 4PQ

See similar textbooks

Related questions

Q: A 4500 kg ship moves at a speed of 2 m/s, determine its power (P)? ASsume all the energy losses are…

Q: 1. A2 kg mass attached to a spring with a spring constant of 400 N/m is pulled 10 cm from…

Q: Given below are the distance graphs of a large ball made of entangled rubber bands and a man dropped…

A: We generally calculate two types of velocities. One is average velocity and other is instantaneous…

Q: A projectile is fired with an initial velocity of 400 m/s hits a cliff 2000 meter apart determine…

A: range = V0 cos(60) x t here V0 = 400m/s time of flight is t seconds range = 2000m thus, time (t) =…

Q: The resistance of a certain conductor , 300 mil diameter and 20 ft long is 200 x10^-3 Q. Calculate…

Q: Q3) Calculate that [Ĥ‚P]

Q: 15. A body of mass 5 kg is moving with velocity of v = (21+ 6j) ms- att = 0 s. After timet =2 s,…

Q: E Consider an elevator car (lift) with a mass of 700kg which call carry up to 600kg of passengers.…

Q: 5. In the circuit shown, 3 0 Determine the following: A. Magnitude and direction of the current B.…

A: Given The circuit diagram and we have to determine magnitude and direction of the current, the…

Q: A bullet of mass 20g traveling at 16m/s penetrates a sand bag and is brought to rest in 0.05s . Find…

A: A. Depth of penetration is 0.4m B. Average retarding force is 6.4

Q: The slope of the line in a position vs time graph represents the

Q: If the ideal gas law (PV = kT) is used to find P when T and V are given, but there is an error of…

Q: 9. When a load of 10 kg is hung from the wire, then extension of 2 m is produced. Then work done by…

Q: Describe and compare the wavelength, amplitude, frequency, and period of the waves in the figure…

Q: the distance traversed by a particle moving along a straigh line is given by x = 180t + 50t² metre.…

A: Acceleration is the rate of change of the velocity of an object with respect to time. Here, we…

Q: The resistance of a certain conductor , 300 mil diameter and 20 ft long is 200 x10^-3 Q. Calculate…

Q: Part A Olaf is standing on a sheet of ice that covers the football stadium parking lot in Buffalo,…

Q: How are bulbs and or LED lights in your house connected? Why is this so?

Q: A bicyclist is riding on the banked curve of a circular velodrome. The radius of curvature for the…

Q: How much heat is given off by 25 g of aluminum as it cools from 100 ◦C to 20 ◦C?

A: Given data: Mass (m) = 25 g = 0.025 kg Initial temperature (Ti) = 100°C Final temperature (Tf) =…

Q: IS

Q: A motor having a resistance of 15.0 Q is connected to a 120 V line. What is the back electromotive…

Q: what is the method to get the answer for the second question?

Q: interest rate is 10%, at

A: False

Q: Mass spectrometric analysis of potassium and argon atoms in a Moon rock sample shows that the ratio…

Q: 1. A boy throws a paper airplane. It follows a parabolic path as shown in the figure. At the instant…

A: Given, ad = 0.2 m/s2 v = 1.5 m/s y = (4/30)x2 +1 We have to find out the total…

Q: ANALYSIS Problem solving. (Show your solution) 1. A steady current of 2.0 A flows in a wire for 16.0…

Q: An ideal gas with energy E = NKBT moves quasi-statically (i.e. reversibly) from state A to state Cas…

Q: metal loop enters a region with a uniform magnetic field at a constant velocity. In which direction…

Q: The gravitational force between two particles with masses m and M, initially at rest at great…

Q: shown in the figure weighs 150 kg and has a centroidal radius of gyration of 200 cm. The blocks are…

A: The pulley assembly shown in the figure weighs m = 150 kg It has a centroidal radius of gyration of…

Q: Modern computer memories use parallel-plate capacitors to store information, and these capacitors…

Q: is placed 45 cm in front of a concave mirror with a focal length of 14 cm. How tall is the image?

A: Given Data:- The height of the object is h = 8 cm The object distaance is u = -45 cm The focal…

Q: n ideal gas with energy E = NKBT is subjected to a cyclic, quasi-static (i he figure. What is the…

A: An ideal gas with energy E = 52NkBT is subjected to a cyclic, quasi-static (i.e. reversible) process…

Q: A car is moving on a straight road 23 m/s. It is acceleration at 30 m/s2. What will be it's velocity…

A: Given data : Acceleration = a Initial velocity = u Time = t…

Q: A lady wants to listen to a programme on his favourite radio station, broadcasting at a frequency of…

A: Given data: A radio wave Frequency (f) = 1000 kHz = 1000×103 Hz Required: Wavelength (λ)

Q: An unstretched spring is 10 ft long. A pull of 40 lb stretches the spring by ½ ft. Find the work…

Q: Find the uncertainty in a calculated electrical potential difference from the measurements of…

Q: 2. A glass rod was positively charged when rubbed with a silk cloth. The net positive charge is…

A: Note: As per our guideline, I will solve the first question only. Please post other questions…

Q: Determine the final velocity of car. Initial velocity=5 m/s acceleration=2 m/s2 time=2 s

Q: wo objects with a mass of 48 kg and 60 kg respectively, produce a gravitational force between them…

A: Given: m = 48 kg , M = 60 kg F = 2.8 x 10−6 N , G = 6.67*10^(-11) Nm^2/kg^2 Required : distance…

Q: The armature of an AC generator consists of 10 turns of wires, with an area of 0.5 m2 each, having a…

A: Answer

Q: 4. Which of the following equations correctly calculates the capacitance (C) of a parallel-plate…

A: Step1 - Here we will understand the concept that will be used to solve this question.…

Q: What current flows through the bulb of a 3.00 V flashlight when its hot resistance is 3.60 Q? The…

Q: Which of the following statements is false? (a) Gaps need to be left in lengths of railway lines…

A: (1)Gaps need to be left in lengths of railway lines to prevent buckling in hot weather It is a true…

Q: IF an unknown element has 30 neutrons and a quantum number sequence of 3, 2, -2, -1/2 identify: Z=…

A: number of neutrons = 30 quantum number sequence = 3 , 2 , -2 , -1/2

Q: In this circuit, the current through the 5-W resistor is approximately 100 V 5 0 10 0 10 0 4 A 20 A…

Q: excitation is increased by 20% Jor Me suml ) Find the P, Q, E und s of the given system when…

Q: 1. Suppose the pulley in Figure2 is suspended by a cord C. Determine the tension of cord connecting…

A: We have two masses mA=24.32 kg and mB=32.80 kg, let the tension on the cord be T and acceleration of…

Q: An Carnot engine absorbs heat at high temperature 800 Kelvin and efficiency of the Carnot engine is…

Question

Determine the amount of energy necessary to raise 51 kg of aluminum by 156 degrees Celsius. Report your answer in units of Joules using scientific notation (###E#). Assume that no phase change takes
place. Use the specific heat values listed in table 11.1 from the textbook.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A poker is a stiff, nonflammable rod used to push burning logs around in a fireplace. For safety and comfort of use, should the poker be made from a material with (A) high specific heat and high thermal conductivity, (B) low specific heat and low thermal conductivity, (C) low specific heat and high thermal conductivity, or (D) high specific heat and low thermal conductivity? Please explain the correct answer. Thank you.
Define the term molar heat capacity at constant volume?
How much internal energy in Joule is generated when a (1.67x10^1)-g lead bullet, traveling at (4.9000x10^2) m/s, comes to a stop as it strikes a metal plate? Give your answer with three significant figures.
A ceramic ball of radius 2.52 m and emissivity 0.900 is heated to 123°C. (a) Convert the given temperature to Kelvin. (Enter your answer to at least three significant figures.) K (b) What is the surface area (in m2) of the ball? m2 (c) If the ambient temperature is 26.0°C, what net power (in W) does the ball radiate? W
A 4-ton air conditioner removes 5.06×107 J (48,000 British thermal units) from a cold environment in 1.00 h. (a) What energy input in joules is necessary to do this if the air conditioner has an energy efficiency rating ( EER ) of 12.0? (b) What is the cost of doing this if the work costs 10.0 cents per 3.60×106J (one kilowatt-hour)? (c) Discuss whether this cost seems realistic. Note that the energy efficiency rating ( EER ) of an air conditioner or refrigerator is defined to be the number of British thermal units of heat transfer from a cold environment per hour divided by the watts of power input.
Define the adiabatic expansion of an ideal gas?
An insulated beaker contains an unknown mass of liquid water at a tempeerature of 75 degrees c. you place 0.100 kg of pure ice with an initial temperature of 0 degrees c in the beaker. after the system has come to equilibrium, the final temperature in the beaker is 40 degree c. (Cice= 2090 J/kgK, Cwater= 4186 J/kgK, Lfwater= 333,500 J/kg) a) sketch two temperature vs. energy added diagrams (one for ice and one for water) b)solve for the amount of heat energy that must have been transferred to the ice to get it from its initial state to its final state c) use the answer from b to solve for the mass of the water in the beaker.
A Styrofoam cup holds 0.302 kg of water at 22.5°C. Find the final equilibrium temperature (in degrees Celsius) after a 0.123 kg block of iron at 90.1°C is placed in the water. Neglect any thermal energy transfer with the Styrofoam cup. The specific heats of water and iron are cwater = 4186 J/(kg · °C) and cFe = 448 (kg · °C). I've tried this before and my answers (26.7 and 27.6 were incorrect).
A 6.0 m * 8.0 m * 3.0 m room contains air at 20\deg C. What is the room's thermal energy
A person eats a dessert that contains 170 Calories. (This "Calorie" unit, with a capital C, is the one used by nutritionists; 1 Calorie = 4186 J. See Section 12.7.) The skin temperature of the person is 36 °C and that of her environment is 18 °C. The emissivity of her skin is 0.71 and its surface area is 1.5 m2. How many hours would it take her to emit a net radiant energy from her body that is equal to the energy contained in this dessert?
A person eats a dessert that contains 280 Calories. (This "Calorie" unit, with a capital C, is the one used by nutritionists; 1 Calorie = 4186 J.) The skin temperature of this individual is 36°C and that of her environment is 24° C. The emissivity of her skin is 0.75 and its surface area is 1.3 m2. How much time would it take for her to emit a net radiant energy from her body that is equal to the energy contained in this dessert?