Determine the average rate of heat transfer into your room through walls and roof. Consider the thermostat in the room is set at 200C and the average temperature outside is 460C during the five months long summer season. Disregarding any direct radiation gain or loss through the windows and taking the heat transfer coefficients at the inner and outer surfaces of the house to be 6 and 14 W/m2 · °C

Q: A 75-hp (shaft output) motor that has an efficiency of 91.0 percent is worn out and is replaced by a…

A: Given Data: The output power of the older shaft motor is (Wo)1= 75 hp The efficiency of the older…

Q: How does heat transfer and energy transformations make heat engines like geothermal plants work?

A: HEAT ENGINES Heat engines cause heat energy through the working fluid to be transformed to cinematic…

Q: Consider an electric refrigerator located in a room. Determine the direction of the work and heat…

A:

Q: A closed system having a mass of 50 kg has an initial velocity of 10 m/s. Subsequently its velocity…

A:

Q: Water is being heated in a closed pan on top of a range while being stirred by a paddle wheel.…

A: Given data: The heat transferred to the water is Q1=30 kJ. The heat lost by the surroundings is…

Q: Water is pumped from a lower reservoir to a higher reservoir by a pump that provides 20 kW of shaft…

A:

Q: How is electricity generated from wind

A: Wind turbines operate on a simple principle: instead of using electricity to generate wind (like…

Q: Determine the Kinetic energy in BTU of a 8 lbm block moving at a velocity of 85 ft/s.

A: Given data  mass of block (m)= 8 lbm velocity of block(v) = 85 ft/s

Q: A piston cylinder assembly was insulated so that no heat could get in or get out. If the system was…

A:

Q: When is work said to be done by a system. Is there any difference between work transfer and heat…

A: Work done is a way through which energy transfer occurs between the system  Energy is the ability or…

Q: Consider a TV set that consumes 120 W of electric power when it is on and is kept on for an average…

A: Given: The average time per day TV is kept on is t=6 h The power consumes by the TV is P=120 W The…

Q: A room is heated by a baseboard resistance heater. When the heat losses from the room on a winter…

A:

Q: A fluid enters a machine at 187.91 m/s, 792 kPa, and with a specific volume of 0.111 m³/kg. The…

A: For solution refer below images.

Q: Two constant-volume tanks, each filled with 30 kg of air, have temperatures of 900 K and 300 K. A…

A: Given data: Mass of air, m = 30 kg Initial temperature of source, T1 = 900 K Initial temperature of…

Q: The average specific heat of the human body is 3.6 kJ/kg·°C. If the body temperature of an 80-kg man…

A: Given data :C=3.6 KJ/kg C°M=80 kgT1=37°CT2=39°C

Q: A hot water pipe at 80°C is losing heat to the surrounding air at 5°C by natural convection with a…

A: given that  h = 25 w/m^2-k dT = (80-5) = 75 degrees

Q: Consider refrigerator whose 40 watts light bulb remains on continuously as a result of a malfunction…

A:

Q: In a piston cylinder system, the gas expands from 1.5 m³ to 7.5 m³ with an increase in internal…

A:

Q: A wind turbine is rotating at 15 rpm under steady winds flowing through the turbine at a rate of…

A: Given: The speed of wind turbine, N = 15 rpm The mass flow rate of wind, m = 42000 kg/s The tip…

Q: A hollow spherical iron container with outer diameter 20 cm and thickness 0.2 cm is filled with iced…

A: The outer radius of the hollow sphere, The inner radius of the hollow sphere, The thermal…

Q: A 20-kW electric heater is used to heat up a house with size measured 6 m x 8 m x 10 m. The house is…

A: The mode of heat transfer in which molecules from a hot surface moves to a cold surface due to…

Q: A fluid enters a machine at 10200 m/min. 800000Pa, and with density of 3.333 kg/m3. The radiation…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Q: 15. Water is being heated in a closed pan on top of a range while being stirred by a paddle wheel.…

A:

Q: A 2-kW electric resistance heater in a room is turned on and kept on for 30 min. The amount of…

A: Power of electric resistance heater, P= 2-kW or 2000 W  Time of working, t= 30 min or (30*60)…

Q: 1. An engine developer proposes one that has an operating temperature of 28°C surface of the water…

A: from clausius inequality ∮δQT≤0 for the process to be possible   heat absorbed from top surface =…

Q: Calculate the total heat transfer for 12 hours through an insulated window that measures 4 ft × 7…

A: Since the window is insulated, there should not be any transfer of heat between system and…

Q: Consider a river flowing toward a lake at an average velocity of 3 m/s at a rate of 570 m³/s at a…

A: Given data: V=3 m/sz=90 mV˙=570 m3/s Need to determine the total mechanical energy of the river per…

Q: The pump of a water distribution system is powered by a 15-kW electric motor whose efficiency is 90…

A: Given: The efficiency of the electric motor is ƞmotor=90%. The water flow rate is V=50 L/s. The…

Q: A student living in a 4-m x 6-m x 6-m dormitory room turns on her 150-W fan before she leaves the…

A:

Q: The temperature at the inner and outer surfaces of a boiler wall made of 25 mm thick steel and…

A: solutiongiven dataTi=350°CT∘=600°Cb1=25 mmb2=15 mmks=68 w/m°CKins=0.126 w/m°C

Q: In a piston cylinder system, the gas an initial pressure of 100 kPa and expands from 1.5 m3 to 7.5…

A: To find: The heat gain or loss in the system. Given: The initial pressure is P1=100 kPa. The initial…

Q: :A thin metal plate is insulated on the back and exposed to solar radiation on the front surface.…

A:

Q: Heat is transferred steadily through a 0.2-m-thick, 8 m × 4 m wall at a rate of 2.4 kW. The inner…

A:

Q: A fluid enters a machine at 182.39 m/s, 804 kPa, and with a specific volume of 0.206 m3/kg. The…

A:

Q: A flat-plate collector gets incident of solar radiation at a rate of 260 Btu/h-ft' and has the…

A: Incident Radiation, G = 260 BTuh*ft2 Collector temperature, Tc = 120 F ambient air temperature, Ta =…

Q: Consider a 300-liter water heater that is initially filled with water at 290 K. Determine how much…

A:

Q: hydraulic turbine is used to generate power by using water in a dam. The elevation difference…

A:

Q: A fluid enters a machine at 161.96 m/s, 881.74 kPa, and with a specific volume of 0.174 m³/kg. The…

A:

Q: Consider a river flowing toward a lake at an average velocity of 22.5 km/hr at a rate of 387 m3/s at…

A:

Q: A 2 kW electric resistance heater in a room is turned on and kept on for 30 min. The amount of…

A: Power, P = 2 kW = 2000 W Time, t = 30 minutes = 1800 seconds Work Done, W = ?

Q: An oil pump is drawing 44 kW of electric power while pumping oil with ρ = 860 kg/m3 at a rate of 0.1…

A: First, we calculate the mechanical power output…

Q: A fluid enters a machine at 188.98 m/s, 805 kPa, and with a specific volume of 0.125 m³/kg. The…

A:

Q: A student living in a 4-m x 6-m x 6-m dormitory room turns on her 150-W fan before she leaves the…

A:

Q: A hydraulic turbine is used to generate power by using water in a dam. The elevation difference…

A:

Q: : A thin metal plate is insulated on the back and exposed to solar radiation on the front surface.…

A:

Q: Consider a river flowing toward a lake at an average velocity of 3 m/s at a rate of 500 m3 /s at a…

A: At the location of 90 m, the river is flowing with an average velocity of 3 m/s. So, the total…

Q: A fluid enters a machine at 170 m/s, 800 kPa, and with a specific volume of 0.3 m3/kg. The radiation…

A:

Q: A burner is used to increase the temperature of a substance from 10 °C to 50 °C with the thermal…

A: Write the given values with the suitable variables. T1=10 °C=283 KT2=50 °C=323 KQ=80 kJ=80×103 Jm=20…