Determine the center of gravity for a miniature model of a bus stop as shown in Figure. Neglect the thickness of the model. 12 Cm

Q: A block of mass 10 kg rests on a horizontal floor. The acceleration due to gravity is 9.81 m/s?. The…

A:

Q: The figure below shows a manometer connected to a pipeline containing oil of specific gravity 0.8.…

A:

Q: 14. In the figure, fluid A has a specific gravity of 0.90 and fluid B has a specific gravity of…

A: Given data  Specific gravity of fluid A (GA) = 0.9  Specific gravity of fluid B (GB) = 3    Specific…

Q: Panel AB is circular and retains a liquid with specific gravity of 1.6. It has a width of 4 feet…

A:

Q: SITUATION. On a frictionless, horizontal air track, a glider oscillates at the end of an ideal…

A: Answer We can write down the given data from the acceleration graph Maximum acceleration amax = 12…

Q: 1. In the given figure below, locate the centroid from x and y axis. In addition, determine the…

A: The given figure is divided into three shapes as shown below. Here, 1 and 2 are the areas to be…

Q: When a 5-kg object is placed on top of a vertical spring, the spring compresses a distance of 1.5…

A: Given data :-  A object is placed on the top of a vertical spring.  Mass of the spring(m) = 5 Kg…

Q: For the figure ,point A is (30 cm) below the surface of liquid , What is the pressure

A:

Q: 6m 5m S.G=0.9 2m 2m 2m 6m 1m, Mercury Water @ 20 degree Hemispherical shape

A: Consider the following figure: Where, FN is force of buoyancy. FW is  weight of water displaced.

Q: An open water tank shown in figure is moving up a 30 degree incline with constant acceleration a as…

A:

Q: A 100-ft long dam holds 30 ft of water as shown in the figure. Using the panel equations, determine…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: For the given section shown in the figure, determine the following: 20 mm Moment of inertia with…

A: For the given angle section, the position of centroid is given by:…

Q: A stick 3 meters long is placed in a horizontal position with its end resting on two inclined…

A:

Q: (a) Find the rate of change of volume of a cylinder with radius, 6 cm and height, 14 cm if the…

A: Given data: circular cylinder r=6 cm H=14 cm drdt=0.3 cm/sdHdt=-0.4 cm/s

Q: H.W An inverted right circular conical tank, as shown in the figure, is initially filled with water.…

A: Given:- Ht = h Radius = r To find:- height of water function of time v(t)=2gh(t)Between the points A…

Q: 5. What is the required vertical upward acceleration so that the pressure at any point in a liquid…

A:

Q: Using the figure shown below, determine the location of the center of gravity.

A: Given:- Figure is shown with shaded area   To determine:- The location of centre of gravity

Q: 36 m/s 36 m/s →→ water jet ↓5 cm block

A:

Q: The figure shown is formed of 1/8 -in.-diameter steel wire. Knowing that the specific weight of the…

A: The diameter if the wire is 1/8 in. The specific weight is 490 lb/ft3. The diagram of the wire is…

Q: The liquid reservoir in the figure accelerates to the right with its fluid moving like a rigid…

A: Schematic diagram of the given problem: h = 28-15 = 13 cm

Q: Q3) Determine the center of gravity of the below figure symmetrical about the y-axis, then discuss…

A: The center of gravity is a geometric property of any object. The center of gravity is the average…

Q: In the figure below, the weight of the block is 300 kg and the angle of internal friction is 24.2…

A:

Q: Question #3: The couple in the figure lies in the shaded plane which connects three corners of the…

A:

Q: A triangular plate made of homogeneous material has a constant thickness that is very small. If it…

A:

Q: An object with a mass of m=4.7 kg is attached to the free end of a light string wrapped around a…

A: Following is the given information: Mass of object, m = 4.7 kg Mass of the disk, M = 3.00 kg Radius…

Q: 1. Starting from rest, an elevator weighing 8.9kN attains an upward velocity of 5m/s in 4 seconds…

A:

Q: On the ceiling, a spring is attached with a  3 kg mass to the other end. Here on earth, the…

A: The mass of the object is m=3 kg. On Earth, The acceleration due to gravity is ge=9.81 m/s2. The…

Q: Q2) Example: A pitot-static probe connected to a water manometer is used to measure the velocity of…

A: We take point 1 on the side of the probe where the entrance is parallel to flow and is connected to…

Q: 46. Consider a 50-N weight suspended by two wires as shown in the accompanying figure. If the…

A: Given that:

Q: Situation 2: As shown in the figure, two blocks are connected by a light, flexible cord passing over…

A:

Q: If the pressure in the air shown in figure, is increased by 10 kPa, the magnitude of H will be…

A:

Q: 1. A 15-lb block A rests on a 35-lb wedge B as shown in the figure. Determine the acceleration of…

A: Solution Given That Mass of Block A= 15 lb Mass of Block B= 35 lb

Q: For the Figure, the cover gate AB closes a circular opening 114.2 cm in diameter.The minimum mass…

A: The given data is: Diameter of Circular opening for Gate AB (d) = 114.2 cm h = 137 cm

Q: The figure shows gate AB, 4 meters high, submerged in water. It is inclined 40 degrees with respect…

A: Center of gravity refers to the location where the body's mass is concentrated. Center of gravity…

Q: Q3: Define the friction losses in pipes, what are the parameters that effect on friction in the…

A:

Q: 180 Problem: From the figure shown the coefficients of friction are as follows: 0.25 at the floor,…

A:

Q: Consider oil flowing through a horizontal pipe at a rate of 3 liter/s. There are two sections of the…

A:

Q: For Figure 9.2 as shown, determine the centroidal moment of inertia about x and y axis, -500 mm-…

A: Given:- A composite figure is given To determine:- The centroidal moment of inertia about the x and…

Q: 1. When a 10-kg object is placed on top of a vertical spring, the spring compresses a distance of…

A:

Q: EXAMPLE If each pulley has a mass of 5 kg. what is the mass "M" that will hold the system in…

A: solution  Draw the free body diagram of individual pulley  and then apply equilibrium conditions…

Q: The figure shown a motor pulling an object in an in clined surface determine the power required to…

A: Given, Velocity = 3.5 m/s μ = 0.20

Q: In a demonstration of the momentum of fluid flow, a circular plate was suspended in equilibrium on…

A:

Q: Auniform ladder of length 2.1 m and mass 20 kg leans against a vertical wall to make an angle of a =…

A: What is the minimum value of P(N) required to prevent downward sliding of the ladder?

Q: 2. 200 7 100 ► 12 20 100 Figure a Dimension in "mm"

A:

Q: 40 kN What weight W is 60 kN W necessary to start the system of blocks shown in Fig. moving to the…

A: Given Data:Weight of the Blockd w= 60kN, 40kN,Angle = 30°Cofficient of friction= 0.10

Q: For the figure shown, locate the center of gravity with respect to reference X and Y axes.

A: Given section:

Q: Q4: A 7-cm diameter solid aluminum ball balance nicely when submerged in a fluid as shown in figure.…

A: Given: Dal = 7cm, S.Gal = 2.7, SGbr = 8.5

Q: A mass of 3.9kg is projected with a speed of 4.7m/s up a plane inclined 38 degrees with the…

A:

Q: For the figure shown, locate the center of gravity with respect to reference X and Y axes

A: Given section

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.