Determine the elastic settlement using the Schmertmann method of the 10'x 10' footing as shown below. Estimate the elastic modulus using Es = 10(N + 15), where Es is in ksf and N is the corrected SPT value. Q = 250 kips | DEPTH SPT (t) Loose sand 10 10 x 10 Medium dense sand Layer 1 21 10 Layer 2 11 Loose sand 15 Layer 3 Layer 4 Layer 5 15 Dense sand 20 41 4 Very loose sand 25 0 02 04 0.6 STRAIN E

Determine the elastic settlement using the Schmertmann method of the 10'x 10' footing as shown below. Estimate the elastic modulus using Es = 10(N + 15), where Es is in ksf and N is the corrected SPT value. Q = 250 kips | DEPTH SPT (t) Loose sand 10 10 x 10 Medium dense sand Layer 1 21 10 Layer 2 11 Loose sand 15 Layer 3 Layer 4 Layer 5 15 Dense sand 20 41 4 Very loose sand 25 0 02 04 0.6 STRAIN E

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter17: Settlement Of Shallow Foundations

Section: Chapter Questions

Problem 17.10P

See similar textbooks

Similar questions

A rectangular footing 3m x 2m exerts a pressure of 100kN/m2on a cohesive soil Es= 5x104 kN/m2and µ = 0.5. Estimate the immediatesettlement at the centre, assuming(a) the footing is flexible (b) the footing is rigid (ii) Write about influence of water table in determination of bearing capacity.
A strip footing shown is resting on loose sand has the following data (refer to figure h = 0.95 m Df = 1.9 m B = 1.8 m Unit weight of soil above GWT = 1750 kg/m3 Saturated Unit weight of soil = 1950 kg/m3 c = 12 kPa Angle of internal friction = 30 degrees Calculate the following: Net Allowable Bearing Capacity of the footing using Terzaghi’s assumption, kPa. Use FS = 2.5
A strip footing 2m wide carries a load intensity of 400 kN/m2at a depth of 1.2 m in sand. The saturated unit weight of sand is 19.5 kN/m3 and unit weight above water table is 16.8 kN/m3. The shear strength parameters are C=0 and Ф = 350 . Determine the factor of safety with respect to shear failure for the following cases of location of water table :(a) Water table is 4m below G.L(b) Water table is 1.2 m below G.L(c) Water table is 2.5 m below G.L(d) Water table is 0.5 m below G.L(e) Water table is G.L itself
Calculate the size of a square footing on a soil profile consisting of a medium-densesand layer with constant N values, N60 = 30. The dead load is 500 kN and the live load is200 kN. The footing is embedded 1 m into the sand. Groundwater is 2 m below thesurface. Consider that allwable settlement is 25 mm.
Problem 1 A 3m x 3m square footing is constructed at a depth of 2m in a 26m deep clay layer with following soil properties: g =16.5kN/m3, Normally Consolidated Clay, eo= 0.65, Cc = 0.25,ms=5 and Es= 6.0 MN/m2. If there is a 1000kN structural load on the footing, calculate the consolidation settlement of the footing. A 2m X 2m footing carrying 1400kN load is constructed in a site with 2.5m thick clay layer under a 2.5m thick sand layer. If the footing and the ground water table are located at 1.5m below the surface, calculate the consolidation settlement of the footing. You may assume the following soil properties: for sand gsat = 19.25kN/m3 and gt = 7kN/m3, and for clay eo= 0.65, Cc = 0.25, Cs = 0.06, s’p = 200kN/m2 and gsat =19.25kN/m3. A 1882kN load is carried by a 2.6m x 2.6m square footing at a depth of 1.4m in a 30 m deep sand layer. Given the following soil properties for soil calculate the total settlement of the footing after 10 years. Where soil properties are: g = 15.9…
A square footing has a dimension of 1.43 m x 1.43 m and has its bottom 1.07 m below the ground surface. Compute for the gross allowable load in kg that the footing has to carry if it has a factor of safety of 2.57. Ground water table is located 0.50 m from the bottom of the footing. Soil Properties: c = 1,718 kg/m2 Specific gravity, Gs= 2.61 Void ratio, e =0.40 = 30 degrees HINT: Use Dry unit weight for soil above the groundwater table. Unit weight of water = 9.81 kN/m3
A rigid 2m square footing is constructed over a loose sand layer as shown on the figure. It carries a total load of 810kN. Compute the elastic settlement of the 3m footing if the poisson's of soil is 0.32, modulus of elasticity of soil Es = 16000kPa , influence factor
A square footing having a dimension of 4m has its bottom at a depth of 3.2m Trom the ground surface. The water table is located at an insignificant depth. FS=3 Properties of wet soil are as follows: Specific gravity, Gs = 2.7 Void ratio, e = 0.35 Degree of saturation = 70% Cohesion, c = 19 kPa Angle of internal friction = 26 degrees Assume general shear failure. Calculate the following: 1. Gross Ultimate Bearing Capacity of the footing using Terzaghi's assumption, kPa. 2. Net Allowable Bearing Capacity of the footing using Terzaghi's assumption, kPa.
Refer to the rectangular combined footing in Figure 10.1, with Q1 = 100 kip and Q2 = 150 kip. The distance between the two column loads L3 = 13.5 ft. The proximity of the property line at the left edge requires that L2 = 3.0 ft. The net allowable soil pressure is 2500 lb/ft2. Determine the breadth and length of a rectangular combined footing.
A 2.0 m 2.0 m square pad footing will be placed in a normally consolidated clay soil to carry a column load Q. The depth of the footing is 1.0 m. The soil parameters are: c = 0, =26, = 19 kN/m3, cu = 60 kN/m2 (=0 condition). Determine the maximum possible value for Q, considering short-term and long-term stability of the footing.
Redo Problem 16.13 with the following data: gross allowable load = 184,000 lb, = 121 lb/ft3, c = 0, =26, Df = 6.5 ft., and required factor of safety = 2.5. 16.13 A square footing (B B) must carry a gross allowable load of 1160 kN. The base of the footing is to be located at a depth of 2 m below the ground surface. If the required factor of safety is 4.5, determine the size of the footing. Use Terzaghis bearing capacity factors and assume general shear failure of soil. Given: = 17 kN/m3, c = 48 kN/m2, =31.
Q#2: {7} Compute the allowable load using the General (Meyerhof) Bearing Capacity equation for the rectangular footing and soil parameters shown in Figure # 2. Use a safety factor of 3 and assume dimension of footing B = 1m, and L = 2m. Figure # 2 Note: Write the proper answer in word format Subject: Geotechnical Design