Determine the equivalent capacitance ( combination shown in mF units) of the when C = 46.8 mF. C
Q: . Do the following operation (i) (246 )8 + (521)8 (ii) (324 )8 + (631)8 (iii) (704 )8 - (103)8
A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…
Q: What is the limit on how many gravity assists a single spacecraft can get?
A: The principle of gravity assist is that the initial velocity of a ship can be multiplied by up to…
Q: Determine the velocity of electromagnetic wave in free space. I need detail calculation.
A: In this case, the velocity of an electromagnetic wave in free space is to be determined.
Q: Transfer the circuit of the figure to the frequency domain and calculate: a) ?(?) =????(?)/????(?) ,…
A: It is straightforward to solve time domain differential equations in the S domain by utilising…
Q: QUESTION 4 Maximum Power transfer (CLO 5) The value of the load resistor R₁ to ensure the maximum…
A: Given circuit,
Q: II. From the circuit given below, find a) Z. b) 11;1;&13 c) Pand d) pf Г 11. Hf e 0.2 0.42 ww 영 100…
A:
Q: Question-1 Consider the signal below: Given that A = 5 and B = 2 x(t) 0 2B B A t a) [ Write the…
A: Given A=5 B=2 Find Equation of the periodic waveform Express the periodic waveform in Fourier…
Q: An available transformer core has a cross-sectional area of 5 cm^2 and a saturation flux density…
A:
Q: 3. About Transformer efficiency 3.1. Define efficiency 3.2.State the criterion for maximum…
A: 3.1 Transformer efficiency is defined as the ratio of available output power to input power.…
Q: Consider an aperiodic continuous-time si x(t) having the corresponding Fourier transform X(jw). What…
A: In this question we will find Fourier transform of given signal...
Q: For an SCR, the gate cathode characteristics is given by a straight line with a gradient of 16 volts…
A: We got an SCR with 16 volts per amp(V/A) Given Data, Minimum gate current (Ig)min = 500 mA = 0.5 A…
Q: Apply Thevenin's theorem to find Vo in the circuit of the figure. Consider R=110. 3 A www 492 www 16…
A: Given here a electrical circuit and asked to find the voltage V0 by using the thevenin theorem.
Q: Using the equation: X (s)_ _1-6²³² (5+₁) 2 5² a closed-form expression for the clime-domain) output…
A: Time domain provides a picture of how a dynamic system's state evolves over time in response to a…
Q: Application of Distance Relay (Device 21) in sub-transmission and distribution lines. Also discuss…
A: The distance relays are used as a better alternative in the place of overcurrent protection relays.…
Q: You apply a potential difference of 10.55 V between the ends of a wire that is 62.98 m in length and…
A:
Q: What is the z-transform of: x(n) = 3nu(n-2)
A:
Q: . Determine the value of h(0)
A:
Q: The first column of the Routh table of a system is made by the following values: 3 € 5-€ € 31 8 This…
A:
Q: f(t) A t
A: In this case, the Laplace transform of the given function is to be determined.
Q: Given the following unit step response of a second order system, calculate the following values: 1.…
A: The above plot is the standard plot of tep response of a 2nd order system. Peak time is defined as…
Q: Define the unit step function and the shifted unit step function. Need
A: The unit step function and its shifted counterpart has been defied in the following section.
Q: For the circuit below, if the value of 0.5 V, then the value of current VCB Io Is? +1" = 5V 5ks IQ…
A: Given circuit, VCB=0.5 V
Q: Determine the velocity of electromagnetic wave in free space. I need detail calculation.
A:
Q: Establish the shifting property of Z transform.
A: In this case, the shifting property of Z transform is to be established.
Q: Consider a signal x[n] having the corresponding Fourier transform X(ejw). What would be the Fourier…
A:
Q: QUESTION 16 KVL (CLO 3): The value of Vx, in the following electric circuit equals: www 72 15V -3 V…
A: Given circuit,
Q: how to solve complex equations for impedences. How do I do the algebra for (j15.08)*10/ (j15.08+10).…
A:
Q: Draw the graphic symbol of dual 4-to-1-line multiplexers with common selection inputs and a separate…
A: The logic diagram of the dual 4-to-1-line multiplexers with common select inputs and a separate…
Q: G(s) = 1 (1+s)(1+0.5s) (1) Consider the system: Is the system controllable? Observable? (2)…
A:
Q: The boolean function F=A+A'B+C+C'B' can be minimized to be equal to OA+B+C OA+C 01 00
A: Given function, F=A+A'B+C+C'B'
Q: 2)A person of mass 50 kg stands on a weighing scale on a lift. If the lift is descending with a…
A:
Q: Design a 6-bit ripple carry adder. Experimentally find out the sum of 110011 and 111001. Construct…
A: Here, we have to design 6 bit ripple carry adder. Full adders are used for designing n-bit ripple…
Q: An induction motor has 10 poles and an electric frequency of 50 Hz. Computer the synchronous speed…
A: Given data, Number of poles P = 10 Frequency f = 50 Hz
Q: U₂ (1) C * R Op-amp vo (1) •Find vo(t) if vi(t)=In(2t)sin(2t) mV.
A:
Q: A de electrical shunt motor rated 50 kW connected to a 250 V supply is loaded as to draw 200 A when…
A:
Q: Implement the following Boolean function with a 4 × 1 multiplexer and external gates.1. (a)∗ F 1 ( A…
A: The given Boolean function can be implemented by using the truth table and by using the truth table…
Q: A JFET has r(d) = 100 kilo ohm and voltage gain of A(v) = -200. What is the value of g(m)
A: We have a JFET with, Rd = 100 KΩ AV = -200 And We have to find The Value of gm
Q: Consider the analog signal x(t) = 3 cos2000πt+5 sin 6000rt+10cos12,000ft What is the Nyquist rate…
A: Given:- Analog signal xat=3cos 2000πt+5sin 6000πt+10cos 12000πt In this que. we have to find the…
Q: E (t) = sin 2t R = 1000 L = 4H ww C = 0.01F Figure Q4: RLC circuit + Vo(t)
A:
Q: Problem 2) Determine the output time function. y(t), from the convolution integral y(t) =…
A: According to Laplace transforms
Q: V = 36 V Refer to the figure at the right. iz What is the potential of point a with respect to point…
A: The given circuit diagram is shown below:
Q: der the following signal x[n] as ibed below: = 28[n8] 3 d[n -6] + [n- 4]-38[n-2] +2.6 Use the DTFT…
A:
Q: Write a hierarchical gate-level HDL model of the multiplexer described in Problem 4.31 .
A: The 16x1 multiplexer can be implemented by using 4 select line with two 8x1 multiplexer nad one 2x1…
Q: 3 phase supply 400V V₁ IL A IN 14 Vp le C IN IN B
A:
Q: 35. What is the group of 1s present in 8 cells of a K - map called?
A: The correct option along with the explanation is provided in the following section.
Q: T/2 T VIE V +sen wot + V1 + (-1) Σ N-2 (1-N²) cos Not
A: Given: Half wave rectified signal with peak amplitude V. Fourier series of the above mentioned…
Q: Determine the THHN copper conductor size (mm^2) of the following branch current 36.5A
A:
Q: A 500 V shunt motor running at 720 rpm takes an armature current of 50 A. The equivalent armature…
A: Terminal voltage V = 500 V Initial speed of motor N1=720 rpm Speed after adding resistance, N2=540…
Q: Why is the following situation impossible? The LC circuit as shown has L = 30.0 μH and C = 50.0 μF.…
A: The energy stored in the capacitor is given by the expression as shown below: E=12CV2 The voltage…
Q: An 8-bit A/D converter-type inverter has 500 kHz clock. Find (a) maximum conversion time, (b)…
A: We have been given an 8-bit A/D Converter-type inverter with, Frequency (F) = 500 KHz = 500 * 103 Hz…
Step by step
Solved in 3 steps with 1 images
- A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
- A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow. XC=12fCC=12fXCf=12CXc Capacitance XC Frequency 38 F 60 Hz 78.8 400 Hz 250 pF 4.5 k 234 F 10 kHZ 240 50 Hz 10 F 36.8 560 nF 2 MHz 15 k 60 Hz 75 nF 560 470 pF 200 kHz 6.8 k 400 Hz 34 F 450
- Inductive Circuits Fill in all the missing values. Refer to the following formulas: XL=2fLL=XL2ff=XL2L Inductance (H) Frequency (Hz) Inductive Reactance ( ) 1.2 60 0.085 213.628 1000 4712.389 0.65 600 3.6 678.584 25 411.459 0.5 60 0.85 6408.849 20 201.062 0.45 400 4.8 2412.743 1000 40.841In a pure capacitive circuit, does the current lead or lag the voltage?You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?