(Determine the (f_x ) when force 90 N and angle 50° on the axis (Y .A 68N .B 68.94lb .C 69N .D 68.94N

Q: Differentiate material flow from energy flow. Why are these processes important? answer in more than…

A: Given question is to differentiate between material flow and energy flow. Also we have to explain…

Q: Q 13. A frame is said to be 'Perfect frame, if it followS certain relation betvoen number of members…

A: Perfect frame will not change when it is subjected to load with help of perfect number of members…

Q: Part A The disk is moving to the left such that it has an angular acceleration a = 7 rad/s and…

A:

Q: 200Kg/min superheated steam at 40 bar and 350C enters a turbine through a 7.5cm ID pipe. It exits at…

A:

Q: Q 10. The air with enthalpy of 125 k/kg is compressed by an air compressor to a pressure and…

A:

Q: 9() 4 4(1) A, h (1) valve A valve CH1%(1) One equation describing the system is O a (HI-H2)/RAQB Ob.…

A:

Q: QI) Water flowing through a jet with velocity of 30 m /s. Caleulate the value of (0) to be the water…

A:

Q: | 9(1) 4 4(0) A, h (1) valve A valve CH1%(?) One equation describing the system is O a (HI-H2)/RA-QB…

A:

Q: 3.6 Two forces, each of magnitude P, are applied to the wrench. The diameter of the steel shaft AB…

A: Diameter of the steel shaft AB, D= 15 mm Maximum allowable shear force in the shaft, τ= 120 MPa…

Q: Q 16. In a stressed body, an elementary cube of material is taken at a point with its faces…

A: Find the principal stresses.

Q: 1. A gas initially at 15 psia, 2 ft3 undergoes a process to 90 psia, 0.6 ft3; during which the…

A: Find the change in internal energy. And the value of Cp and R.

Q: Q4) Derive an equation For axial viscous flow for axial flow radius r u is the viscosity of the…

A: INTRODUCTION:                             For the viscous flow through the circular pipe, the…

Q: Calculate the reservoir volume filtered in an affinity absorption system plasma filtrate flows…

A: Given    Diameter, d = 0. 5mm      Velocity, u = 2 mL/min      Volume, V = 0.02 mg/mL Find   Volume…

Q: A rectangular plate 3 m x 2 m is immersed horizontal inside a liquid of specific gravity 1.2.…

A: Find the total pressure on the plate.

Q: A certain coal has the following ultimate analysis: Carbon = 69% Nitrogen = 5% Hydrogen = 2.5%…

A: Given: Heating value = 27280.68 kJ/kg Carbon = 69% Nitrogen = 5% Hydrogen = 2.5% Sulfur = 7%   To…

Q: en a fie plne chanm with five revolute pairs, analyse and calculate the nurmber of degrees of…

A:

Q: 3-Plot a graph of metacentric height (GM) against angle of heel. thaorctically-

A: Given question Plot the variation in metacentric height against angle of heel.         [NOTE:…

Q: In this task, various ideal gases are considered. If no other information is given, the specific gas…

A: Since we only answer up to 3 subparts so we will answer first 3. Please resubmit the question by…

Q: A logging firm in Isabela operates a diesel electric plant to supply its electrical energy…

A: Given data-Energy produced =2900kw-hr                          = 2900×3600 KJQuantity of fuel  =250…

Q: 25 mm Hg -> 0.09 m2 150 mm Water Problem 4.17 4.17. For a flowrate of 2 m'/s of air (y = 12.0 N/m')…

A:

Q: In an air-conditioning unit 3.5 m3/s air at 27°C dry-bulb temperature, 21°C wet-bulb temperature,…

A:

Q: Föllowing data is available from time study on a job: Representative time = 1 minute Rating = 125%…

A:

Q: Q 28. Consider a cylinder of diameter d and length I, then the ratio of its surface area A to volume…

A:

Q: Calculate the reservoir volume filtered in an affinity absorption system plasma filtrate flows…

A: Given    Diameter, d = 0. 5mm      Velocity, u = 2 mL/min      Volume, V = 0.02 mg/mL Find   Volume…

Q: kle joint, that shown in the figure below, is used to transmit ring the various failure cases of the…

A:

Q: A tank is filled with 2.5 kg water vapor at 150 bar and 350°C. Determine its volume (m3) using;…

A: Given data as per the question mass= 2.5 kgPressure =150 barTemperature =3500

Q: Derive the kinetic energy equations and the mass equivalents of the two-system shown.

A:

Q: the centre of percussion of uniform length suspended rod of length L' lie when measured from the top…

A: As we know that, center of percussion is where the resultant is applied causing a body to rotate…

Q: A certain coal has the following ultimate analysis:   Carbon = 69% Nitrogen = 5% Hydrogen = 2.5%…

A:

Q: If a car wheel radius of 0.25m rotates with 20revimin. then its linear velocity will be- -. 5n O 21…

A: Calculating the velocity in m/min.

Q: A wedge is used to raise a 40 kg cylindrical drum. Determine the force P necessary to initiate…

A:

Q: This is a graph for an experiment that examines the change in kinetic energy. A mass hanger of 10 g…

A: Speed is defined as the ratio of the distance covered by a person to the time in which it will…

Q: Calculate the reservoir volume filtered in an affinity absorption system plasma filtrate flows…

A: Given     Diameter, d = 0. 5mm      Velocity, u = 2 mL/min      Volume, V = 0.02 mg/mL Find   Volume…

Q: 5.10 Figure 5.25 shows a cross-section of the end of circular duct through which air (density 1.2 kg…

A: given; density of air (ρ)=1.2kg/m3velocity(V)=30m/sexerted force(F)=?pressure at A…

Q: 6.7 Compute the horizontal force P required to cause motion to impend up the plane for the 100-lb…

A: Given                     Mass, m = 100 lb                                    = 45.35 kg Coefficient…

Q: Q4/ Assuming the car has no dependence on friction with the road, determine the speed u of the car.…

A:

Q: A 5-m rod having a uniform cross-sectional area of 1000 sq. mm. is secured between two walls 5…

A: Given Data: Total length, L=5 m Cross-sectional area, A=1000 mm2

Q: The SR-71 Blackbird, which is 107 feet 5 inches long, is the world’s fastest airplane. It can fly at…

A:

Q: Calculate the density of the following pure metal. Express your answer in kg/m^3   Type of crystal…

A:

Q: A rectangular plate 3 m x 2 m is immersed horizontal inside a liquid of specific gravity 1.2.…

A:

Q: The dynamic viscosity of water is 0.001 N-s/m2. Determine the kinematic viscosity in English…

A:

Q: mine the ideal steady state yaw rate for a vehicle on a circular skid pad given the neter Value…

A:

Q: - The state of plane stress at a point is shown on the element in Figure below. Represent this state…

A:

Q: Determine the kinematic viscosity in English system. Calculate the equivalent kinematic viscosity in…

A:

Q: ( Determine the (f_R ) By using Law of cosine when ( A=8 Ib , B=6 Ib ,c = 100° .A 10 .B 11lb .c…

A:

Q: and the supporting surface. 6.11 A 90-lb block lying on a rough horizontal surface is sub- jected to…

A: Given                      Mass, m = 90 lb                                    = 40.82 kg Coefficient…

Q: 30° P 10 in. B 12 in.

A:

Q: ( Find the Resultant Force when ( R_y = 190 N .A 13.78N .B 36100N .c 190N .D 19N

A:

Q: A 1 ft3 liquid has a mass of 70 lbs. 1. Determine the density of the liquid. 2. Calculate the…

A:

Q: Part A The piston of an internal-combustion engine is connected to its connecting rod with a "wrist…

A:

Free Body Diagram

The system of forces acting on a body tends to either rotate it or make the body undergo motion. In general, when an external agent exerts a force on a body, the body undergoes translational motion and rotational motion. The body has six degrees of freedom under the influence of that force. Here, three degrees of freedom are from the translational motion while the other three are from the rotation motion. However, sometimes the bodies are not allowed to undergo any motion and are fixed, under such conditions the body is said to be constrained.