Determine the magnitude and point of application of the horizontal and vertical compenents of the hydrostatic pressure force acting on the prismatic surface a b c d e. The surface lenght (dimension perpendicular to the figure) is 4.5 m. The unit weight of water =9.81 Kn/m3

Q: Q2) ) If the vertical component of the hydrostatic force on the gate BC shown in fig.2 is 1200 kN…

A:

Q: Determine the hydrostatic force in kN acting on an isosceles triangular plate

A: Dear Student, Complete Solution Given In The Below Image ,Kindly Look Into It.

Q: Determine the hydrostatic force acting on the submerged plate (2 m long and 6 m wide) and the…

A: Given: ρ=1000 kg/m3g=9.81 m/s2l=2m b= 6 m

Q: 2. A vertical, triangular gate with water on one side is shown in Figure. Determine the total…

A: To find: The total resultant force acting on the gate and location of the center of pressure. Given:…

Q: A circular wooden log is floating in water. It has a diameter of 1.41m, length of 6.5m, and…

A:

Q: The tank in the image contains benzene and is pressurized to 350 kPa (gage) in the air gap. The tank…

A:

Q: A circular window with a radius of 0.25 m has its center 3 m below the water's surface. The window…

A:

Q: 1. In the figure shown, a vertical triangular gate submerged in a certain liquid with s.g. = 0,85.…

A: GIVEN :- A vertical triangular gate.s.g.=0.85e=150 mmρ=850 kg/m3h=2.7 mb=1.2 m SOLUTION :- here,…

Q: Q-5 The dam in Fig. is a quarter circle 50 m wide into the paper. Determine the horizontal and…

A:

Q: 5. Calculate the net hydrostatic force per unit width on the rectangular panel AB and its location…

A: Answer: ◆The net hydrostatic force per unit width on the rectangular panel AB is 28.88304 kN. ◆ It's…

Q: 4. Find the force on the following triangular submerged plate in water and location of its center of…

A: Introduction: The pressure produced by a fluid at equilibrium owing to gravity at a specific place…

Q: Determine the magnitude and direction of the total hydrostatic force on the radial gate in the…

A:

Q: 3. The gage pressure of the air in the tank shown in the figure is measured to be 65 kPa. Determine…

A: Given data Pressure measured = 65Kpa

Q: Q4/ A4-m-long curved gate is located in the side of a reservoir containing water as shown in Fig.…

A:

Q: Determine the magnitude and location of the equivalent hydrostatic force acting on the circular gate…

A:

Q: QuestionPlate AB of width =2m, supported by a cable at B and hinge at A. unit weight of water…

A: Hydrostatic force  Hydrostatic forces are the resultant force caused by the pressure loading of a…

Q: Evaluate the total force on the gate (unit width) and its direction. (specific weights of Water:…

A:

Q: b) Determine the hydrostatic force acting on the radial gate and its angle of inclination if the…

A: Given: The vertical height of the water from top to bottom of the gate, h = 15 m The length of the…

Q: Determine (a) the total hydrostatic force on the curved surface AB in the figure and (b) its line of…

A: Given: The depth of water, h = 20 m The radius of gate, R = 20 m

Q: Determine the force due to hydrostatic pressure on the flat vertical side of a tank which has the…

A:

Q: 3.89 Determine the hydrostatic force acting on the radial gate if the gate is 40 ft long (normal to…

A: Given:r=50 ftl=40 ft

Q: An isosceles triangle, base 18 ft and altitude 24 ft, is immersed vertically in oil of specific…

A: Given details: b=18 fth=24 ftX=13 ftS.G.=0.800 Formula used: h=x+h3F=γoil×A×hhcp=Icsin2(θ)Ah+h…

Q: Derive the formula used in determining experimental hydrostatic force using the center of pressure…

A: In this experiment, when the quadrant is immersed by adding water to the tank, the hydrostatic force…

Q: bläi 5 In the Fig. below is shown the * cross-section of the tank full of water under pressure. The…

A:

Q: determine the center of pressure in m of an isosceles triangle plate of base 5 m and altitude 5 m…

A:

Q: The given Figure is shown a curve surface. It is required to determine the magnitude, direction, and…

A:

Q: JA masonry dam 7 m high has a top width of 1.5 m and bottom width of 5 m. Maximum water level in the…

A:

Q: The massless, circular gate with 4 ft diameter shown in the figure below pivots about the…

A: A moment is a movement of the body when a body is rotating on an axis. The moment is also known as…

Q: .. Determine the magnitude and location of the equivalent hydrostatic force acting on the circular…

A:

Q: diagram, Calculate the center of pressure of the circular plate. (3 marks) FREE SURFACE 2.5 m h* 2 m

A: Given quantity ;  surface of rectangular plate = 3 m wide and 5 m deep  total pressure = ? position…

Q: RI R=2 m R2=3 m (water), 9. 10 m R2

A: The hydrostatic force experienced by the curved surface cab be found out in two components:…

Q: The cover is mounted on a water-filled reservoir as shown in the figure with a width of 2 meters…

A:

Q: A force Fis required to hold the hinged door as shown in figure in closed position. The door is a…

A:

Q: The quarter-circular gate of the Figure is 4 ft wide (in the direction normal to the screen/paper).…

A: Given data:- Radius, R=7ft.=2.1336m width, w=4ft.=1.2192m D=15ft.=4.572m Since, it is a curved gate…

Q: -1 = 5 m D=4 m

A:

Q: (c) A Gate AB in Fig. 1(c) is 1.2 m long and 1.0 m width. Neglecting atmospheric pressure, determine…

A: Length of gate AB = 1.2 m Width = 1 m SG of oil = 0.82

Q: 3.6 A 125-ml. cube of solid oak is held submerged by a tether as shown. Calculate the force of the…

A:

Q: Evaluate the total force on the gate (unit width) and its direction. (specific weights of Water:…

A:

Q: The massless, 4-ft-wide gate shown in the figure below pivots about the frictionless hinge O. It is…

A:

Q: Q.1: An inclined, circular gate with water on one side is shown in the figure below. Determine the…

A:

Q: A storm water drainage pipe with diameter of 800mm is carrying stormwater of density 1153 kg/m3. The…

A: Given: The density of water = 1153 kg/m^3 The diameter of drainage pipe, d = 800 mm = 0.8 m The…

Q: Determine the magnitude and point of application of the horizontal and vertical components of the…

A: force on point a will be zero due to zero height from vertical surface . now force on point b ,…

Q: The tank shown has one curved surface restraining a body of static fluid, with the following…

A: Find the value of depth of centre of gravity of curved surface from free surface(X-bar) Given data:-…

Q: Determine the resultant hydrostatic force on the 1 m square door shown in the figure below, and the…

A: absolute reading of the guage = patm = po+P mercury = 50 KPa + 13.6 *9.81*0.5 = 116.7 KPa

Q: Q2/The tank in Fig. contains benzene (s-D0.876) and is pressurized to 200 kPa (gage) in the air gap.…

A: Calculating specific weight of benzene:At (20°C)γB=p×gγB=881×9.81γB=8642.61 Nm3b=1(say)Force in…

Q: The 4-m diameter circular gate showr the figure is located in the inclined wa large reservoir…

A: GIVEN:Diameter d=4mh=10m

Q: A triangular wooden body (S=0.80) is placed in water in the position indicated in the figure. If the…

A:

Q: A circular window with a radius of 0.25 m has its center 3 m below the water's surface. The window…

A: