bläi 5 In the Fig. below is shown the * cross-section of the tank full of water under pressure. The length of the tank is 3 m. An empty cylinder lies along the length of the tank on one of its corners as shown. The horizontal component of the force acting on the curved surface ABC of :the cylinder is 2 28 kN/m A r= 1.0m ic Tank full of water - 1.5 m

bläi 5 In the Fig. below is shown the * cross-section of the tank full of water under pressure. The length of the tank is 3 m. An empty cylinder lies along the length of the tank on one of its corners as shown. The horizontal component of the force acting on the curved surface ABC of :the cylinder is 2 28 kN/m A r= 1.0m ic Tank full of water - 1.5 m

Name: 95bläi 5In the Fig. below is shown the *cross-section of the tank ful
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: 95bläi 5In the Fig. below is shown the *cross-section of the tank full ofwater under pressure. The length ofthe tank is 3 m. An empty cylinderlies along the length of the tank onone of its corners as shown. Thehorizontal component of the forceacting

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.121P: One side of the container has a 03-m square door that is hinged at its top edge. If the container is...

See similar textbooks

Similar questions

One side of the container has a 03-m square door that is hinged at its top edge. If the container is filled with water, determine the smallest force F that must be applied to the bottom edge of the door to keep it closed.
Consider a heavy car submerged in water in alake with flat bottom. The driver's side door of the car is1.1 m high and 0.9 m wide, and the top edge of the door is10 m below: the water surface Determine the net forceacting on the door ( normal to its surface) and the locationof the pressure center if : (a) the car is well-sealed and itcontains air at atmospheric pressure and (b) the car is filledwith water. (Ans:102.5 kN)
The truck carries an open rectangular container that is 3.9m wide, 3.0m deep and 5.0m long, contains oil of density 811kg/m³ to a depth of 2.1m. If it has a constant acceleration of 6.9m/s². Determine the total force(in kN) acting at the rear wall of the container.
The 100cm radius cylinder weighs 3.1 KN and rest on the bottom of a container which is 1.5 meter long. Oil and water are poured into the left and right portion of the container to the depth of 0.8m and 1.4m respectively. Find the magnitude of the horizontal and vertical components of the force which will keep the cylinder touching the container at B.
The initial pressures at A and B are the same at 103 kPa. If the pressure at the liquid at A (SG1 = 1.25) is increased to 148 kPa while keeping the pressure at B constant, determine the new position (Δh, in mm.) of the mercury meniscus inside the tube as shown. Assume no change in the liquid densities. The connecting tube is a 1-cm in diameter, Y1 = 0.51 cm, and the inclination of the tube is 18 degrees with respect to the horizontal. Assume unit weight of air to be negligible.
A gas is contained in a vertical, frictionless piston– cylinder device. The piston has a mass of 5 kg and a cross-sectional area of 35 cm2. A compressed spring above the piston exerts a force of 75 N on the piston. If the atmospheric pressure is 95 kPa, determine the pressure inside the cylinde
two vertical parallel glass plates 0.1 mm apart are partially immersed in water. Considering that the water does not reach the upper edges of the sheets and that the liquid completely wets the glass, determine: a) the height that rises in the flat capillary, b) the attractive force between the plates. Consider the width of the sheet l=12cm and density y=72.8*10^-3 N/m
Determine the absolute pressure exerted by the seawater in kPa on the body of the diver if he descends 128.44 m to a sunken ship. Assume that the density of 1,025.465 kg/m3 and the barometric pressure is 101.725 kPa.
The 280-kg, 6-m-wide rectangular gate is hinged at B and leans against the floor at A making an angle of 45° with the horizontal. The gate is to be opened from its lower edge by applying a normal force at its center. Determine the minimum force F required to open the water gate.
A tank of water 4 m deep receives a constant upwardacceleration a z . Determine ( a ) the gage pressure at the tankbottom if a z = 5 m 2 /s and ( b ) the value of a z that causes thegage pressure at the tank bottom to be 1 atm.
Pipe A contains gasoline (SG = 0.7), pipe B contains oil (SG = 0.9), and the manometer fluid is ,ercury. Determine the new differential reading if the pressure in pipe A is decreased 25 kPa, and the pressure in pipe B remains constant. The initial differential reading is 0.30 m. (Hydrostatic)
A 3-ft-diameter vertical cylindrical tank open to the atmosphere contains 1-ft-high water. The tank is now rotated about the centerline, and the water level drops at the center while it rises at the edges. Determine the angular velocity at which the bottom of the tank will first be exposed. Also determine the maximum water height at this moment.