Determine the magnitude of the horizontal reaction (N) at A if P = 291 N and Q = 1838 N. Let x = 2.45 m, y = 2.43 m, and z = 2.07 m. Round off only on the final answer expressed in 3 decimal places. Instead of units

Determine the magnitude of the horizontal reaction (N) at A if P = 291 N and Q = 1838 N. Let x = 2.45 m, y = 2.43 m, and z = 2.07 m. Round off only on the final answer expressed in 3 decimal places. Instead of units

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The 10-kg block shown In Figure (a) rests on the smooth incline. If the spring is originally…

A: Work Energy Theorem: The work-energy hypothesis clarifies the possibility that the network - the all…

Q: Find the magnitude of the resultant of the concurrent forces if 0 = 19.48° ,B = 34.85°, F = 141. 14,…

Q: Q2/A circular jet of water at 200C impinges on the vane shown in figure. The incident jet has a…

A: Velocity of jet = v = 25 m/s Diameter = d = 200 mm Vane angle = 200C

Q: Water at 20°C flows through a 300-mm-diameter pipe that discharges into the atmo- sphere as shown in…

Q: Q.3 A uniform slender rod, carying a slider at a distance b measured from point 0, is supported by a…

Q: 120 kN/m A В 80 kN/m 5 m - 3 m For the beam shown in the figure, determine the magnitude of the…

Q: Determine all the reactions on the following beam. Use DOUBLE INTEGRATION METHOD. 720 N 480 N/m 2.4m…

A: To find the reaction at support B, we will assume support B as redundant. Then we will divide the…

Q: Q3. A vertical wall (5 m long) has a fluid (sp. Gravity 0.8) on one side and another fluid (sp.…

Q: Determine the magnitude of the horizontal reaction (N) at A if P = 229 N and Q = 1966 N. Let x =…

Q: l00 kg 50kg

A: Given data:

Q: Replace the forces and couple moment system acting on the structure shown in the figure below by an…

Q: c) The engine inside the tractor as shown in Figure 4 is no longer working. You then attached a…

A: Velocity(v)=4 m/sec, Distance(s)=5 m, Kinetic friction=0.3, Tractor weight=50 kg.

Q: The spring is stretched horizontally by an applied force Fap. If a spring is stretched 12.0 cm by…

A: Given data : The value of force applied Fap=92 N The value of stretching in spring X=12 cm…

Q: P and w are 90KN and 85kN/m respectively, determine the following unknowns 1m 1m 5m 2m 2m Determine…

Q: The uniform 25 lb-f ladder in the figure below rests against the smooth wall at B, and the end A…

Q: 2. A horizontal crane boom 3.5 m. long and weighing 900N is hinged on a vertical wall on its right…

A: Given data in question Span length Point loads Rope Angles To find out reactions

Q: SITUATION 3: A homogenous ladder 10m long and weighing 3.5 kg/m leans against a vertical wall. The…

Q: A tank contains 2 m of seawater with relative density of 1.03. The tank is 2.5 m wide, 3 m long, and…

Q: A light fixture of negligible mass, has three applied forces acting on it as shown. |F,| = 4 kN %3D…

A: Given data : F1=4 kNF2=6 kNF3= 5kN

Q: L = 100 ft. A 100-ft long dam holds 30 ft of water as shown in the figure. w.s. a. Using the panel…

Q: Calculate the reactions in the given beam 15 kN 4.8m 3.4m 7.2m A В 9 kN/m Vertical Reaction on B, kN…

Q: The triangular gate shown in the figure below is hinged at the B and rests on a smooth floor at A,…

A: To Determine The vertical component of the reaction at A and the horizontal and vertical components…

Q: Through your solutions, prove that the support reactions are similar to the values shown below. Rb =…

A: Consider the figure,

Q: 11. The device shown is used for lifting 55-gallon drums. Determine the magnitude of the force…

A: \]

Q: A fluid flows downward with the rate of Q=0.015 m/s in a smooth vertical pipe with the length of l.…

A: Given Data: The rate of flow of fluid is, Q=0.015 m3/s The initial guess is, f=0.02 The density of a…

Q: A closed cylindrical tank with 0.30 m radius and 1.0 m height is fully-filled with water. The tank…

A: Given data, Radius = 0.3 m Height = 1 m Initial pressure = 15 kPa To find out the pressure at…

Q: Q3 [25 p). Water in a horizontal channel accelerates smoothly over a bump and then undergoes a…

Q: Q5. A dam which has a width of 10m (the third dimension perpendicular to figure surface) has a…

Q: Problem 2: The Block A with a mass of 300 kg and placed on the sloped plane as shown below. The…

Q: Find the magnitude of the resultant of the concurrent forces if 0 = 24.19°,B = 35.43°, F = 134.4, Q…

Q: Determine the vertical distance of the center of gravity of the curved gate from the water surface…

Q: The triangular gate shown in the figure below is hinged at the B and rests on a smooth floor at A,…

A: *Multiple questions* As per our guidelines we are supposed to answer?️ only one question. Kindly…

Q: Replace the forces and couple moment system acting on the structure shown in the figure below by an…

A: Given: As shown in diagram:point load=25kNMoment=10kNmUDL=10kN/mCalculate the…

Q: Calculate the reactions on the given beam 35 kN 18 kN/m 16 kN/m 9kN/m 1.25m 2.9m 2.5m 2.2m 9.7m A…

Q: Two identical rollers, each of weight 450 N, are supported by an inclined plane and a vertical wall…

Q: Q.4 Consider the concrete dam, whose specific weight is 2000 kg/m3 and width is 2.0m, as shown in…

A: Force exerted on surface of dam is due to amount of water stored, it acts in horizontal direction,…

Q: Two identical rollers, each of weight 450 N, are supported by an inclined plane and a vertical wall…

Q: 27, О A Bl L--x ´E D y

Q: In the beam depicted above, ?A is a fixed support. The magnitude of ?=365?/?W=365N/m, ?=60?P=60N and…

A: To analyze the given cantilever beam for support reactions and internal forces and moments. Given,…

Q: The rectangular framework shown in the next slide is subjected to the indicated non-concurrent…

Q: Determine the magnitude (N) of the horizontal component of the reaction at point A if, F=492N,…

Q: 2. If the velocity at point A in Fig. 2 i is 18 m/s, what is the pressure at point B if we neglect…

Q: The cylinder shown in Fig. (5) retains oil from one side and water from the other side. Determine…

A: Given Diameter=2m Unit weight of water=9.79kN/m3 SG of oil=0.90

Q: SITUATION. A closed cylindrical tank with 0.60 m diameter and 1.0 m height is fully-filled with…

Q: a = 3.9 m, b = 9 kN/m, c = 15 kN. b kN/m c kN DO JE 4 m 3 m 3 m FIGURE 1

Q: Calculate the force that must be created in the CD hydraulic arm in order to stop the rotating wheel…

Q: The uniform 25 lb-f ladder in the figure below rests against the smooth wall at B, and the end A…

Q: In figure shown, use left end of the beam as reference and assume the upward reaction provided by…

Q: W The 50 KN block is on top of an inclined plane shown in the figure. Determine the weight (W) of…

Q: using any Geometric Method. Consider 250 mm x 400 (b x h) mm section and E = 100,000 MPa. Enter the…

Question

Determine the magnitude of the horizontal reaction (N) at A if P = 291 N and Q = 1838 N. Let x = 2.45 m, y = 2.43 m, and z = 2.07 m. Round off only on the final answer expressed in 3 decimal places.

Instead of units, indicate the direction of the horizontal reaction at A: use R if to the right and L if to the left.