Determine the modulation factor. e. What frequencies would show up in a spectrum analysis of the modulated wave? f. Write trigonometric equations for the carrier and the modulating waves.

Q: Three point charges are located as shown in the figure. q1 =-5 x 10-12 [C] and d = 6 [cm] 42 = -4 x ...

A:

Q: The power supplied to an infinite bus system is 0.6 times of the maximum power transferred. What is ...

A: Given, Power supplied, P=0.6Pmax  

Q: 4. Compute the power dissipated by a. A 5-ohm resistor with 5-A current b. A 12-V battery with 12-A ...

A: The solution is given below 

Q: Č1 R2 15ko 10nF V1 1Vpk 30kHz 0° R1 C2 15kQ 10nF

A: The solution is given below

Q: Q4): A) Find the Equation of the line that passing in point (3,5) and parallel or perpendicular to t...

A: As per our guidelines we are supposed to be answer only the first question. Kindly repost the other ...

Q: G. In AC OPF the locational marginal price (LMP) for different buses could be different due to (a) s...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: a) Write down the characteristic equation of a semiconductor diode. b) What happens in a semiconduct...

A:

Q: For the series-parallel magnetic circuit shown in Figure 1, draw the equivalent magnetic circuit and...

A: The given circuit is shown below: ϕg=2×10-4 Wb

Q: A 75 MHz carrier having an amplitude of 50 V is modulated by a 3 kHz audio signal that has an amplit...

A: We are authorized to answer three sub-parts at a time, since you have not mentioned which part you a...

Q: Analyze the given circuit and determine the minimum and maximum input voltage that the given Zener d...

A:

Q: Whas is the circuit diagram of linear voltage regulator for fixed output voltage using IC78xx and IC...

A: Voltage regulator- Voltage regulator is a device which provide a fixed voltage as an output for fluc...

Q: 15. For the network of Fig. 9.80: a. Determine re. b. Find Ay = Vo/Vị- c. Calculate Zz. - mid

A:

Q: When a rated load with 0.8 lagging power factor is supplied, the terminal voltage of a single phase ...

A: Given, The terminal voltage of 1-phase alternator at full load, Vfl=200 V Open circuit voltage or no...

Q: R1 For the circuit shown in figure beside, select the values of R1, R2 & R3 so that: y1=0.5v, y12=-0...

A:

Q: A germanium diode draws 32 mA with the forward bias 0.27 V. If T=300 K, calculate the reverse * .sat...

A: Given, In germanium diode Diode current, ID=32 mA Forward bias voltage, VD=0.27 V Temperature, T=300...

Q: 34. In the circuit of Fig. 10.53, which is shown in the phasor (frequency) domain, I10 is determined...

A:

Q: In the circuit shown in figure (3) VI =12V,find Vs : 4 kf ww w- 2 kl 1 kl Vs 3 kl Fig. 3 6 kl? 4 k

A: Given V1=12v

Q: If 25Ω and 125A are the base impedance and base current, respectively, for a system, find the kVA an...

A:

Q: Assignment Q1: The circuit of Fig. 14 is designed to produce nearly constant current through the var...

A:

Q: Find the equation of the line if it passes through the points: (5,-1) and (3,2) Find the equation of...

A: Calculation of equation of line : When line passes through two points : A5,-1 and B3,2 . When line ...

Q: What are the advantages of an open-loop control system?

A: 1)Open loop control system simple in construction doesn't need much components like closed loop cont...

Q: /10 V 12 V 62 22 36

A:

Q: The number of the electric field lines, between two charged particles, is proportional to the amount...

A:

Q: (1 - FIT) = (1 - FIS) x (1 - FST) . true or false (1 - HT) = (1 - HI) x (1 - HS) . true or false H...

A: For the above true or false questions, the answers and explanations are discussed as mentioned below

Q: A 90MVA, 11KV water wheel generator has an inertia constant H = 3. The stored energy in the rotor at...

A: Given a water wheel generator has, MVA rating, S = 90 MVA Inertia constant, H = 3  

Q: An ac voltage of peak value 20v is connected in series with a silicon diode and load resistance of 5...

A: This question belongs to analog electronics .  It is based on the concept of analysis of silicon dio...

Q: 3) a) What is the logic function that is implemented by the gate in the below figure? b) What are th...

A:

Q: What mass of water can be heated from 25.0° C to 50.0° C by the addition of 2825 J? O 27 gm O 22 gm ...

A: Given, Initial temperature (T1) = 25.0°C Final temperature (T2) = 50.0°C Quantity of heat (Q) = 2825...

Q: Compare the results of static or dc resistance of the diodes obtained from different values of rever...

A: The characteristics of a virtual diode and a 1N4001 diode is shown in the question. The values of re...

Q: 2- Explain the effect of increasing the filter capacitance on the output voltage.

A: 2. When the capacitor size is increased then the peak current in the diode and the dc voltage will a...

Q: Q3/(a) For the cct. below find Zif for A=10,000, B=0.1 gm=40nS

A: Given,A=10,000β=0.1gm=40nS=40×10-3 This is voltage shunt feedback And for this, Zif=Zi1+Aβ ......(1)...

Q: 1. Vp, VR and Ip

A:

Q: H.W. 1 Write out the First three terms of the following infinite series: (-1)" Sin nt cosnt nt 2. n=...

A:

Q: #4) FInd IL and power acwss 6k2 veststor: IIX VI V 312K2 (3mA 3Tx LamA 4K

A:

Q: Find the average value of the voltage signal v(t), such that Vm = 4.5 V and time period T = 3.2 s. v...

A: Given, Voltage signal, Vm=4.5 VVT=3.2 s

Q: 1- In OR gate table why 1+1= 1? 2- Explain the basic logic gates, complete three and four input logi...

A: Here, which question I have to do, is not specified. So according to the policy, I will be doing onl...

Q: An alternating current of frequency 50Hz has a maximum value of 200 2A Reckoning the time from the ...

A: Given, An alternating current  Frequency, f=50 Hz Maximum current, Im=200 A  

Q: In the circuit shown in figure (3) V1 =12V ,find Vs : 4 kN 2 k. V1 1 kn Vs 4 kf2 6 kN 3 kn ww

A: Many ways to solve above problem Voltage across any element is the product of resistance and current...

Q: 15. Find the missing values in Fig. 5-35. R, = 500 N R,32 kn R, 2 kn Flg. 5-35

A: If R1 ,R2 and R3 are in parallel and Rt is the total resistance of the circuit  Then relation betwee...

Q: Q, and Qg are two charges creating an electric field. Based on the electric field lines in the figur...

A: Given: QA and QB two charges creating an electric filed. Based on the electric field lines in the gi...

Q: A 10mF capacitor has the current waveform as shown. Assuming that v(0) = 7V, sketch the voltage wave...

A: The solution is given below 

Q: Calculate the energy stored if the current flowing through a 1 nH inductor is 7 mA. (You must provid...

A: Given, Inductance L=1 nH Inductor current i=7 mA  

Q: Series Diode Configuration 5. 5. Vo and I, 1.2KQ Si IR +12 Vo Ip 2.4KQ -5V

A:

Q: VOCABULARY Match the verbs and nouns. have a film on TV make to music wash to my friends my hair bre...

A: Have break fast Wash my hair Watch a film on tv Talk to my friends

Q: 1. What quantity of electricity is carried by 6.24 x 1021 electrons?

A: Number of electrons n=6.24×1021 electrons

Q: For transfer functions, roots that are complex may give rise to: A) linearly increasing behavior B e...

A:

Q: In JDBC, what is the difference between CLOB and BLOB data types?

A: BLOB : Variable- length BLOB string that can be up to 2GB (2,147,483,647) long. Primarily intended t...

Q: (22)Use nodul analysıs to fin the power in (552) resis tor. [ 149.05 W) 15 i 252 Yu.52 125V- 8.2 55S...

A: The circuit are given as 

Q: 3. For both circuits: Determine the potential difference on and the current through each resistor. S...

A:

Q: OR Ex3/1 B. A. B. Imedule OR (ar bang} In this question, the user of the OR logic gate and the gate ...

A:

Amplitude modulation

A radio signal can carry information in the form of sound or image for broadcasting or communication. For it to be sent to a greater distance, the signal must be changed or modulated in some way. One of the easiest way is to change the amplitude of the signal with variations of the video or the audio signal. This is called Amplitude Modulaton. In this modulation information of message is carried in amplitude of carrier signal.