Determine the normal stress in each of the cables? (MPa) a. 85.7 b. 75.7 c. 65.7 d. 55.7 If the cables elongated by 1 mm, what is the vertical displacement of the precasat slab? (mm) a. 1.758 b. 1.658 c. 1.458 d. 1.558 What is the tensile force in each of the cables? (kN) a. 5.98 b. 4.98 c. 7.98 d. 6.98

Q: A 0.2 m diameter shaft is supported by a smooth journal bearing at E and a smooth thrust bearing at…

A:

Q: Check the design of the retaining wall shown below for sliding, overturning, and liftoff. Draw the…

A:

Q: A 5-m STEEL SHAFT ROTATING AT 2Hz HAS 70 KW APPLIED AT GEAR THAT IS 2m FROM THE LEFT END WHERE 20 KW…

A: Using the following formula and calculating TA, TB, TC and TD: T=P2πf TA=-2010002π×2=-1591.55…

Q: Q.4.13 *. steel cable of 8 mm diameter is stretched across two poles 50 m apart. The central dip is…

A:

Q: masonry dam has a given cross-section shown. The intensity of hydrostatic uplift varies uniformly…

A:

Q: Problem # 3: The boom AC is a 4-in square steel tube with a wall thickness of 0.25 inch. The boom is…

A: Given :- Width of the square steel boom (b) = 4 in Wall thickness (t) = 0.25 in Hollow part width of…

Q: ) Determine the moment about the base of the retaining wall. 20° 4m y = 16.5 kN/m³ 4' = 30°. 2.5 m 0…

A: Earth pressure is the pressure exerted by soil in lateral direction. It is dependent on various…

Q: A 60-kg disk supported by the rope and was rests against a rough vertical wall. The tension of the…

A: The pulling force that acts along with a rope is called tension (T). When a rope supports the weight…

Q: "Al' rod in which loading as shown, determine total axial elongation for given loading condition.…

A:

Q: The structure is worked up by El-Centro earthquake with zeta=five%. it's far required to investigate…

A:

Q: he cross section of a proposed concrete retaining wall is shown in Figure 4. The unit weight of the…

A: Retaining walls are structures that are constructed to retain earth over a vertical cut. The…

Q: Problem 2. A 145 KN fully luaded car is pulled up a surface inclined at an angle 30 degrees from the…

A: Using equilibrium equation

Q: (a) A solid shaft, 100 mm diameter, transmits 75 kW at 150 rev/min. Determine the vadue of the…

A:

Q: tural tube that has a 380-mm outer diameter and a 12-mm wall thi a time when the resultant of the…

A:

Q: A car weighing 114 kN when fully loaded is pulled slowly up a steep inclined track by a steel cable…

A: Given data in question  Load Angle Area To find out  Tensile stress Angle

Q: wo cables BC & BD are pull out the ship as shown in Fig. (6), if the diameter of each cable is 50…

A:

Q: A reinforced concrete slab 2.6 m x 2.6 m x 250 mm thick is lifted by four steel cables of equal…

A: For the reinforced concrete slab: The dimensions of slab=2.6 m*2.6 m*250 m The unit weight of RCC,…

Q: Q.6 A rigid retaining wall 19.69 ft high has a saturated backfill of soft clay soil. The properties…

A: Given: Height of retaining wall = 19.69 ft Saturated Backfill of Soft Clay Soil Saturated Unit Wt.…

Q: Q.1.11 *. steel cable of 8 mm diameter is stretched across two poles 50 m apart. The central dip is…

A:

Q: The pipe is subjected to a wind loading that increases from WA= 12 lb/ft at its base to wg = 18 | a)…

A: The given data is: Outside diameter, D=4.8 in Wall thickness, t=3/16 in Calculating the inside…

Q: Loading status in figure q= 4 kN ⁄ m, P = 48 kN in the bar dimensions L= 2 m and e= 0.5 m.…

A: The lever will induce an axial force P and a clockwise moment Pe at the point C. Using equations of…

Q: -20 kW +70 kw -20 kW -30 kW A B C D 2 m 1.5 m 1.5 m

A:

Q: 2. Three steel cable jointly support a load of 12kN. The diameter of the middle bar is 18mm and the…

A: Given, Dm = 18 mm  Ds = 12 mm

Q: Determine the active force per unit length of the wall y = 16 kN/m 6' = 30° c' 0 3 m Groundwater…

A: To find active force per unit length of wall

Q: Six steel cables support a circular moulding of diameter 2 meters. The cables are spaced equally…

A: Determine (a) Minimum diameter of each cable (b) Displacement in cable

Q: A concrete retaining wall (ye=150 lb/ft') supporting a cohesionless backfill and surcharge pressure…

A: yw=62.4lb/ft3 , yc=150 lb/ft3Pa=Active pressure=…

Q: Q.14.4 central dip is 1 m at a temperature of 20°C. Assume unit weight of steel as 78 kN/m3 and…

A:

Q: SITUATION. For the cable carrying a uniformly distributed load as shown, determine: 40 m 2 m w = 10…

A:

Q: 1.) Given the Cable as shown below that supports a 100 N/m uniformly distributed load. Determine the…

A: Given data:- Uniformly distributed load on cable, w0=100 N/m Below Cable diagram is given;

Q: The head loss in 50 m long, 12 cm diameter pipe is known to be 6 m when liquid specific gravity is…

A:

Q: For the figure shown, a 250-lb bar AB is D. supported by 4-in. diameter cable CD and pinned at B.…

A:

Q: B- Rectangular panel (4 *1) m, fixed at short edge and free at long edge, if resisting moment at…

A: In beam or panel when loading applied up to the plastic limit then the beam show mechanism a…

Q: A suspension cable passes over saddles supported by roller bearings on the top of two towers 120 m…

A:

Q: SITUATION 3 - The design base shear of the three-storey building is 450 kN. Given: Dimensions:…

A: We have to determine shear force at the roof level and natural vibration of the building and…

Q: 1.) Given the Cable as shown below that supports a 100 N/m uniformly distributed load. Determine the…

A: Given : Suspension cable with 100 N/m load 30 m length

Q: Situation X:A series of uniformly spaced hangers along a parabolic cable supports a 60 – m pipeline…

A:

Q: What is the maximum shearing stress of the beam having a thin-walled tubular (circular) section?

A: This question is related to the Strength of Material. Inthis question we write down maximum Shear…

Q: (6) For the following prismatic beam of Mp = 86 kNm () Draw possible collapse mechanism, ")…

A: Given:- MP = 86 KN

Q: Cable 60° Water Gate, 2.4m 3m Hinge. FIGURE Q2(c)

A:

Q: If the compressive force on member AD is 12 kN. Which of the following gives the neares value of…

A: Direction of 1 force and it's magnitude is given  To solve we have to resolve all forces in the X Y…

Q: reaction at B, and D? What is the shear and bending moment at distance @2m from B on the span BD?…

A:

Q: Determine the stress in member ch. A 13.33 kN (T) B) 21.33 kN (C) C) 14.17 kN (T) D) 52.00 KN (C) E)…

A:

Q: Problem 3. The ladder has a uniform weight of 80 lb and rests against the smooth wall at B. If the…

A: For a ladder of weight 80lb, if the motion of ladder restrain, then the angel of inclination with…

Q: 2. A square steel hollow channel is 18mm x 18mm and has a wall thickness of 2mm. If this size…

A:

Q: SITUATION. For the cable carrying a uniformly distributed load as shown, determine: 40 m 2 m w = 10…

A: Given Data w =10 kN/mL = 40 mh= 2 m

Q: The link acts as part of the elevator control for a small airplane. If the attached aluminum tube…

A: The given data:   The inner diameter = 25 mm   A wall thickness =5 mm   The cable forces, F=600 N

Q: Q1: The homogeneous bar ABCD shown in Fig. 1 is supported by a cable that runs from A to B around…

A: Given stress in each cable=120MPa Area of cable AB=300mm2 Area of cable C=400mm2

Q: SITUATION 1| The system below is consisting of two solid circular cross-section bars AB and BC,…

A:

Q: Arigid bar ABCD is being supported by a hinge atA and two cable CE and DE. Ameasuring gauge…

A:

Planar Stresses