Determine the PHASOR values of V1. 20/60° V Vị V2 15/0° V j42 2Ω

Q: What is the phasor voltage Vo? Express in polar form. j30 ohms + 30 / -30 deg V 202 Vo

A: In this question we need to find a voltage Vo in phasor form

Q: Determine the power and the rms value of: (a) 8(t) = C cos (wot + 0) (b) g(t) = C1 cos (wit +01) +…

A: The standard form of sinusoids are given hence the power will be the square of the RMS value of the…

Q: Using i(t)=2 sin(wt) as a reference, sketch the voltages given on single phasor diagram,…

A: The following voltages are- v(t)=10sin(wt+56∘) v(t)=7.5cos(wt+25°) the following are the phasor…

Q: For the system with v(t) = 120 sin(2wt - 30)V and i(t) = -12 cost(2wt + 70)A. Determine average…

A: Average power of a single phase circuit is P = V I cos φ Where V is the magnitude of the voltage…

Q: An AC supply voltage is represented by v = 325 Sin wt. Three loads are connected in paral and the…

A: In this question we will find circuit power factor...

Q: A non-sinusoidal voltage (e=20+15sin1000t+ 10sin3000t+5sin4000t) Volt is applied to the circuit…

A:

Q: Addition of sinusoidal signals Calculate the phase indicator net using y3(t): y1(t) + y2(t) when…

A:

Q: Compute the reactive power for -j25Ω with a voltage source, Vg = 240∠0⁰ (rms)

A: To find reactive power by -j25 ohm

Q: Convert the following to their phasor equivalent values type "cis" instead of the symbol "2" e.g.…

A:

Q: Calculate the phasor currents I and Izin the circuit of 9. ブ4ロ 12/0 V (1) sa E J60 122 Figure 9. For…

A:

Q: Q1) For the circuit shown in Figure 1 L=10 mH R=100 0 C=100 µF i. Calculate i(t) if the frequency…

A: RLC circuit A Resistor, capacitor, and inductor are connected in series between an alternating…

Q: Determine the angle by whichv1 lags i1 if v1 = 34 cos (10t + 125°) volts and i1 = 5 sin (10t - 19°)

A: Solving this question by phasor method assuming sine wave as a reference wave and you know cos…

Q: R Ziob Espqっかを Rab=11 1cr 82 20人 Rab

A:

Q: What is the phase difference between the following pairs of voltages and currents? 1. v = 10 sin…

A: Given: 1. v=10sinωt, i=5sinωt2. v=8sinωt, i=5sinωt-10°

Q: The values of the elements areR1 = 100 ohms, R2 = 12 ohms, ZL = 0+j16 ohms, ZC = 0-j20 ohms, Vg =…

A: As per the guidelines of Bartley we supposed to answer first three subpart only.

Q: Q3 (a) In Figure Q3(a), the load impedance, Zi is adjusted until it absorbs the maximum average…

A:

Q: (a) v = 7 cos(2t + 40°) V (b) i = -4 sin(10t + 10°) A %3D

A:

Q: Given the following currents: i 1 = 25 cos(wt + 30°); i 2 = -15 sin(wt – 30°); i 3 = -35cos(wt +…

A: In this question We need to Determine the equation of the resultant current using only function of…

Q: What is the phase difference between the following sets of the voltages currents And draw on the…

A: A)v=10 sin ωt+30°i=5 sin ωt+70°v=102∠30° , i=52∠70° Phase difference is=70°-30°=40°

Q: What is the phase difference between the following pairs of voltages and currents? Draw them on a…

A: 1) v = 10 cos (wt)i = 5 sin (wt)we know that sin(90+θ) = cosθso we can write v = 10 sin (wt+90)now…

Q: The unit for three phase apparent power is Select one: O a. KW O b. V O C. KVA O d. KVAR

A: The apparent power is defined as the combination of the reactive power and the true power and is…

Q: (b) For the following set of voltages, Va= 208sin(@t + 27°) V= 208sin(@t + 147°) V. = 208sin(@t –…

A: Phasor is a vector with phase Use this to analyse the given phasors As the phase continuously…

Q: A resistive and a capacitive load of equal magnitude is connected in series, determine the phase…

A: The phase difference of the circuit will be dependent on the reactance of the circuit.

Q: State which one is leading by determining the phase angle between the two sinusoids below. V1 = -10…

A:

Q: Q1 B)) Draw the following sets of voltage and current, and What is the phase difference between…

A:

Q: Q1: For the waveform of Figure below, Determine: 4v(mV) i) The peak value is mV 8. ii) The…

A:

Q: Q2 (a) Explain the generation of single phase alternating voltage. Illustrate with a diagram. (b)…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: For the circuit shown, determine the current through the 2+j5 ohms impedance. 1 jsn 252 um 2 •…

A: The detailed solution is provided below.

Q: Time left 0:51:47 Z1 Z2 V sine sine B Let Z1 = 3+j4 ohm and Z2 = 3-j4 ohm. Let the current source…

A: Brief discussion: For the given AC circuit we need to calculate the value of thevenin equivalent for…

Q: Convert the following to their phasor equivalent values type "cis" instead of the symbol "2" e.g.…

A: In this question Convert the waveform signals to phasor waveform.  a. v(t) = 100sin(1000t) V b. i(t)…

Q: QI) What is the phase diffarence between the following pairs of voltages and currents? Draw them on…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: 3. 2. Siny-ySin y

A:

Q: Q1/ Determine the voltage V, in the circuit shown below j32 j22 10V -j42 Vo

A:

Q: Problem 8: For the circuit shown below, determine the real, reactive and apparent power for each…

A: Calculate current I, I=2402∠600-2802∠300(5+8j)I=20.99∠93.02 A For element 5 ohm, S5Ω=|I|2R+j0…

Q: R = 115 ohms XL = 26 ohms Xc = 51 ohms f = 268 Hz E sine Y m C m

A:

Q: An alternating voltage is given by v1 = 75 sin( 200 Ttt -0.25 ) volts. What is the phase angle…

A: Answer :- 14.324°

Q: What is the phase difference between the following pairs of voltages and currents? Draw them on a…

A: Note :As per our guidelines we are supposed to answer only one question. Kindly repost other…

Q: Determine the phase difference between the two voltages v1= 12 sin(1000t + 60) V and v2 = -6…

A:

Q: A time varying Electric Field is given by F=20 cos (wt - 6 z) X (V/m):. The phasor representation of…

A: Given that Phasor representation of E is given is

Q: Determine the average power absorbed by R1. (answer: 8W) 为H 4H ree reeer R2 4A O RI 98 car 4t V

A: In this question,   We need to determine the power in the resistance R1  We know power in resistance…

Q: Q1. 30, 110 kV, 50 Hz, 150 km long transmissiòn ine consisting of three conductors e diameter and…

A: The correct solution can be achieved as follows.

Q: Question 4 An AC Voltage v(t) = 250 cos (100nt) is applied to the given circuit. ~ V (1) sine…

A: Brief description: For the given sinusoidal voltage function we need to derive peak, peak to peak ,…

Q: SQ j100 ww 20 wwo 60/120° V j202 15.9-16.9j -89.5+59.1j -20+87.7j None of the answers

A:

Q: A Time left 0:5 Z1 22 V sine sine B Let Z1 = 3+j4 ohm and Z2 = 3-j4 ohm. Let the current source…

A: In this question,  We need to determine the Thevenin voltage and Thevenin impedance?

Q: Ex. 1840. Given two voltage functions with phases in degrees: V1=44sin(26t+74) V2=34cos(26t+41).…

A:

Q: indicate whether the element is capacitive, inductive, or resistive v = 20 cos(250t+60°); i= -5…

A:

Q: Vab = 220 angle 20 deg. Z-delta = 20 + 10j ohms Assuming positive sequence Van A LAB Von B Isc CA…

A: The solution is given below

Q: Activity no. 27 Solve for the currents I, lz and Ia. 10 V ww ww

A: The currents are already labelled in the circuit as I1,I2 and I3. We will apply KVL law in each mesh…

Q: 24 V 2H 10 sin(t-30) V e 20 2 cos 34

A:

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).