Determine the resultant force and direction of the force system shown below. B P = 800 N A 3 m T= 600 N 6 m C/60° DI

Q: Q1/ From Fig (1) Determine: the magnitude of F1 and its direction 0 If you know that the resultant…

A:

Q: A helicopter starts from rest at point A and travels along the straight-line path with a constant…

A:

Q: Q1 -B- Draw just the Free Body Diagram of the following figures. 30 kN/m Fig. (2) -3 m- +-3m- -3m-…

A: given; draw free body diagram for given figure;

Q: 1. Assume 1 kg of steam expand isentropically from 2 MPa and 360°C to 0.040 MPa. Find: a) work for…

A:

Q: A man stands on the middle rung of a 250 N ladder resting on a smooth flo and against a wall as…

A: Given data:Weight of ladder = 250 NTension force in the string = 50 NReaction at A = 1.3 kNReaction…

Q: Q1-A- A man stands on the middle rung of a 250 N ladder resting on a smooth floor and against a wall…

A:

Q: Q2-B- Fill in the blank with the correct answer. 1. When the resultant of force system acting on a…

A:

Q: Please have a clear font f

A: When fluid enters a pipe, its velocity is usually consistent across the pipe cross-section. The…

Q: Can you please show me how to calculate the stress and strain on this figure. use this formula or…

A: For stress, σ=FA      F - applied load (known to you)                  A- effective cross section…

Q: Q5 - The three cables are used to support the 30-kg flowerpot, as shown in the Figure 9. Determine…

A: Givenm=30kg

Q: The boom OAB pivots about point O, while section AB simultaneously extends from within section OA.…

A:

Q: Q2: A two-stroke diesel engine was electrically motored (non-firing operation) when the meter…

A:

Q: بایت Boolean يمكن لنوع البيانات O(A) 2 byte O (B) 4 byte O(C) 1 byte O (D) 8 byte * .VB أي من بنية…

A: Given (1) Boolean bytes can be a data type * storage (A) 2 byte (B) 4 byte (C) 1 byte (D) 8 byte…

Q: Q4 - Two blocks A and B of weight 350 N and 600 N, respectively are connected by a cord that passes…

A:

Q: C. A 60 lb ball is dropped from a height of 48ft. What is the velocity of the ball just before…

A:

Q: The pressure tank shown is fabricated from spirally wrapped metal plates that are welded at the…

A: The largest gage pressure that can be used inside the tank if the allowable normal stress…

Q: vacuum refrigeration system consists of a large insulated flash chamber kept at low pressure by…

A: Assumptions made : 1) No heat tramsfer to the surroundings  2)pump work is neglegible  3)No effect…

Q: Eight points in the cartesian system are as follow: A(-9, 3), B(-5, 6), C(2, 2), D(5, 6), E(-2, -5),…

A: Draw position vectors:

Q: 5. The decimal number 37 is equivalent to the binary coded decimal (BCD) number: (a) 00110111 (b)…

A: This is a really useful lesson that starts with a standard programming language environment for…

Q: Q2-B- Fill in the blank with the correct answer. 1. When the resultant of force system acting on a…

A: 1. When the resultant of force system acting on a body is zero, i.e. there is no unbalanced force in…

Q: Calculate the polar moment of inertia of the following cross section about origin: Y₁ 30 mm 4 (A)…

A: Parallel Axis Theorem:- Let xc and yc be the centroidal axis and x and y are the other axis parallel…

Q: (a) Determine the reactions at A and E if P = 720 N. The reactions are positive if to the right or…

A:

Q: (3) A circular cam 8-in in diameter rotates off-center with an eccentrity e = 1” & operates the…

A:

Q: (10) A weight of 270kg falls a distance of 1.0m & strikes a coil compression spring which absorbs…

A:

Q: An ideal gas at 27°C is compressed adiabatically to 8/27 of its original volume. The rise in…

A: Given, Original temperature of the ideal gas = T1 = 27 oC = 300 K Let us consider original volume to…

Q: Slender rod LA hits block Q at end A of the rod which causes the block to move by a distance of…

A:

Q: Q2: The motion speed of the piston in one hydraulic transmission system is depend on the the inlet…

A:

Q: The steel water pipe has an inner diameter of 12 in. and wall thickness 0.25 in. If the valve A is…

A: Introduction: The tension is created by fighting the bursting effect of the imposed internal…

Q: Two plate are joint by five rivets of 20 mm diameter. What is the shear stress in the material if…

A: For solution refer below images.

Q: The hydraulic radius of a pipe with diameter of 12 mm is equal to 3 mm 6 mm 9 mm 4 mm

A: hydraulic radius is the ratio of wetted area (A) to the wetted perimeter (P). i.e. Rh=AP For…

Q: Question 1: Determine the mathematical model of the linear mechanical system shown below, given f(t)…

A:

Q: A uniform bar of mass m is pivoted at point O and supported at the ends by two springs, as shown in…

A:

Q: A hydraulic jack system is used to lift a block resting on the platform at Piston B by displacing…

A: The piston diameter at B, DB=115 mm=0.115 mLoad on piston B, MB=150 kgForce on piston A, FA=25.035…

Q: How would the last part of this problem be solved (finding the magnitude of the resultant vector in…

A:

Q: A simplified vibration measuring instrument is used to measure the vertical acceleration of…

A: Given : ω=10 r/s m=1.2 kg k=104 N/m To find : a) max acceleration b) amplitude of duct

Q: In figurer (3), the pressure at point A is P What is the absolute pressure in the closed chamber B…

A:

Q: 100N 160 150 mm 150 mm 400 N 30 60° 320 N

A:

Q: Question 2: a) What is entrance region and fully developed region? Discuss it with figures. b) What…

A: Given questions: a) What is entrance region and fully developed region? Discuss it with figures b)…

Q: 04-Two blocks A and B of weight 350 N and 600 N. respectively are connected by a cord that passes…

A: GivenWA=350NWB=600NμA=0.5μB=0.4θA=50oθB=30o

Q: Convert the following binary numbers to decimal: (a) 10101 (b) 110011 (c) 1001001 (d) 10101011.

A: This is a really useful lesson that starts with a standard programming language environment for…

Q: The thin-walled cylinder can be supported in one of two ways as shown. Determine the state of stress…

A: Calculated the state of stress in the wall of the cylinder for both cases.

Q: The net head influence to a Caplan turbine is 45m. the working fluid hits the rotor and the rotor…

A:

Q: Q2-A- Use the graphical method to find the magnitude and direction of the resultant of these forces.…

A:

Q: Consider the non-interacting tanks in the figure below. Resistances R 1 and R 2 are linear. The flow…

A: Given : To find : h

Q: Q1-A- A man stands on the middle rung of a 250 N ladder resting on a smooth floor and against a wall…

A: Given that, Weight of ladder = 250 N Tension force in the string = 50 N Reaction at A = 1.3 kN =…

Q: The flanged steel cantilever beam with riveted bracket is subjected to the couple and two forces…

A:

Q: Q4 - Determine the reactions at the supports. 500 N/m www...... B 4 m 4 m 30

A:

Q: Calculate the energy wasted (Qexhaust) from convection oven if 5000SCFM natural gas is found in the…

A: Introduction: Designers who need to carry hot fluids through pipes over a long distance must account…

Q: Q2 At a given instant, the gear has the angular motion shown. At this instant, Determine: 1- The…

A:

Q: A helicopter starts from rest at point A and travels along the straight-line path with a constant…

A: