Determine the tension P in the cable which will give the 79-lb block a steady acceleration of 4.1 ft/sec2 up the incline. Determine the tension Pin the cable which will give the 79-lb block a steady acceleration of 4.1 ft/sec? up the incline.39°19 lbHa = 0.3530Answer: PiIb

Answered: Determine the tension Pin the cable…

Determine the tension Pin the cable which will give the 79-lb block a steady acceleration of 4.1 ft/sec? up the incline. 39° 79 lb Ha = 0.35 30° Answer: P = i Ib

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.79P: The coefficient of rolling resistance between the 30-kg lawn roller and the ground is r=0.1. (a)...

See similar textbooks

Related questions

Q: (d) If the ball has the following parameters, will it make it over the wall for a home run? Let e = ...

Q: If the P-value for a one-tailed test is 0.019, then the null hypothesis would be rejected or not rej...

A: In the null hypothesis, the value of p is determined form the statistical tests which describes how ...

Q: 3. Water flows at the rate of 5 ftls through an inclined pipe. At point A, where the diameter is 12 ...

Q: R4-13. Determine the force P required to hold the 800-lb weight A by means of the system shown Figur...

Q: A 3-m long (into the paper) rectangular gate AB (dimensions in the figure: a = 0.5 m, b = 1.2 m) is ...

Q: A toy spring gun is used to shoot a 30 g marble vertically upward. The uncompressed length of the sp...

A: Disclaimer: Since you have posted multiple questions we will solve the first question for you. If yo...

Q: As water rises up to a height of 150 cm above the hinge of the rectangular gate, the gate will open ...

Q: 25 kN 20 kN 30 kN 14 -1.5 m- 3 m 3 m

Q: You want to save an amount of 100000 at the end of 10 years. you are given 8% interest compounded qu...

Q: 4. If the compression ratio is 17:1 and the piston displacement is 10 cc. Compute for piston clearan...

A: Dear student, we are suppose to solve only one question. Please post other question as a separate qu...

Q: Determine the pressure difference between the inside and outside of the 0.1 mm diameter air bublle i...

A: Diameter of the bubble, d=0.1 mm=0.1*10-3 mSurface tension, σ=0.075 N/m

Q: Express the repeating decimal as a fraction. 0.4444. . . =

A: Given decimal 0.4444..... is infinite therefore using infinite decimal to fraction technique

Q: Determine the force in member AE of the loaded truss. The force is positive if in tension, negative ...

Q: Determine the tension Pin the cable which will give the 116-lb block a steady acceleration of 6.9 ft...

A: Given:W=116 lbμ=0.31a=6.9 ft/s2

Q: Consider the following numerical data that apply to a viscously-data spring-mass system subjected to...

A: Here the steady state amplitude = F°K(1+r2) + (2∑r)2=ADAr∑<1.65 x 10-3F0=460Nr=WWhW=PWA=4 X 10313...

Q: Water surface B A

Q: 1) Consider the masses A and B with weight as shown. If the two systems are released from rest, whic...

A: Given

Q: A four-stroke, four-cylinder diesel engine running at 2000 rpm develops 60 kW. Brake thermal efficie...

A: Given data as per question N=2000 rpmcv=42 MJkgd=120mmρa=1.15 kgm3mm=0.8ηbt=30%BP=60kwLs=100 mm=2lcA...

Q: Q1: In an air-conditioning unit 3.5 m/s of air at 40 C dry-bulb temperature, 40 percent relative hum...

Q: NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to th...

Q: An air-standard Carnot cycle operates in a piston-cylinder device between temperatures of 300 and 90...

Q: BP1 A round steel beam with diameter d=1 cm and length L=1 m, supported at L/3 and 2L/3, is loaded w...

A: Draw the free-body diagram of the beam.

Q: 3. The antenna tower is supported by three cables. If the forces of these cables acting on the anten...

Q: he resultant of three forces acting on rod at

Q: The level of data measurement must be at least for a median to be meaningful. A ordinal B ratio inte...

A: There are four levels of measurement Nominal-the data can only be categorized. Ordinal- the data can...

Q: The structure is used to support a distributed load of w = 5 kN/m. The bolts at A, B, and C each hav...

Q: a- 6.1 m, b - 4.1 m, c = 14.1 kN/m, d = 24 kN. d kN d kN c kN/m BA

Q: A bucket is hanging from a horizontally moving crane. Calculate the maximum allowable speed (m/s) of...

A: Given DataL=8.8mθ=24°

Q: 4. For this series of 4 questions, two blocks, A and B, are connected using the cable and pulley sys...

Q: Given F1=155 N, F2=187 N Determine the z component of the moment of reaction at the fixed wall A (in...

Q: 33인 113 Ib Hi = 0.23 20°

Q: Yc Zw h Yw Figure 2: 2D side view of a camera in the world. This question refers to Fig. 2. (a) What...

A: Given : To find : Rotation and translation parameters of the extrinsic matrix

Q: The structure is used to support a distributed load of w = 5 kN/m. The bolts at A, B, and C ea have ...

Q: Determine the pressure difference between the inside and outside of the 0.15 mm diameter air bublle ...

A: GiveDiameter of the air bouble, d=0.15mmsurface tension σ=0.111N/m

Q: A bar having a radius equal to 0.375 inches is subjected to different torques along its span as show...

Q: 2-1/2 inch fire hose discharges water through a nozzle having a jet diameter of 1 inch. The lost hea...

Q: Two blocks A and B of the same mass 1.97 kg are released from rest on a 21° incline when they are S ...

Q: 9. A torsion tube is made from aluminium tube having an outside diameter of 60mm and a wall thicknes...

A: Given: The outside diameter of the tube, D = 60 mm The wall thickness of tube, t = 5 mm The young mo...

Q: Use Hottel's Crossed String Method to find Fij. The distance between the plane and the circle is 25 ...

A: This is the case when a planer strip is in front of a circle. so according to string method write th...

Q: The spring has a stiffness k = 50 N/m and an unstretched length of 0.3 m. It is attached to the 24-k...

Q: Water flows thiough o horizontal pipe at o veiociry of 50 f per secon d. Owing to the pipe gradually...

Q: 2) On your birthday, your friends stack two presents, A and B, on a horizontal surface. A ribbon is ...

Q: Determine the relationship which governs the velocities of the three cylinders, and state the number...

Q: For a tensile test it can be shown that the percent cold work (%CW) is related to strain according t...

Q: A bucket is hanging from a horizontally moving crane. Calculate the maximum allowable speed (m/s) of...

Q: Solve the hydrostatic force components of AB, BC, and CD using the general solution. Be sure to incl...

A: Given: The height of CD, h1 = 1 m The height of AB, 2.5 m

Q: Given the bar shown below that is made of Red Brass, what is the maximum load (kN) that can be appli...

Q: The column is subjected to an axial force of 8 kN which is applied through the centroid of the cross...

Q: The flow of water from a reservoir is controlled by an L-shaped gate hinged at point A, as shown in ...

Q: ir is at 30 °C and standard atmospheric pressure. If the gas constant is 287 J/kg-K, find the specif...

A: Given:T=30 CPatmR=287 J/Kg.K

Concept explainers

Conservation of Energy

In physics, the rule of the conservation of energy states that energy doesn’t disappear from the atmosphere; instead, it changes its form from one type to another. Energy is one of the most important physical quantities in nature, and it cannot be created or destroyed — only transformed.

Question

Determine the tension P in the cable which will give the 79-lb block a steady acceleration of 4.1 ft/sec² up the incline.

Determine the tension Pin the cable which will give the 79-lb block a steady acceleration of 4.1 ft/sec? up the incline.
39°
19 lb
Ha = 0.35
30
Answer: P
i
Ib

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The double inclined plane supports two blocks A and B, each having a weight of 7 lb as shown below. If the coefficient of kinetic friction between the blocks and the plane is 0.09, determine the acceleration of each block.
The conveyor belt delivers each 12-kg crate to the ramp at A such that the crate’s speed is vA = 2.5 m>s,directed down along the ramp. If the coefficient of kinetic friction between each crate and the ramp is mk = 0.3,determine the smallest incline u of the ramp so that the crates will slide off and fall into the cart
The 149-lb crate is carefully placed with zero velocity on the incline. What is the acceleration of the block (positive down the incline) if (a) θ = 12° and (b) θ = 18°?
*8–60. Each block has a weight of 400 lb. Determine how far the force P can compress the spring until block B slips on block A. What is P for this to occur?
If the 40kg box is moving with 1 m/s^2 acceleration to the right, determine the magnitude of normal force acting on the box, if F is 174 N. The coefficient of kinetic friction between the box and the ground is 0.3.
Determine the skier's speed when he reaches point B on the smooth slope. Also, what is the normal force on the skier's skis at BB? What is the skier's rate of increase in speed at BB?
The 4-lb collar C fits closely the smooth shaft. The spring in unstretched when s=0 and its stiffness is 6 lb/ft. AT s=0 ft, the collar is given a velocity of 19ft.s-1. The height is 0.6-ft. determine the position of the collar when its velocity is 0 ft.s-1
The conveyor belt is moving downward at 5 m/s. If the coefficient of static friction between the conveyor and the 12-kg package B is uk = 0.71, determine the shortest time the belt can stop so that the package does not slide on the belt.
The driver attempts to tow the crate using a rope that has a tensile strength of 1 kN. If the crate isoriginally at rest and has a weight of 1,3 kN, determine the greatest acceleration (m/s2) it can have if the coefficient of static friction between the crate and the road is μs=0.4, and the coefficient of kinetic friction is μk=0.3, g=10 m/s2
The conveyor belt is moving at 4 m/s. If the coefficient of static friction between the conveyor and the 10-kg package B is ms = 0.2, determine the shortest time the belt can stop so that the package does not slide on the belt.
The coefficient of static friction between the 200-kg crate and the flat bed of the truck is 0.3. Determine the shortest time for the truck to reach a speed of 60 km/h, starting from rest with constant acceleration, so that the crate does not slip.
If the 50-kg load A is hoisted by motor M so that the load has a constant velocity of 1.5 m/s, determine the force (T) of the cable connected directly on the block.