Digitizers convert analog data to digital. Explain?

Q: Calculate the total capacitance for the given CIRCUIT, the charge Q For each capacitor, and the…

A:

Q: 3.44. The equivalent capacitance of the cir- cuit shown in Fig. 3.1, will be (a) 6F (6) 8 uF (c) 10…

A: Given circuit,

Q: (4) Find the current passing through each diode and Vo. Assume ideal diodes. Κ 5ΚΩ -10V 10V 5ΚΩ Vol

A: In this question We need to determine the current in the each diode and also determine the voltage…

Q: If you knew two signals had a phase difference of 60° and expected a y max equal to 8.0 divisions,…

A: Given: 1. If you knew two signals had a phase difference of 60° and expected a y max equal to 8.0…

Q: Draw the output waveform of each circuit in Figure. Assume the RC time constant is much greater than…

A:

Q: 7.14 Calculate the time constant of the circuit in Fig. 7.94. 20 ΚΩ 10 ΚΩ ΑΛΛ ΑΛΛΑ 40 ΚΩ ΜΑΛΛ 5 mH…

A: Given:

Q: Definition of the Operational Amplifier. In which cases of circuits types it can be used. List two…

A:

Q: Definition of the Operational Amplifier. In which cases of circuits types it can be used.

A: The problem has been solved as follows

Q: Use mesh/loop analysis Given a = 2, b = 5, c = 2, d = 3, e = 4, f = 2 and x = 60, what is the phasor…

A: The given circuit diagram is shown below, Where,a=2,b=5,c=2,d=3,e=4,f=2,x=60.

Q: Detail the relationship between resistance, reactance, impedence, conductance, susceptance and…

A: We need to write about resistance, reactance, impedence, conductance, susceptance and admittance.

Q: Given a capacitor of C = 3 µF, calculate the current going through the capacitor during the interval…

A: In this question We need to determine the current in the capacitor C.  We know Current in the…

Q: Find the total transfer function using Matlab.

A: Given: A negative feedback closed loop control system as,  where,  G=1s2-3s+1, H=1, To find:…

Q: For this assignment you will be designing a power supply circuit for windshield heating element and…

A: According to the question, we need to design a power supply circuit for windshield heating element…

Q: 2. An AM signal with a 40 V modulating signal and a carrier voltage of 50 V. What is the peak…

A:

Q: An RLC-serial resonance circuit can be used as a band-pass filter. Find out how the filter works.…

A:

Q: Learning Goal: To analyze an RC circuit to determine the initial voltage across a capacitor, then to…

A:

Q: Use mesh/loop analysis Given a = 6, b = 2, c = 3, d = 11, e = 2, x = 0 and y = 0, what is the phasor…

A: Given: A circuit,  with, a=6, b=2, c=3, d=11, e=2, x=0 and y=0. To find: Phasor value of V0.

Q: 6. Given the following circuit, solve for CT. A Ст — B 2 μF 6 μF 3 μF 6 μF 6 μF 2 μF 6 μF 10 μF 46…

A:

Q: Chapter 1, problem 3. b) 101101000001012 c) 79110 - Convert the following numbers to hexadecimal

A:

Q: Determine the current i, and the voltage V, for the circuit shown below 2V, 202 5 V 452 V. (492 4Ω…

A:

Q: Consider the joint PDF: fx,y (x, y) = (1/15 0≤x≤5,0 ≤ y ≤ 3 otherwise. Find the probability that Y…

A: given here PDF and asked to find the Probability that y>ax where a=2.

Q: Three D.C. voltmeters are connected in series across a 120 V D.C. supply. The voltmeters are…

A: Given- 3 D.C Voltmeters in series- 120 V D.C supply, To Find- The voltage reading by A, B & C.

Q: The switch in the circuit shown in has been in position a for a long time. At t = 0, the switch…

A: it is asked to find Vo and io for given circuit

Q: Determine the RI voltage waveform for circuit in Figure R₁ ww 56 Ω +10 V Vin OV -10 V RL 10 ΜΩ 3V

A:

Q: Now consider the following continuous-time system with input and output specified sepa- rately,…

A: The given problem has been solved as follows

Q: In a series L-C circuit, the inductance and capacitance are 5 H and 2 μF respectively. of the…

A:

Q: The electromagnetic torque developed in a DC machine is 80 Nm for an armature current of 30 A. What…

A: It is given that: T1=80 NmIa1=30 AIa2=15 AN2=900 rpm

Q: 1. If a load resistance of 600 is placed on the output of the amplifier in the following figure,…

A: Given:

Q: Draw the bode plot for the following:

A: In this question We need to draw the bode plot.  We are solving this problem using the frequency…

Q: 6.3.4 Determine the inductance at terminals A-B in the network given. BO 1mH 4 mH 2mH m 12 mH 3 mH…

A: We need to determine equivalent inductance between terminals A and B. i.e Leq.

Q: A capacitor of capacitance ((10^-4) /m) F, an inductor of inductance (2/m) H and a resistor of…

A:

Q: lve for the current and voltages across each node using KCl and KVL equations.

A: We need to calculate node voltage and branch current.

Q: Q1: What is the value of the unknown resistor R in figure shown, if the voltage drop across the 500…

A:

Q: Draw schematics for the following circuits. Please provide an extra sheet of paper for your…

A:

Q: Calculate the V p-p  of the power outlet knowing  that V rms =120 volts

A: Given:  The RMS Voltage of the power outlet is given as 120Vrms and we need to calculate the…

Q: 5. A 3-phase 60 MVA, 13.8 kV, 3600 rpm, 60 Hz grid connected generator with a synchronous reactance…

A: Given information a three phase synchronous machine which is operated as a generator is, Rated…

Q: Design an ammeter and voltmeter that work in one switch, the current is one milliamp, the internal…

A: In this question We need to design an multimeter for measure the different different voltage.  We…

Q: What should Zy be to transfer the maximum active power from the source? Please use Thevenin method

A:

Q: Given the following circuit, find the Thevenin equivalent circuit. 5 mA 4 ΚΩ Vx 2V, -+ 2 ΚΩ 6 ΚΩ 2…

A:

Q: 22. Obtain the drop across the 1 ohm resistor in the circuit shown in Fig. P1.12 when the control…

A: It is given that: α=4ic=-1 A

Q: The electromagnetic torque developed in a DC machine is 80 Nm for an armature current of 30 A. What…

A: Solution: Given:  The electromagnetic torque developed in a DC machine is 80 Nm for an armature…

Q: For the circuit Shown below draw the DC-lord line and determine the value of R2 so that the Q-Point…

A: The given circuit is a voltage divider bias, If analyzed on an exact basis the sensitivity to…

Q: Problem 12. A current of 5 A flows in the winding of an electric motor, the resistance of the…

A: Data given in the question:   A current of 5 Ampere flows in the winding of an electric motor, the…

Q: 5. When the modulation percentage is 75, an AM transmitter produces 10 kW. How much of this was…

A: We have given the following problem When the modulation percentage is 75% an AM transmitter radiates…

Q: Given C = 0.7 mF. R₁ = 124 Ohms, R₂ = 428 Ohms, and L = 1 H in Fig. P6.38, compute the voltage…

A:

Q: A forward biased PN junction diode has the. and the condition increases _connected to the positive…

A:

Q: Mention five warning signs in the AVR system?

A: We need to tell about five warning signs in the AVR system.

Q: The signal (xt) = 100 sin(200nt) +75 cos(300mt) is sampled every 20 ms. (a) Is the sampling…

A: Given: The signal x(t)= 100sin(200nt) +75 cos(300mt) is sampled every 20 ms. (a) Is the sampling…

Q: 20.11 Obtain the state equation for the circuit shown in Fig. E20.14. Given L= 1H ; C=0.25 F ; R=59.

A: It is given that: L=1 HC=0.25 FR=5 Ω

Q: Q4 Perform a mesh analysis on the following circuit and then answer the questions below. 3 Ω -j3 Ω…

A:

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.