Instructions50 cm10 cm8.0 AR = 1.0 × 10-3 NA small circular loop of wire of radius 5 cm andresistance 1E-3 Q is centered inside a large circularloop of wire of radius 50 cm. The larger loop, whichinitially carries a current of 8 A, is cut and its currentis reduced to zero over a time interval of 1E-6 s. Ourgoal will be to find the average current in the smallerloop during this time interval. (The magnetic field ofthe larger loop is approximately constant over thesmaller loop.) Direction of B inside the smallloop as a result of the inducedcurrent:O UpO Into pageO Out-of-pageO Down

From the diagram, the direction of current in the loop is clockwise direction.

Answered: Direction of B inside the small loop as…

Science

Physics

Direction of B inside the small loop as a result of the induced current:

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter27: Current And Resistance

Section: Chapter Questions

Problem 27.65AP

See similar textbooks

Similar questions

as part of a lecture demonstration, a physics professor plans to hold an ununsulated current carrying wire in her hands. For safety sake, the potential differnece between her hands is to be no more that 1.50v. She holds her hands 1.20m apart, with the wire stretched tightly between them. The wire is to carry 6.00 A of current and is to be made of aluminum. What is the minimum wire radius that is consistent with safety? p for aluminimum = 2.75 x 10 -8 omega-m
A bird lands on a bare copper wire carrying a current of 32 A. The wire is 6 gauge, which means that itscross-sectional area is 0.13 cm2. (a) Find the difference in potentialbetween the bird’s feet, assuming they are separated by a distanceof 6.0 cm. (b) Will your answer to part (a) increase or decrease ifthe separation between the bird’s feet increases? Explain.
A current i=−40mA is flowing through the two infinitely long straight wire segments connected by a semi-circular arc, as depicted in the figure. The semi-circular arc has a radius R=18mm . Point A is equidistant from both the infinitely long straight wire segments and also very far away from the semi-circular arc. The coordinate directions are shown in the figure. Note: If the value of current given in the question is positive, then direction of current flow will be the same as depicted in the figure. For the negative value of current, the direction of current flow will be opposite to the direction shown in the figure. a) Find the magnetic field in unit vector notation at point A. (x,yx,z component) Use fig-2 image for answering b) b) Find the magnitude of magnetic field at point B. c) From Fig.2, find the magnitude of magnetic field at point C, which is very far away from point B .
27.64. Please help with the following problem. I attached a screeshot of it as well. An aluminum wire consists of the three segments shown in the following figure. The current in the top segment is 13A Part A For each of these three segments, find the current 'I'. (It should be equal to just one current, i.e. find Itop, Imid, Ibottom = ? ) Part B For each of these three segments, find the current density J. Jtop,Jmid,Jbot Part C For each of these three segments, find the electric field E. Etop,Emid,Ebot Part D For each of these three segments, find the drift velocity vd. (vd)top,(vd)mid,(vd)bot Part E For each of these three segments, find the electron current i. itop,imid,ibot
You are working with an oceanographer who is studying how the ion concentration in seawater depends on depth. She shows you the device that she uses to measure the resistivity of water from a boat. It consists of a pair of concentric metallic cylinders at the end of a cable (Fig. P26.36). Seawater flows freely between the two cylindrical shells. She makes a measurement by lowering the device into the water and applying a potential difference V between the inner and outer cylinders. This produces an outward radial current I in the seawater between the shells. She shows you the current and voltage data for the water at a particular depth and is then called away to answer a long call on her cellphone about a laboratory issue back on the mainland. As she leaves, she says, Have the resistivity of the water calculated when I get back. She forgot to show you any tables or formulas to use to determine the resistivity, so you are on your own. Quick! Find an expression for the resistivity in terms of I and V before she finishes her phone call! Figure P26.36
Integrated Concepts One long straight wire is to be held directly above another by repulsion between 1heir currents. The lower wire carries 100 A and the wire 7.50 cm above it is 10gauge (2.588 mm diameter) copper wire. (a) What current must flow in the upper wire, neglecting the Earth’s field? (b) What is the smallest current if the Earth’s 3.00105T field is parallel to the ground and is not neglected? (c) Is the supported wire in a stable or unstable equilibrium if displaced vertically? If displaced horizontally?
The human body can exhibit a wide range of resistances to current depending on the path of the current, contact area, and sweatiness of the skin. Suppose the resistance across the chest from the left hand to the right hand is 1.0 106 . (a) How much voltage is required to cause possible heart fibrillation in a man, which corresponds to 500 mA of direct current? (b) Why should rubber-soled shoes and rubber gloves be worn when working around electricity?
Draw a sketch of the situation in Figure 22.30 showing the direction of electrons carrying the current, and use RHR-l to verify the direction of the force on the wire.
In the figure below a bar of length L, width w, and thickness d is positioned a distance h underneatha long straight wire that carries a large but unknown steady current Iwire (w is small compared to h,and h is small compared to the length of the long straight wire). The material that the bar is madeof is known to have n positive mobile charge carriers (“holes”) per cubic meter, each of charge e, andthese are the only mobile charge carriers in the bar. An ammeter measures the small current I passingthrough the bar. (a) Draw connecting wires from the voltmeter to the bar, showing clearly how the ends of the con-necting wires must be positioned on the bar in order to permit determining the amount of current in the long straight wire Iwire. If the voltmeter reading ∆V is positive, does the current in thelong straight wire run to the left or to the right? Explain briefly. [2](b) If the voltmeter reading is ∆V , what is the current in the long straight wire, Iwire? Express your 4 answer for…
a)(i) What is the accuracy of a measurement of 26.5gm taken as against 25gm? (ii) State the types of resistor colour band in use and hence determine the colours of the following resistors: (i) K39±10%; (ii) M56±1%; (iii) 3K9±10%; (iv)120K±2% (v) 8R8±10%
ii, The electric current flowing in a resistor is given by I = 20 sin(100t) where I is in Amperes and t is in seconds. A, What is the maximum current? B, What is the frequency of the current? C, What is the time taken to change from zero to maximum current in each cycle?
An AC appliance cord has its live wire and neutral wire separated by 3.00 mm andcarries a 5.00 A current.a) What is the force per unit length between the wires?b) Are the forces between the two wires attractive or repulsive? Explain.c) Do appliance cords need any special design features to compensate for theseforces? Explain