Discuss the Basic concepts forces acting within embankment zone and on installed soil nails ?
Q: What are Solution Methods available in geotechnical or foundation engineering ?
A: Solution methods available in geotechnical or foundation engineering are:- Bearing Capacity…
Q: Some ground improvement methods can be used to construct “intermediate” foundations that have…
A: Answer Ground Improvement Ground improvement is the technique that is used for improving the…
Q: What are the practical reasons for requiring the soils that are placed for earth fill projects to be…
A: The compaction is nothing but a process of removal of air in the soil by means of mechanical force…
Q: Define what are bearing piles ?
A: Solution: A bearing pile is generally used to transmit the load of the building through the…
Q: What is the Embankment Loading ?
A: Solution: Embankments have a finite length with defined end angles and can be placed at any…
Q: Why does slope stabilty of the soil is dangerous in building construction?
A:
Q: Explain the Pre-loading methods for ground improvement ?
A: The load or stress from the buildings or any corresponding infrastructural projects is received or…
Q: Define the Pressuremeter Test for Settlement predictions for shallow foundations ?
A: for the new piece of the work this method is required. the mainly used method is preboring pressure…
Q: Define the Influence of Soil Compressibility on Bearing Capacity ?
A: Soil Compressibility Soil compressibility is the capacity of a soil to decrease in volume when…
Q: Define Modification Factors for Footing Depth.
A: The modification factor can be defined as, the quantitative measure which gave the degree of…
Q: Explain the Spangler and Handy (1982) Allowable Soil Pressure Chart ?
A: A chart relating SPT blowcounts, CPT tip resistance and footing width to net footing pressure was…
Q: 1- Given Data Column Footing = 3.25 ksi = 350 Kips = 250 Kips fe fy %3D %3D = 60 ksi = 2.7 ksf L %3D…
A: The compression strength means the material or structure's ability to resist loads that tend to…
Q: Define the Geotechnical strength requirements ?
A: Solution: The geotechnical properties of soils generally influence the stability of civil…
Q: Define driven piles.
A: There are two types of foundations are there: Shallow foundation Deep foundation A shallow…
Q: Define about Settlement of Foundations on Coarse-grained Soils ?
A: The settlement is the deflection at the foundation due to loading due to reduction of air voids in…
Q: Define the term Rockfill Dams.
A: Rockfill dam is defined as a kind of dam that is generally made of compacted rock fill. Rockfill dam…
Q: Define Normalized Load-Settlement Data for Small Footing Load Tests. ?
A: The normalised load settlement is used to obtain complete load settlement in sand. The normalised…
Q: Define Multiple piles
A: piles is a deep foundation. piles are used to carry vertical compressive load as well as resist…
Q: Define why is shallow bedrock condition unfavorable for open berth piers?
A: Open berths feature structures supported by piles set slightly offshore from the natural extent of…
Q: What is gap graded soil?
A: A Gap graded soil is such a soil which lacks a few sieve sizes in between the standard size…
Q: Define steel piles
A: Steel piles are a big screw, made of galvanized steel with a helical flange that not only helps to…
Q: Explain Footing Design Data from Penetration Resistance in Boreholes.
A:
Q: The following shows cross-section notes for a road grading work. х1 x2 3.5 1.2 -3.2 1.2 2.8 In…
A:
Q: Describe Modification Factors for Inclined Foundation Base.
A: Modification factor for inclined loading:
Q: Given: a square footing (BxB) shown in figure. If the allowable consolidation settlement (Sc = 25…
A:
Q: Explain the procedure developed by Hunt (1986) for determining allowable bearing pressure of…
A: Bearing Pressure : The bearing capacity of soil is the maximum average contact pressure between the…
Q: What is well graded soil?
A: Types of soil:In general, the soil is classified as “coarse grained soil” and “fine grained soil”.…
Q: Explain the Menard and Rousseau (1962) settlement method Settlement Predictions of Shallow…
A: Menard and Rousseau (1962) proposed that within a standardized homogeneous soil, the (Pressuremeter…
Q: Describe the Types of shallow spread footing foundations.
A: Footings are generally the lowermost supporting part of the structure known as sub-structure and are…
Q: find out the total area of rupture on the fault; 1011
A:
Q: Describe hydraulic fill in detail.
A: Hydraulic fill is material that is dredged from from a borrow area or borrow pit and placed at a…
Q: Give Some Comments and Considerations Concerning theGeotechnical Design of Shallow Foundations ?
A: Brief concept introduction- Whenever buildings are to be built, the first attempt is to provide a…
Q: Define the Vertical Stress Due to Embankment Loading ?
A: Solution: The vertical stresses are also called as overburden stress. The Fractures form…
Q: Combined Footing: L2 must be 1.42 m because of the location of the property line. Determine the…
A: Given:-
Q: Explain the procedure recommended by Schmertmann (1986) to estimate footing settlements ?
A: Solution: Schmertmann (1986) basically recommended the process to estimate the settlement of footing…
Q: What is open excavation and why do we need to conduct soil exploration prior to design of any in…
A: An excavation is said to be open if its width is greater than or equal to its depth. Soil…
Q: Excavations in open cuts in excess of depth shall have adequately designed shoring on support. 2.5 2…
A: To Determine At what depth of excavation in open cuts designed shoring on support is required.
Q: What is The criteria used to evaluate the vulnerability of clay-type soils to earthquake?
A: The criteria of cyclic failure is used to evaluate the vulnerability of clay-type soils to…
Q: Define when will the total settlement be completed in the case of cohesion-less soil?
A: The answer is below:
Q: Define what are displacement piles ?
A: Driven piles, also referred to as displacement piles, are a commonly-used sort of building…
Q: Discuss the assumptions made in footing design of proposed structure in geotechnical engineering and…
A: 1.Determine the dimensions of the footing plan by comparing the gross soil bearing pressure and the…
Q: Define CFM (1975) Allowable Bearing Capacity Chart Based on SPT ?
A: Canadian Foundation Engineering Manual (CFM, 1975) shows charts for allowable soil pressures…
Q: Explain the construction procedure for ground improvement by the deep soil mixing method .
A: Let’s first understand what is soil mixing: Deep Soil mixing (DSM) consists of exploitation…
Q: Define the Correction for N60 in Granular Soil ?
A: These are terms related to geotechnical engineering.
Q: Define Computing Differential Settlement of Spread Footings
A: Differential settling is a phrase used in engineering structures to describe a problem wherein the…
Q: Define the term Floating Foundations.
A: In this case, we need to define the term floating foundation.
Q: If an irrigation canal is forced to pass through a depression, what type of structure is needed?
A: There are mainly 2 types of structures Aqueduct: canal runs over the drainage . Super passage :
Q: Explain General categories of concrete-masonry dams.
A: - A concrete masonry dams are those dams which are made from concrete and masonry and can be simply…
Q: Describe about the Shallow Foundations—Design and Installation Criteria?
A: Footings are generally the lowermost supporting part of the structure known as sub structure and are…
Discuss the Basic concepts forces acting within embankment zone and on installed soil nails ?
Step by step
Solved in 2 steps with 2 images
- Explain the Menard and Rousseau (1962) settlement method Settlement Predictions of Shallow Foundations ?1A) Site investigation should form a part of a coordinated chain of design from inception of the project through preliminary to the final detailed design of a civil engineering project. Discuss the reconnaissance survey with respect to site investigations 1B) Foundation soil is that portion of ground which is subjected to additional stresses when foundation and superstructure are constructed on the ground. Discuss the purpose of bearing capacity.Discuss the assumptions made in footing design of proposed structure in geotechnical engineering and analysis.