Dissolved oxygen (D0) is influenced by which factors? Explain. How can you determine chloride content in a waste water sample

Q: Why is the Coliform and E Coli bacteria measurement is commonly used as the main microbiological…

A: E. coli is commonly used as a faecal pollution measure. It is also commonly used as a measure of…

Q: Hello can you help me solve this. Calculate the suspended solids in mg/L given the following data:…

A:

Q: Determine the ultimate BOD of a waste water sample which was subjected to the BOD determination as…

A: This question is related waster water from Environment Engineering or waste water Engineering. In…

Q: Environmental Engine... ✓ The 500mL portions analysed using the membrane filter technique produce…

A: given- 500 mL portion samplecounts of coliforms per 100 mL-350, 370, 370 and 340

Q: What are significances of pH determination?

A: Let us first understand what pH exactly is, pH is the measure of the relative amount of free…

Q: Question - In a sludge digestion tank, if the moisture content of sludge is reduced from 90% to 80%…

A: Given data- Initial moisture content p1=90%Final moisture content p2=80%To Find-The  percentage…

Q: What will be the influence of using more alkaline/acidic water in boilers? Discuss the type of…

A: (C) Introduction : Hard water, which contains minerals such as calcium and magnesium, can corrode…

Q: Solids analyses were conducted on the domestic wastewater that was tested for BOD. The tests were…

A: Total solid Total solids in water are made up of dissolved solids as well as suspended and…

Q: 100-mL water sample is mixed with 200 mL of deionized water for BOD analysis. The DO of the mixture…

A:

Q: 8. The BODS of a waste sample was found to be 160 mg/L. The initial oxygen concentration of the…

A:

Q: For a BOD analysis, 30 ml of waste with a DO of zero mg/L, is mixed with 270 ml of dilution water…

A: Biological oxygen demand is the measure of amount of oxygen required by microorganism to oxidize…

Q: During an analysis to determine the fractions of solids in 100 ml of a sample, the weights were…

A: INTRODUCTION: Total solid is the sum of dissolved and suspended solid present in sample. The…

Q: What are the two general types of hydrometers? What are their respective differences? Name and…

A: Since the given question is multiple type question therefore as per guide lines only 1 and 2 will be…

Q: Derive the equation for effluent tracer concentration from a CFSTR. Assume a step-input tracer test.…

A:

Q: The data are given as follows: Weight of evaporating dish: 53.5430 g Weight of evaporating dish and…

A:

Q: Briefly discuss the effect of alkalinity on flocculation.  What will happen to the pH and…

A: solution  alkalinity is one of the important factors of the flocculation  as we know alkalinity…

Q: Question 8 Given the following dissolved oxygen data for an aeration test with Cs = 9 mg/L, the KLa…

A: When a supersaturated solution is to be degassed or removal of gas takes place,then equation can be…

Q: Q4: Wastewater mixed with a river at a point resulting in a mixture whose characteristics are…

A:

Q: what is the Standard test method to determine biochemical oxygen demand of a given water sample…

A: INTRODUCTION: Biochemical Oxygen Demand The quantity of soluble oxygen needed by aerobic bacteria to…

Q: 21 Calculate the Liquid Limit, plastic limit and plasticity index. Results of liquid limit test 1…

A:

Q: Why it is necessary for the water samples collected during site investigation be tested for…

A: Chloride test - It is present in salt water and pure water. In excess level ,the water becomes worst…

Q: .Determine the 5-day BOD (in mg/L) for a 15 ml sample that is diluted with dilution water to a total…

A: Given a 15 ml sample that is diluted with dilution water to a total volume of 300 ml when the…

Q: a)How can you calculate BOD value? What happens if you have a higher BOD value? b)Differences…

A: Biochemical Oxygen Demond (BOD) :- Amount of oxygen required to carry decomposition of biodegradable…

Q: Determine the moisture content and density (kg/m3) of the sample from the following data: Waste…

A: To find:- Moisture content Density  Of given municipal solid waste. Moisture content = (wet weight -…

Q: A 150 g/l solution of a chemical was discharged into a stream @ 0.01 L/sec. The quantity of same…

A: stream discharge can be calculated asQ=CiQi(Cg-Cb)×5.89×10-7where Ci=injected discharge Qi=rate of…

Q: a)      How can you determine chloride content in a waste water sample? Subject: environmental…

A: Chloride, within the style of chloride (Cl–) particle, is one in every of the main inorganic anions…

Q: Flocculation is very important in dewatering process. With special reference to the standard…

A: The water treatment process is a very progressive process where to achieve clear water we follow the…

Q: Prove that poison ratio is less than(<) than half(0.5)

A: Poissions ration is less than 0.5 and proof is given below

Q: Dissolved oxygen (D0) is influenced by which factors? Explain. How can you determine chloride…

A: Dissolved oxygen: Dissolved oxygen means the amount of non compound free oxygen present liquid or…

Q: The following data were obtained in a laboratory study conducted for the determination of the…

A: Step 1

Q: Table 2 General information and results of constant head permeability test Specimen diameter (cm)…

A: To find coefficient of permeability

Q: How can you calculate BOD value? What happens if you have a higher BOD value? SUBJECT: ENVIRONMENTAL…

A: Given data in question  BOD value calculations High BOD value To be discussed  How is BOD calculated…

Q: Among finished drinking water, raw wastewater and de-ionized water, which water is expected to have…

A: Among three type of water  RAW WATER Wil contain High carbonate hardness

Q: )      What precautions should we follow when conducting experiment in Environmental lab? b) How can…

A:

Q: A BOD analysis was begun on Monday. Fifteen ml of waste with a DO of zero was mixed with 270 mL of…

A: Calculating dissolved oxygen of mix sample:

Q: Adding 20ml sample to a 300ml DO bottle causes its dissolved oxygen concentration to decrease by 10…

A:

Q: 4. What is the concentration in mg/L of TSS within a 400 mL sample containing 0.058 g of solids…

A:

Q: 2. The BOD5 of a waste sample was found to be 60 mg/L The initial oxygen concentration of the BOD…

A:

Q: In the lead content analysis of a wastewater sample, 50.00 mL of the original sample was taken and…

A:

Q: Calculate the pH and alkalinity (in mol/L) of a water that contains 120.0 mg/L of bicarbonate ion…

A: Convert carbonate and bicarbonate mg/l into OH- mg/l.

Q: PART B 1. The data are given as follows: Weight of evaporating dish: 53.5430 g Weight of evaporating…

A: given- weight of dish Wd=53.5430 gweight of dish+residue Wdr=53.5760 gweight of filter+residue…

Q: Please make presentation about this question How to determine chlorides in a water sample.?…

A:

Q: How can you determine chloride content in a waste water sample?   Note: Write the answer  in word…

A: Chloride concentrations in water must be between 1 and 100 ppm for water to be usable in nature.…

Q: Identify, from the list, below the primary purpose of each of the following wastewater treatment…

A: And 1-C  Grit chamber is used to remove descretd particles such as coffee grinds, sand,glass…

Q: Given the following dissoived oxygen data for an aeration test with Cg = 9 mg/L, the KLa value…

A: Volumetric oxygen mass transfer coefficient=KLaKLa=KL×AVwhere A=inerfacial area of mass transfer…

Q: a)What precautions should we follow when conducting experiment in Environmental lab? b)How can you…

A:

Q: Draw and fill the table below for three types of settling of particles on your paper Two important…

A: Answer The explanation consist in table followed in second step

Hydrogen Energy

Energy is a quantity that cannot be defined, its existence can only be felt. In simple language, if a system possesses energy, it can do a specific kind of work. There are many forms of energy sources which people can use to obtain work. Solar energy, tidal energy, hydroelectric energy, geothermal energy, wind energy are some of the renewable energy sources which are primarily used for the production of electricity.