dont post from internet will downvote answer only has accurate knowledge A TCP segment consisting of 1500 bits of data and 160 bits of header is sent to the IP layer, which appends another 160 bits of header. This is then transmitted through two networks, each of which uses a 24-bit packet header. The destination network has a maximum packet size of 800 bits. How many bits, including headers, are delivered to the network layer protocol at the destination?

Q: With Network Address Translation, a router changes a private IP address in the IP header to the…

A: Translation of Network Addresses (NAT): When visiting the Website, we'll need one gateway, and then…

Q: How does TCP/IP protocol deal with problems such as out of order delivery, lost packets, duplicate…

A: This is how  TCP/IP protocol deals with problems: TCP/IP has a unique characteristic. According to…

Q: Explain in detail step by step specifying protocols what happens when a PC at 137.168.35.6 tries to…

A: In the Internet Protocol (IP), computers split messages into packets and those packets hop from…

Q: P protocol? Describe some circumstances where it might be desirable to use source routing rather…

A: Below the header overhead in the IP protocol

Q: Assuming standard 1500 byte Ethernet max payloads:  how many IPv4 fragments will be needed to…

A: Ethernet Max Payloads = 1500 bytes IP4 Fragments = 2 IPV4 fragments will be needed to transfer 2000…

Q: Pv4 and IPv6 are two different protocols. Hence, the packet structures are unidentical. Some of the…

A: IPv4 and IPv6 are two different protocols. Hence, the packet structures are unidentical. Some of the…

Q: we obtain the following information from one router. What kind of routing protocol does it use?…

A: Here use ony Routing information protocol. we can use it wiht local area network for small ranges.…

Q: The TCP/IP model has one layer, application, that covers OSI layers 5-7.  Why is this appropriate

A: Background Information   A practical use of the OSI Model is the TCP/IP Model. Despite the fact that…

Q: Assume that Computer A, which is connected through an Ethernet cable to the Switch S1, is just…

A: All the protocols which came into play with reference to TCP model layers are given below. We used…

Q: Please use YOUR OWN MODEL -- not somebody else's. Using TCP/IP model: Create all parts of a IPv4…

A: 1. Preface It is a 7 byte field that contains an example of exchanging 0's and 1's.It alarms the…

Q: TCP protocol diagram

A: A TCP protocol diagram to describe the whole procedure is given below.

Q: 450005dc 1e244000 8006... is a piece of information in an IP datagram header (in hexadecimal) How…

A: This packet can travel to one more router because the time-to-live (TTL) value is 1

Q: Layer

A: Answer:- Unlike POP, IMAP keeps your messages on the server, therefore when you click to read an…

Q: What are the names of the TCP/IP layers? Describe all of the layers (Must be in proper order)

A: TCP/IP:  Its full form is Transmission Control Protocol/Internet Protocol and it is a collection of…

Q: With Network Address Translation, a router changes a private IP address in the IP header to the…

A: Option : Destination Port Checksum Length

Q: A TCP segment consisting of 1500bits of data and 160bits of header is sent to the IP layer, which…

A: The answer is..

Q: I'm really stuck on this question. Which protocol uses TCP as its transport layer protocol? a. SNMP…

A: File Transfer Protocol (FTP), Trivial FTP (TFTP) are all Application layer protocols.

Q: Assume that there are four routers (R1, R2, R3, and R4) and four hosts (H1, H2, H3, and H4) in a…

A: Actually, packet is a small data element sent over a network.

Q: Delivery of a packet to a host or router requires two levels of addresses. Name them ii. State four…

A: (i).Delivery of a packet to a host or router requires two levels of addresses. Name them (ii). State…

Q: What happens to the MAC addresses of packets when they move from one network to another is a…

A: ans is given below:

Q: 3. An unencrypted DNS response packet captured by Wireshark on a DNS client has 3 protocol headers…

A: Given that An unencrypted DNS response packet captured by wireshark on a DNS client packet has 3…

Q: Given a network 100.20.128.0/18, design 4 subnets of 100 computers and 4 subnets of two usable IP…

A: Given network is: 100.20.128.0/18 IP Address/Subnetting: NETWORK: 100.20.128.0/25 SUBNET MASK:…

Q: For the network in Figure 2, show the number of steps which are needed to send a packet from PC1 to…

A: The Answer is in Below Steps

Q: A 3200 bit long TCP message is transmitted to the IP layer and becomes a datagram after adding a 160…

A: The packet size is 3200 bits The IP header length is 160 bits LANs datagram payload size is 1200…

Q: IP hosts that are not designated routers are required to drop packets misaddressed to them, even if…

A: A would be inudated with the multiple copies the packets if the same host address is arrived at a…

Q: nged the exam(s) in 2013, CCNA students had to study 3 different routing protocols whic

A: Introduction: Below describe the Cisco changed the exam(s) in 2013, CCNA students had to study 3…

Q: Q3: If a routing table of a router is depicted by the following table, what is the next hop for a…

A: A routing table is provided for the information.

Q: Match the following to one or more layers of the TCP/IP protocol suite: a. route determination b.…

A: A TCP/IP model is a five-layer model for networking. 1) Application Layer 2) Transport Layer 3)…

Q: Consider the following IP address and subnet mask. 131.0.10.11 255.255.128.0  What is the Network ID…

A: Network ID- 131.0. Broadcast ID-131.0.10.255 Number of Bits- 255-11= 244

Q: In your own words, describe what happens at every step of our network model, when a node on one…

A:

Q: For the network in Figure 2, show the number of steps which are needed to send a packet from PC1 to…

A: The Answer is in Below steps

Q: A TCP message consisting of 2100 bytes is passed to IP for delivery across two networks. The first…

A: In the question given: Payload refers to the actual data in the IP packet. Excluding network…

Q: In this Question, you have been given the network address 13.0.0.0/8 to subnet and provid the IP…

A: Network Address Block Subnet Mask 255.0.0.0/8 255.128.0.0/9 255.192.0.0/10 255.224.0.0/11…

Q: FTP requires confirmation that a file was successfully transmitted to a client, but it has no…

A: The transmission control protocol (TCP) of the transport layer ensures that the delivery of the file…

Q: 2. How can we determine if an IPV4 packet is carrying an ICMP packet? 3. A router receives an IPV4…

A: Note : As per guidelines of the company, we are authorized to answer very 1st question. Thus repost…

Q: One line answer: Q. Which layers does TCP/IP model does not have but OSI model have them.

A: Given question is asking for layers in tcp model.

Q: Q3: If a routing table of a router is depicted by the following table, what is the next hop for a…

A: In the given problem, we are going to depict the next hop for the given IP address.

Q: 4. In one of the pairs of protocols given below, both the protocols can use multiple TCP connections…

A: Correct answer is #1.   HTTP: is a request-response protocol used for transporting information…

Q: An ISP has the following block of addresses 132.204.192/20. The manager of this ISP hired you to…

A: The answer is

Q: . How can we determine if an IPv4 packet is carrying an ICMP packet?

A: Actually, IP stands for Internet Protocol.

Q: Which TCP/IP protocol, which handles and assures the delivery of packets, provides this guarantee?…

A: In Internet for interconnecting network devices TCP/IP protocol are used.

Q: Q5: If Host A in the following network used MTU discovery protocol to send packets to Host B, what…

A: A maximum transmission unit (MTU) is the biggest bundle or casing size, indicated in octets…

Q: Question 1: True or False: [      ] Telephone network is an example of Packet Switching network. […

A: Note: - As per the guidelines we can only answer a maximum of three subparts. Please resubmit the…

Q: yer    C) Application layer    D) Internet layer   Answer: iv) How many bits are used in the IP…

A: 1) Internet layer is for routing packets in TCP/IP architecture. Hence answer is d) 2)Internet…

Q: A router is blasting out IP packets whose total length (data plus header) is 1024 bytes. Assuming…

A: Actually, IP stands for Internet Protocol.

Q: A 3200 bit long TCP message is transmitted to the IP layer and becomes a datagram after adding a 160…

A: If the Maximum Transferrable unit(MTU) of a router is less than the size of data then the datagram…

Network Protocols

A network protocol is a set of rules that govern how data is exchanged between the devices in a network. Network protocols enable communication between devices that are located in different parts of the world. Consequently, they are critical in today's digital communications.