Draw a plc ladder diagram for blinking lights with timer (1 second interval), start and stop button

Q: A si diode has reverse saturation current of 2.5 micro amp at 300k find forward voltage for a forwar...

A: The equation of current and voltage in forward biad condition is given as: ID=I0eVηVT The value of d...

Q: A shunt motor has a nameplate rating of 140 hp, 500 V, 205 A, 1700 rpm. The shunt field circuit resi...

A:

Q: 6. R=_kQ |= 4 mA E = 6 V

A: This can be solved by using KIRCHOFFS voltage law Here current is flowing from load to source So loa...

Q: An AM transmitter has a carrier power of 100W at a frequency of 3 MHz. It is modulated at 75% by a 1...

A:

Q: Find the Thévenin equivalent circuit and determine the maximum power transfer to a load between the ...

A: The given circuit is shown below:

Q: A single phase inductive load takes 50 kVA at 0.60 power factor lagging. Solve for the kVAR of a cap...

A:

Q: 1: On a 460-volt supply, a DC Shunt motor operates at 10 rps when drawing a line current of 30A. Its...

A:

Q: What are different types of rotors used in an alternator?

A: There are mainly two types of rotors used in alternators: Cylindrical rotor type. Salient pole roto...

Q: 5. Determine the output waveform of the network for the input indicated (USE 1ST APPROXIMATION) * 1u...

A: The solution is given below

Q: What do you mean by manometric efficiency, mechanical cy and overall efficiency of centrifugal pump ...

A: Manometric efficiency: The ratio of the manometric head to the head imparted by the impeller to wate...

Q: Vcc Vec = 20V R1- 40 kohm R2- 10 kohm Rc -4 kohm RE-2 kohm Rs=1 kohm RL = 22 kohm Cs- 10 uF Ce-1 uF ...

A: We need to find voltage gain for given circuit

Q: A balanced 3 phase load draws 75 amperes line current at 230 volts line to line and 0.848 lagging po...

A: In this question, A balanced 3 phase load draws 75 amperes line current V=230 volts line to line  Po...

Q: Class Example 2 The capacitor in the circuit shown is initially uncharged. a) Immediately after the ...

A:

Q: Explain the difference between transformer equivalent circuit and IM equivalent circuit.

A: Equivalent circuit- An equivalent circuit is a simplified circuit (or model) that is easier to analy...

Q: Suppose that the signals x[n], x2[n] and x,[n] are given by 2mn and rfn] ='c2=nu20 ). 2mn xi[n] = co...

A:

Q: Calculate the percent power saved (%) in an amplitude modulated wave when it is transmitted with 45%...

A:

Q: [50 cos (600t + 30°) + 100cos(600t - 45°)] V. Apply the 4. Find the phasor of the v(t) voltage to th...

A:

Q: Using a Bessel table, determine the minimum bandwidth for the same FSK signal described in Example 2...

A:

Q: 15.8 a) Use the circuit in Fig. 15.4 to design a high-pass filter with a cutoff frequency of 2.5 kHz...

A: For ideal operational amplifier ,non inverting voltage (V+) is equal to inverting  voltage (V-).but ...

Q: Discuss about generator modeling and drive the formula for the real and reactive power supply it .

A: Generator modeling -  The simplest sophisticated modeling in a system stability tool are generator m...

Q: 3. R=__Q 1=12 mA E= 12 V

A:

Q: Determine the source voltage and write the answer in polar form.

A:

Q: 3. In the phase shift oscillator shown in Fig. 3, R1 = R2 = R3 = 1MQ and C1 = C2 = C3 = 68 pF. At wh...

A: To calculate frequency of oscillation

Q: A circuit has a 120-V 60-Hz source connected to a 100-0 resistance and a 100-0 inductive reactance i...

A:

Q: 4) How much energy does a 5mF capacitor connected to a 3v battery store? A)67.5 mJ B)7.5 mJ C)22.5 m...

A:

Q: Resistor 10k Diode 1N914 VAC SINE(0 20 10 0 0 0 40) Vdc + 5v

A:

Q: 1. Compute the Band Width and Power of AM-SSB?

A:

Q: 2. Design a 3-bit ALU which can perform 5 micro-operations - AND, NAND, OR, NOR, and XOR. Do provide...

A:

Q: Use Kirchhoff’s Laws to find the branch currents indicated in the following network:

A: Answer is as follows-

Q: K Q3: For the unity feedback system with G(s)= (s+3)(s² +4s+5) Do the following: a). Find the locati...

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts f...

Q: At the upper critical frequency, the peak output voltage of a certain amplifier is 10 V. The peak vo...

A: The solution is given below 

Q: A LPF has cutoff frequency of we = 100 rad/s. The filter is repeated three times. Find the new cutof...

A: Given: A LPF has a cutoff frequency of ωc = 100 rad /sec The filter is repeated 3 times. To find: Fi...

Q: Find the thevenin and Norton equivalent circuit of the following network. Please show complete solut...

A:

Q: 2. To what type of circuit does a differential amplifier correspond?

A: Differential amplifier is circuit which gives the output voltage corresponding to difference in the ...

Q: a 212 V,079 22 I3 -j10 b 12 j20 V,07- I2 I5 e ll

A:

Q: A capacitor has a charge of 20.5 C when connected with a 24V battery. Determine the capacitance.

A:

Q: Voice information with a frequency range of 0.3 - 4 kHz is sampled according to Nyquist requirements...

A: It is given that: fm=0.3~4 kHzL=256 levelsn=log2256=8 bitsd=0.5M=16

Q: Explain the Wiring Diagram of Direct On Line Starter

A: WIRING DIAGRAM OF DIRECT ON LINE (DOL) STARTER: 1. A DOL starter is the most common way to start a t...

Q: A single phase wattmeter is used to determine the power taken by a three phase squirrel cage inducti...

A: In this question,  We need to determine the line current drawn by the motor. If Line to line voltage...

Q: sequence components o

A: For PU system- PU value=Actual value/Base value

Q: 20 V ... 2:1 ideal diodes C = 10 uF + RL= 10 kohms 20 V fin = 60 Hz Power-supply filter Given the in...

A: Option c 5V is the answer Because Transformer reduced the voltage level by factor of 2  So the ampli...

Q: In the experiment (Differential amplifier) answer the following: Theoretical Calculations: 1. When i...

A: Solve the problem

Q: In the figure, E1 + E2 + E3 + E4 is equal to E, = 9 V Es = 20 V Ez = 24 V E = 6 V

A:

Q: The power input to a 3 – phase induction motor is 40 kW. The stator losses total 1 kW and the fricti...

A:

Q: Phase modulator has a carrier signal of ec = (√34) cos 2π(735x103)t and phase deviation constant of ...

A: We need to find message signal amplitude for phase modulation

Q: 1. Given, C(s)/R(s) = 25/ s2+10s+25. Derive the time response of system when excited with step input...

A:

Q: Hey, please reply as soon as posible. Please read what is asked. PLEASE SEE THE CIRCUIT. SINCE PREVI...

A:

Q: Problem 2 Draw the waveform of vo of the op-amp circuit shown for the given waveform of vi. Label al...

A:

Q: :1 Which of the following is a disadvantage in contact mode scanning? O Very poor resolution of scan...

A: In contact mode scanning, the lateral force exerted on tha sample can be quite high, it will leads t...

Q: Find the Fourier approximation of the specified order of the function on the interval [0, 27]. f(x) ...

A: Given function        f(x) = e^-x in the interval  [0 2pi] Find  Fourier Series approximation of f(x...

Latches and Flip Flop

Just like logic gates, the latches and flip-flops are the important elements of an electronic circuit. The logic gates form the important part of combinatorial circuits, while the latches and flip-flops form the essential part of a sequential circuit. Sequential circuits form the important concept of automata theory in electronics and electrical engineering, these circuits are a kind of logic circuit whose output depends on both present input and past inputs, that is, the input history.