Draw the diagram representing the cooling arrangement part of the modern steam power stations
Q: Why do you learn and study the effectiveness of Electricity Distribution Systems?
A: Why do you learn and study the effectiveness of Electricity Distribution Systems?
Q: How hydropower water turbine is essential in dry season
A: Given We need to elaborate on the importance of hydropower in dry season. Please find the answer…
Q: WHat is shunt reactor and its use in the power system. Explain in short.
A: The inductive current element is considered as the shunt reactor and it is connected in between the…
Q: Introduction about fuel supply system
A: Different energy sources are required in day to day life. These energy sources can be renewable or…
Q: Airframe Electrical System Question: Name four wire types. (Source: FAA AC 43.13-1B/2B)
A: Four types of wire:Two or more separately insulated conductors in the same jacket.Two or more…
Q: Explain with neat sketch the operation of regulated DC power supply.
A: A fluctuating DC voltage supply may result in an unsuitable operation of electronic devices and…
Q: B// Explain the important functions of the condenser in a thermal power station.
A: Important of condenser 1. The condenser creates the vacuum required for steam to exit the turbine…
Q: How can we prevent and control house fires accident caused by electricity?
A: The house fires take place accidentally, and can start suddenly and spread rapidly. Which may cause…
Q: True or False? - Efficiency and capacity factor of an electric power generator depend on how it is…
A: It is true that the efficiency and capacity factor of an electric power generator depend on how it…
Q: Explain the advantages and disadvantages of hydroelectric power plants.
A:
Q: What
A: In this question, we have given a circuit and we have to find out power delivered by 120 V source..
Q: Describe the standard operating procedure (SOP) for Power Supply. including precautions too. Thank…
A: The standard operating procedures for the power supply are listed below: 1- Before the power supply…
Q: what is the importance of identifying the uses of electricity in farm operations and safety…
A: The power system has to transmit power from the generation side to the load side. For this purpose,…
Q: A) Explain with a neat sketch the process of solar cooling?
A: Solar Cooling- The solar cooling system is used for refrigeration and air conditioning with the help…
Q: 12.a. An electrical device would also fall into the classification of an electric(al) A. motor. B.…
A: Answer 12.a. An electrical device would also fall into the classification of an electrical motor. An…
Q: Electric Powers System for Nonelectrical Professional can you describe effective preventive…
A: Electrical Preventive Maintenance (EPM) is the act of leading routine assessments, tests, and the…
Q: Explain the advantage of having high power factor in a supply system.
A: As High power is power is better than low power factor considering the consumer as well as the
Q: An electric power system
A: An electric power system is basically a network of different electrical component which helps in…
Q: Draw and explain block diagram of Thermal power plant and write few advantages and disadvantages?
A:
Q: Draw a schematic diagram of a hydro-electric power station?
A: The parts of hydroelectric power plant is described below. Reservoir:-The reservoir is the part of…
Q: List out all the major components in a thermal power plant
A: The thermal power plant is used to produce electricity by utilizing the energy of the burning fuel.
Q: EXPLAIN BRIEFLY THE IMPORTANT PARTS OF GENERATING STATION THAT PRODUCES ELECTRICAL ENERGY?
A: Individual plant items, equipment, and mechanical and electrical engineering systems make up power…
Q: Q1)Linear power supplies are less efficient than switch-mode power supplies. True or False?
A: To determine whether the linear or switch mode power supply we will first determine the problem and…
Q: Thyristor switched reactor(TSR) for power factor improvement?(150words)
A:
Q: the gas supply pressure to the burner is lowered and maintained at a low pressure by the? 1- air…
A: Gas supply pressure:- it's control the pressure of boiler and furnace. Which device is used to the…
Q: Write the purpose of tail race and valve house of the hydro power plants.
A: A Hydropower plant is usually constructed near rivers and places where there is ample water It…
Q: Consider hydro-electric, thermo electric, and nuclear electric generating methods. Explain one (1)…
A: In this question we discuss about advantages and disadvantage of hydro-electric, thermo electric,…
Q: The evaporator in a commercial installation normally consists of a? Coil, through which the building…
A:
Q: remedies
A:
Q: For a star connection network, consuming power of 1.8kW and power factor 0.5, compute the inductance…
A: In a three phase system there are two ways to connect a three phase load. Star/Wye Connection Delta…
Q: Explain briefly the methods available to improve thermal efficiency of gas turbine plant.
A: The methods which can be used to improve the thermal efficiency of gas turbine plant are as follows:…
Q: Draw the flowchart for Fast decoupled method of power flow studies
A:
Q: Airframe Electrical System Question: In general, describe and draw the construction of shielded…
A: Three phase solid phase insulated cables are classified into two types.Belted type electrical cable…
Q: electrical machines Explain how the experiment is done by drawing the connection diagram of the…
A: Explain how the experiment is done by drawing the connection diagram of the alternator idle test.…
Q: What is the importance of the power distribution system in the country?
A: Power distribution is very essential for any country as power generation is done in bulk always but…
Q: Which of these is a floating power source?
A:
Q: List any two merits and demerits of hydroelectric power plant.
A: Need to find merits and demerits of hydro power plant
Q: block diagram of the electromechanical energy conversion of a power tool
A:
Q: 1- In a table compare between diesel power plants & gas power plants. 2- Give any five comparisons…
A:
Q: A nuclear powerplant is rated 1200 MW. It was operating at a base load plant for 150 days in a year…
A: Nuclear powerplant is rated 1200 MW It was operating at a base load plant for 150 days in a year…
Q: Explain the idea of turning on and off the nuclear reactor of the power station.
A: In a nuclear reactor, energy is created and released by splitting atoms of specific elements. The…
Q: In the distribution transformer; In the transformer used for the distribution of electricity to the…
A: Distribution transformer step down the voltage incoming to distribution transformer =3.3 kV The…
Q: Explain the important functions of the condenser in a thermal power station.
A: Condenser is a part of regenerative feed heating system. It is also called as condensate recovery…
Q: Which of the Following Biogas Plant will maintain constant pressure inside the Digester Tank? a.…
A:
Q: Explain why hydroelectric power plant (HEP) is more prefereble than coal fired generation plant?
A: There are following reason to prefer hydroelectric power plant then coal fired generation plant.
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 2 images
- 1. What are the benefits of flue gases in thermal station?2. How can increase the voltage crosses the solar cells?3. List the main elements of the wind - electric conversion systemDiscuss the importance of electrical grid stability and the measures taken to ensure a reliable power supply.q1: Discussion of power quality aspects that need to be considered before installing the power factor correction unit
- What will be the voltage drop and regulation in resistive, inductive, capacitive load with the no-end voltage of the alternator? Please explain. % Rg = (Ea-Ut) / Ut (% Rg: Percentage voltage regulation, Ea: Alternator free end voltage, Ut: Alternator full load end voltage) (Note:I would be glad if it was written by computer.)Question No. 12: a.) Explain the Gas turbine power plant with neat sketch. b.) Draw and explain the layout of Diesel power plant.Define power quality and describe the factors that can affect it in a power distribution system.
- A nuclear powerplant is rated 1200 MW. It was operating at a base load plant for 150 days in a year with a fixed load of 1110 MW and 150 days with a fixed load of 1050 MW. The plant was in a maintenance shut down for a period of 65 days within that one year period of 365 days. Calculate the Load Factor of the powerplant for the year.What will be the voltage drop and regulation in resistive, inductive, capacitive load with the no-end voltage of the alternator? Please explain. % Rg = (Ea-Ut) / Ut (% Rg: Percentage voltage regulation, Ea: Alternator free end voltage, Ut: Alternator full load end voltage)Discuss the concept of load shedding and its purpose in a power system.