Draw the typical lightning impulse voltage wave shape and label. Draw the simplified circuit of Impulse voltage generator?

Q: D13.10 Specify the minimum width, a, and the maximum height, b, of an air-filled rectangular guide…

A: We need to find out the value of a and b for given mode .

Q: = etermine the divergence of the vector A yxa₂ + zyay+zza, at (6.5.5). div(A) =

A: We need to find out divergence of given vector

Q: The torque curve presented here is most representative of: Engine Power and Torque Curves 280 Power…

A: The Electric motors are categorized into two types on the basis of their supply potential : DC…

Q: D13.9 A TE mode in a parallel-plate guide is observed to have three maxima in its electric field…

A: We need to find out the propagation mode .

Q: For the same voltage and current produced by a three phase and single phase source, the power…

A: In this question,  We need to choose the correct options Choose the given Statment is true or false?…

Q: 2. Solve for the line currents, phase currents and the total complex power absorbs by the loads.

A: It is given that:

Q: Q2: Design a basic RC band stop filter with a lower cut-off frequency of 200Hz and a higher cut- off…

A: We need to design band stop filter

Q: B. solve the following equation using Laplace transformation y' + y = sin(t) y (0) = 1 t

A:

Q: Q1. Choose the correct answer (Answer any TEN): 1. The convolution of two signals in time domain is…

A: In this question we will write about convolution and pulse modulation... Note :- as per our…

Q: Determine the transmittance of the given signal flow graphs. 1 3 R(s) X₁(s) 2 -6 15 -10 √X₁(s) -24 3…

A: This problem can be done by using mason's gain formula

Q: Find the average power absorbed by the resistor R R-900

A:

Q: An AC circuit with a resistor and an inductor had an impedance of 100Ω at 50 Hz and an impedance of…

A: We need to find out the value of resistance and inductor for given circuit

Q: 511 Find the Norton's equivalent Circuit for the network to the resistor R of the networks 100 wwis

A:

Q: Find the value of R₁, in circuit given below for which maximum power is to be delivered at load 300…

A: Given circuit,

Q: For the unity feedback system shown below ,answer the following questions: R(s) + E(s) C(s) G(s)…

A:

Q: "If Ibc is equal to 659.9112271 and la is 381 angle;1, the phase sequence is:" O POSITIVE O NEGATIVE

A: Phase sequence :The order in which each phase attain a positive peak is called phase sequence.…

Q: For the ideal op-amp shown, what should be the value of resistor Rf (in kilo Ohms) to obtain a gain…

A:

Q: With a differential gain of 51,817 and a common-mode gain of 2, what is the common-mode rejection…

A:

Q: B)- Draw a neat diagram to show the armature diverter method for speed control DC series motors

A:

Q: Determine the z-component of the unit vector of F= 2.2a + 3.1ay O a. 0.31 Ob. 0.44 O c.0.58 O d.…

A:

Q: Solve the following problem using Kirchhoff's Rule. Show the equivalent circuit when solving for the…

A: Brief description: For the above given question we need to calculate the value of current flowing in…

Q: P511 find the vorton's equivalent Circuit for the network to the resistor R of the networks of Fig 2…

A: In this question,  We need to determine the Norton equivalent circuit across the terminal resistance…

Q: 3) Solve the meshes and order the matrix of the following way: Then, what is the value of B, C and…

A: The required parameters can be calculated by using the kirchhoff's voltage law to the meshes.

Q: For the following zener clipper draw the output waveform Vz1 = 5V, Vz1 7V ,VK = 0.8v lkn ISV V₁ -5V…

A: As per Bartleby policy we can answer only only one question at a time. As you have not mentioned, so…

Q: Open- and short-circuit test has been performed of a synchronous machine 45-kVA, three- phase,…

A: It is given that: V=220 Vf=50 HzKVA=45P=6 OC characterstics:VLL=220 V,If=2.84ASC…

Q: So what is the Voutput overall?

A:

Q: 5 Which of the following equations gives the output power of a salient-pole synchronous machine ? *…

A: Salient pole alternators are used in hydraulic turbines or diesel engines. Salient pole alternators…

Q: Q4: At an operating frequency of 300 MHz, a lossless 50-W air- spaced transmission line 2.5 m in…

A:

Q: 20. Microprocessors works with binary systems in digits of 1's and O's. What is the representation…

A: Computers read only the voltage that means i.e. high or low. It is like a simple switch. Binary…

Q: Calculate the total losses and the saturation flux density (in dB) present in the satellite link…

A: We need to find out the total losses and power density

Q: Sendent current s pute 100 mH Sketch the current waveform b. At what instant of time is the current…

A: Given Current source current at t<0,   i=0                                      at t>0 , i=10…

Q: Write down the trigonometric Fourier series representation of the following signal: x(1)₁ JU 0 -T B…

A:

Q: current through the armature of a motor changes from +3.0-A to - 3.0-A in 0.0030 s. A 104- V induced…

A: We need to find out the inductance for given Change in current

Q: if a positive charge Q=100uC is located at the origin in rectangular coordinate system. Determine…

A: Magnetic field is a place where the influence of the magnetic lines of force are felt.

Q: 2) Solve the meshes and order the matrix of the following way: [AB] Then, what is the value of A?…

A: The required parameters can be calculated by using kirchhoff's voltage law to both the meshes.

Q: For the circuit in Figure, solve the nodes and order the matrix as follows: B] [1 C c. What is the…

A: The required parameters can be calculated by using the kirchhoff's current law to the nodes.

Q: Q4: An op-amp multivibrator circuit is constructed using the following components. Ri Rr=35k2, R =…

A: In this question we will find frequency of oscillation of opamp multivibrator......

Q: A coil is wound with 500 turns. When a current of 4 A flows the total flux threading the coil is…

A:

Q: Circuit Diagram V1 R1 50 Q 220 Vrms 60 Hz 0.⁰ L1 100mH Computed Values Compute the expected power…

A: It is given that: R1=50 ΩXL=2πfL1XL=2π×60×10×10-3XL=3.769  Ω

Q: 14 Open- and short-circuit test has been performed of a synchronous machine 45-kVA, three- phase,…

A: Unsaturated synchronous reactance is calculated using Vph on airgap line and armature current at…

Q: (b) Write the following in a (remember that the angles П (i) 3, (ii) [5, 4 (iv) [√2, -37]

A:

Q: "Van = 175∠259°, Vbn = 175∠139°, Vcn = 175∠19°" A   POSITIVE PHASE SEQUENCE B…

A: In this question,  We need to choose the correct options What is phase sequence of the given…

Q: Vab = 200 cos (t - 10°), Vbc = 200 cos (t - 230°), Vca = 200 cos (t - 110°)" A   POSITIVE PHASE…

A: In this question,  We need to choose the correct options What is phase sequence of the given system?…

Q: a. IB. b. Ic c. VCE. d. Vc. e. VE. f. VB. g. VBC. For the emitter-bias network, determine: +20 V 430…

A:

Q: 1. Calculate the RMS value of the current waveform and determine the average power absorbed by a…

A:

Q: Q1: Design a second order low pass filter at a cutoff frequency of 2kHz with a pass band gain of 20.…

A:

Q: calculate the magnitude of the vector field

A:

Q: sampled signal

A: Low Pass Filter-It is the  filter which passes only the frequencies lower than the specified…

Q: W 5.00 X 13 10.0V, 0.500 6.0V, 0.100 4.00 5.00 N 8.0V, 0.300 ||² Z

A:

Q: Q4-The armature winding of 4-pole, 250V d.c. shunt motor is lap connected. There are 120 solts, each…

A: In case of DC Shunt Motor, Flux considered as constant Torque is directly proportional to product of…

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.