Find the average power absorbed by the resistor R R-900

Q: "If Va is equal to 302angle;74 and Vab is 523.079/44, the phase sequence is:" O POSITIVE O NEGATIVE

A: A phase sequence is called positive when the Phasor is rotating in clockwise direction in a balanced…

Q: Wider pulses leads to narrowband radiation True False O

A: We need to tell about whether the given statement is true or false

Q: Using ones' complement, a) 6510-2310 Add/Subtract the following. b) 2310 - 6510

A: It is given that: a) 6510-2310b) 2310-6510

Q: Q4) Find an orthogonal set from the following set of signals by utilizing Gran-Schmidt…

A: Given  A series of signals and we need to find the orthogonal set using  Gram- Schmitt…

Q: 2. Determine the following for the network shown below: a. b. ZiAMP C. Z.AMP d. ) ATAMP Given…

A:

Q: A modulating signal f(t) is bandlimited to 5 kHz is sampled at a rate of 15000 samples/ sec. The…

A:

Q: Calculate ict) in the circuit of Figure below 6.12

A: Given circuit is shown below. At t=0-, The inductor is short circuited

Q: A pattern detector which gives 1 at its 1-bit output when the last four values of its 1-bit input…

A: Given: A pattern detector that gives 1 at its 1-bit output when the last four values of its 1-bit…

Q: Find the Inverse Laplace of F(s) = S+4 s²+8s+4

A:

Q: Two point charges exert force of 0.49 grams on each other. If the charges are 3.2 cm apart and with…

A: We need to find out the value of charge particle

Q: .3 Find the charge q(t) flowing through a device if the current is: (a) i(t) = 3 A, g(0) = 1 C (b)…

A:

Q: What is the value of ix?

A: Brief description: For the above given question we need to calculate the value of current ix.

Q: "If Vc is equal to 2942133 and Vab is 509.223243, the phase sequence is:" O POSITIVE O NEGATIVE

A: In this question,  We need to choose the correct options What is phase sequence if Voltage Vc and…

Q: Electrical Engineering 6. Gyroscopes used for vehicle stability are different from those used for…

A: Solution of first question: It is asked to tell which sensor parameters are different when…

Q: A three-phase 20 MVA, 11 kV generator has a reactance of 10% and is connected via a bank of three…

A: Selected MVA base is 10 and KV base is 15KV impedance base, ZB=VB2SB=15210=22.5ΩCurrent base,…

Q: The discrete time Fourier series representation of a signal x[n] with period N is written as x[n] =…

A: Given : period N=3 Fourier series coefficients are   a(-3)=2   and   a(4)=1

Q: 2. Explain electrical contact resistance. Holm model of electrical contact resistance. Contact…

A: It is asked to explain contact resistance and the Holm model of contact resistance. Also it is asked…

Q: Obtain the transfer function H(s) = Vo/V₁. Suppose vi(t) = V₁cos(wt). Obtain the steady state…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Given the circuit below and the associated set of voltages and currents, the reactive Power…

A: Brief description: In the above given question we need to calculate the value of reactive power…

Q: W 5.00 X 13 10.0V, 0.500 6.0V, 0.100 4.00 5.00 N 8.0V, 0.300 ||² Z

A:

Q: It melts whenever there is too much current in the circuit. A. Load B. Switch C. Protection…

A: 1. In electronics & electrical engineering, the fuse is a low-resistance resistor that works as…

Q: Determine Zin, Zo and the small-signal voltage gain. p type C₁ C₂ Vo D Vin Zin Rs 4k RD 2k VI -5V Zo…

A:

Q: Transformers: 1. How does the polarity settings affect Vprimary and Vsecondary?

A: Transformer:- It is a  static electric machine which transfers energy from one end to another end…

Q: A circuit has a resistance of 20 Ω, an inductance of 0.3 henry, a capacitance of 20 µF and the…

A: As connection of elements are not given. Therefore I solved it by assuming they are connected in…

Q: Q2 Find (VCH) in the circuit of Figure below 1H 22 Tout (1) V +=== F 42

A: Voltage across the capacitor: Capacitor is a energy storing device that stores energy in the form of…

Q: Find the Voltages and Currents for all the devices on the circuit below.

A: The voltage across the elements and current through the elements can be calculated by using the…

Q: sketh the output voltage for the following circuit Vsi=0-7 V=0.8 aka www A -30 Si Di Y. ,2;

A:

Q: Q5: Design a Clapp oscillator, the three capacitors are C₁=C₁=C3=1000 pF, while the frequency is to…

A: We need to find out the range of inductor for given frequency

Q: Q2) The conditional probabilities of a binary transmission system with non-return zero signaling are…

A: Conditional probability is known as the possibility of an event or outcome happening, based on the…

Q: "If Ibc is equal to 663.3752106 and la is 383angle;16,the phase sequence is:" O POSITIVE O NEGATIVE

A: Phase sequence is a order in which phase voltage are placed in a three phase network.

Q: ● Calculate

A:

Q: e) Calculate the noise margin for a logic gate with the following logic levels: VIL = 1.1 V, VIH =…

A: Bartleby has policy to solve only one question and its first 3 subparts. So reupload the question.

Q: For each of the following transfer functions, write, by inspection, the general form of the step…

A: As per Bartleby Policy we can answer only one question at a time. As you have not mentioned so I am…

Q: -(A)-A 230 V, 2.5 KVA single -phase transformer has an iron of 100 w at 40 Hz and 70H Find the…

A:

Q: 3.44 An FM signal is represented by v = 12 sin (6 x 108t + 5 sin 1250t) The carrier frequency f and…

A: Given, An FM signal represented by v=12 sin 6×108t+5 sin 1250t

Q: 2. Explain electrical contact resistance. Holm model of electrical contact resistance. Contact…

A: It is asked to explain contact resistance and the Holm model of contact resistance. Also it is asked…

Q: a When setting the Q-point of a JFET amplifier why is the bias circuit shown in Figure 3.1 (b) used…

A: Brief description: In the above given question we need to justify importance of the voltage divider…

Q: 21. A = {1, 3, 5, 7, 9, 11, 13) and B = {1, 3, 7, 11). What would be the output of a logic gate that…

A: To solve above problem, one should understand AND, OR and NOT gate. For AND gate An AND gate will…

Q: point charge of 4 cos 10% nt μC is located at P+(0,0,1.5), while .A -4 cos 10% nt μC is at P_(0, 0,…

A:

Q: A) What are the addressing mode and physical address for each instruction if you know…

A: Given  Register address of a 8086 microprocessor.we need to determine the physical address of the…

Q: Which element (capacitor or inductor) should be placed in parallel with the circuit to achieve unity…

A: In this question we need to find which element should place in parallel to make the overall power…

Q: Questions 9 to 10 [4] Given: R₁, L, V₁. Find the Norton equivalent current IN and impedance ZN with…

A:

Q: The starting torque of a 25-hp 720-rpm synchronous motor is 150 per cent of its rated torque.…

A:

Q: Given a main metal bar (green) slides on another 2 metal bars (orange), all of them are put in a…

A: Given: The bars are placed in the uniform magnetic field. The velocity of the rod is V

Q: Given the vector field in spherical coordinate system: A = 4sindag. Determine the value of its y…

A: given here the vector field in spherical coordinate system is A= 4 sinϕaθ. here we have to find the…

Q: 1. Find V1 and the power absorbed in the resistor 12 ohms by using thevenin theorems. 74.0 16.4 Ո…

A:

Q: Q2/A Shunt motor having a field resistance of 50 and an armature resistance of 0.5 is connected to a…

A:

Q: The voltage across a 1.1-kW toaster that produces a current of 10 A is: (a) 11 kV (b) 1100 V (c) 110…

A: From the question, it is given that  POWER=1.1 kW Current (I)=10 A We have to find voltage

Q: 2. Describe the Torque-Slip characteristics of a three phase induction motor.

A: Induction motor- Induction motor is also known as asynchronous motor. Basically, it is an AC…

Q: Example 6.31. A 3-phase, 1455 rpm induction motor drives a load requiring constant torque. In case…

A: when T remains constant S1V12=S2V22So S2S1=V1V22=10.92=1.23We know that I2 ∝ SVI2'I2=S2V2S1V1=1.2×…

Sinusoids And Phasors

Sinusoids are defined as the mathematical waveforms that are used to describe the nature of periodic oscillations.

Circuit Theory

Electric circuits are a network that comprises of a closed-loop, which helps in providing a return path for the current through a switch. When the switch is activated, the load operates, and the current accepts a path to finish the circuit at a low potential level from the opposing high potential level. Electric circuits theory is a linear analysis that helps in establishing a linear relation of voltage and current for R (resistance), L (inductance), and C (capacitance).