During some actual expansion and compression processes in piston–cylinder devices, the gases have been observed to satisfy the relationship PV n = C, where n and C are constants. Calculate the work done when a gas expands from 350 kPa and 0.03 m3 to a final volume of 0.2 m3 for the case of n = 1.5.

During some actual expansion and compression processes in piston–cylinder devices, the gases have been observed to satisfy the relationship PV n = C, where n and C are constants. Calculate the work done when a gas expands from 350 kPa and 0.03 m3 to a final volume of 0.2 m3 for the case of n = 1.5.

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter17: Energy In Thermal Processes: The First Law Of Thermodynamics

Section: Chapter Questions

Problem 24P

See similar textbooks

Related questions

Q: 50% Part (b) Now find the amount of work done by calculating the force exerted times the distance…

A: It is given that, P=1.95×106 N/m2r=0.23 mh=0.84

Q: The first law of thermodynamics states that the change AU in the internal energy of a system is…

Q: Calculate the net work output (in J) of a heat engine following path ABCDA in the figure, where V1 =…

A: Write the given values from the diagram.

Q: This pV diagram shows three possible paths for changing a system from an initial state, represented…

A: Work done in PV diagram is calculated as area covered by the path process. If area covered by path…

Q: A gas expands from 0.1 m^3 to 0.5 m^3 under a constant pressure of 10kPa. What is the work done? * 4…

A: Given Initial volume of the gas is Vi=0.1 m3 Final volume of the gas Vf=0.5 m3 Pressure of the gas…

Q: A carnot engine receive 100 kj of heat from a hot reservoir at 370 celsuis and reject 37 kj of heat…

A: efficiency of carnot engine is given by n n = 1 - Qrej/ Qrece = 1 - Tc/ Th where , Qrej = heat…

Q: A gas increases in pressure from 2.00 atm to 6.00 atm at a constant volume of 1.00 m³ and then…

Q: For the two PV diagrams below, find the net work done on the gas during the process indicated by the…

A: (a) for first graph, it consists a rectangle and a small triangle. Thus, the work done is,…

Q: In an adiabatic process, oxygen gas in a container is compressed along a path that can be described…

Q: Suppose 1.00 g of water vaporizes isobarically at atmospheric pressure (1.013 × 105 Pa). Its volume…

Q: A gas is heated and allowed to expand such that it follows a horizontal line path on a pV diagram…

Q: A mass of gas is compressed in a quasi-static process from 80 Kpa, 0.1 m^3 to 0.4 Mpa,0.03 m^3 .…

A: Initial pressure: P1 = 80 kPa = 80 x 103 Pa Final pressure: P2 = 0.4 MPa = 400 x 103 Pa Initial…

Q: In an adiabatic compression of an ideal gas the volume is compressed to 1/15 of its original value.…

Q: 0.5 moles of cinnamaldehyde gas that has an initial volume of ten liters expands under the following…

Q: car tire contains 0.0350 m3 of air at a pressure of 2.10 ✕ 105 N/m2 (about 31 psi). How much more…

A: Given Volume of gas V = 0.035 m3 Pressure P = 2.1 × 105 Pa Internal energy of one mol monoatomic…

Q: A gas increases in pressure from 2.00 atm to 6.00 atm at a constant volume of 1.00 m3 and then…

Q: A 6.80-mole ideal gas system is maintained at a constant volume of 7.00 liters. If 1.70 ✕ 102 J of…

Q: 3. 0.5 moles of cinnamaldehyde gas that has an initial volume of ten liters expands under the…

A: Given- number of moles n= 0.5 initial volume Vi = 10L Temperature, T= 185 °F Pressure, P= 800mmHg…

Q: Find the work done on a system consisting of an ideal gas expanding from V0 to 2V0 along the path P…

Q: An ideal gas is taken through a quasi-static process described by P = ?V2, with ? = 2.20 atm/m6, as…

A: Work done on a gas for expanding it from volume V1 to V2 is, W=∫V1V2PdV. Where P is the pressure…

Q: Which condition results to work done greater than the change in internal energy? ΔU > 0; ΔS >…

Q: 1 kg of fluid is compressed reversibly according to a law pV = 0.25, where p is in bar and v is in…

A: Given Data: The condition is given by, pV = 0.25. The work done can be calculated as, W=-∫V1V2pdV…

Q: P (10 Pa) 3.00 2.00 1.00 - V (m³) 2.00 4.00 6.00

A: (a) When the gas expands therefore, work done on the gas is negative. Area of rectangle =…

Q: An ideal gas is taken through a quasi-static process described by P = aV2, with a = 2.20 atm/m6, as…

A: Given data: A quasi-static process P = αV2 a = 2.20 atm/m6 Initial volume (Vi) = 1.00 m3 Final…

Q: A Carnot engine operates between temperature T1 =400K and T2 = 300K. It absorbs 100 cal heat from…

Q: In the following P – V diagram, an | ideal gas is compressed to half of its original volume of 2…

A: A PV diagram is given, Initial volume, Vi = 2 m3 Final volume, Vf = 1 m3 Pressure, P = a V value of…

Q: 0.5 moles of cinnamaldehyde gas that has an initial volume of ten liters expands under the following…

Q: The formula for work in thermodynamics is given by PV=W. Suppose that at any pressure, P=h(V+Vo-1)…

A: The expression for the work done can be written as W=PVW=hV+V0-1VW=hV2+hVV0…

Q: Calculate the amount of work W done on a gas that undergoes a change of state described by the pV…

Q: Gas in a container is at a pressure of 1.5 atm and a volume of 4.0 m3. What is the work done on the…

A: (a). the work done of the gas is

Q: A gas increases in pressure from 2.00 atm to 6.00 atm at a constant volume of 1.00 m3 and then…

A: Initial pressure of the gas is Pi = 2 atm Final pressure of the gas is Pf = 6 atm volume of the gas…

Q: For the two PV diagrams below, find the net work done on the gas during the process indicated by the…

A: We know that work done is given by W= Area enclosed by P-V curve .

Q: A gas increases in pressure from 2.00 atm to 6.00 atm at a constant volume of 1.00 m3 and then…

Q: An ideal gas is at a pressure 1.00* 105 N/m² and occupies a volume 2.00 m³. If the gas is compressed…

A: Given Initial pressure is P1=1.00×10^5 PA Initial volume is V1=2.00 m^3 Final volume is V2=?

Q: Does a gas do any work when it expands adiabatically? If so, what is the source of the energy needed…

Q: A gas expands from 2.2 L to 3.6 L against a constant external pressure of 1.6 atm. What is the work…

Q: During real expansion and compression processes in piston cylinder devices, it has been observed…

Q: Look at the P-V diagram below (Diagram 1). Calculate the work done by the gas for the paths A, B and…

A: Dear student, According to the guidelines I am allowed to answer only one…

Q: Show that the work done by an ideal gas during an adiabatic expansion is: W=(P1V1 - P2V2)/γ-1,…

Q: Find the work done by an ideal gas as it expands from point i to point j along the path shown in the…

Q: A gas expands to F along the three patns Indicated in the Tigure below. CalCulate the work done on…

A: The work done along IAF = work done during isobaric expansion IA + The work done during isochoric…

Q: The internal energy of a system increases by 1350 J when the system absorbs 1150 J of heat energy at…

A: Given Change in internal energy, ∆u=1350 J Heat absorbed by system , ∆q= 1150 J Constant pressure,…

Q: A container having a volume of 5 m3 holds 8 moles of helium gas at 100°C. If the helium behaves like…

Q: If a gas in a cylinder pushes back a piston against a constant opposing pressure of 2.69 × 105…

A: Given Constant pressure is P=2.69x105 Pa Change in volume is ∆V=0.533 m3

Q: Which one of the following statements is true about a sealed ideal gas system? You can increase the…

A: Given : To choose the correct option for the case of a sealed ideal gas system.

Question

During some actual expansion and compression
processes in piston–cylinder devices, the gases have been
observed to satisfy the relationship PV n = C, where n and C
are constants. Calculate the work done when a gas expands
from 350 kPa and 0.03 m3 to a final volume of 0.2 m3 for the
case of n = 1.5.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Step 8

Trending now

This is a popular solution!

Step by step

Solved in 8 steps with 8 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

One mole of an ideal gas does 3 000 J of work on its surroundings as it expands isothermally to a final pressure of 1.00 atm and volume of 25.0 L. Determine (a) the initial volume and (b) the temperature of the gas.
When a gas undergoes an adiabatic expansion, which of the following statements is true? (a) The temperature of the gas does not change. (b) No work is done by the gas. (c) No energy is transferred to the gas by heat. (d) The internal energy of the gas does not change. (e) The pressure increases.
When 400 J of heat are slowly added to 10 mol of an ideal monatomic gas, its temperature rises by 10 . What is the work done on the gas?
A hand-driven tire pump has a piston with a 2.50-cm diameter and a maximum stroke of 30.0 cm. (a) How much work do you do in one stroke if the average gauge pressure is 2.1105 N/m2 (about 35 psi)? (b) What average force do you exert on the piston, neglecting friction and gravitational force?
An ideal gas is enclosed in a cylinder with a movable piston on top of it. The piston has a mass of 8 000 g and an area of 5.00 cm2 and is free to slide up and down, keeping the pressure of the gas constant. How much work is done on the gas as the temperature of 0.200 mol of the gas is raised from 20.0C to 300C?
An ideal gas initially at 300 K undergoes an isobaric expansion at 2.50 kPa. If the volume increases from 1.00 m3 to 3.00 m3 and 12.5 kJ is transferred to the gas by heat, what are (a) the change in its internal energy and (b) its final temperature?
Consider these scenarios and state whether work is done by the system on the environment (SE) or by the environment on the system (ES): (a) opening a carbonated beverage; (b) filling a flat tire; (c) a sealed empty gas can expands on a hot day, bowing out the walls.
Two containers hold an ideal gas at the same temperature and pressure. Both containers hold the same type of gas, but container B has twice the volume of container A. (i) What is the average translational kinetic energy per molecule in container B? (a) twice that of container A (b) the same as that of container A (c) half that of container A (d) impossible to determine (ii) From the same choices, describe the internal energy of the gas in container B.
During real expansion and compression processes in piston cylinder devices, it has been observed that gases satisfy the relationship PVn = C, where n and C are constant. Calculate the work done when a gas expands from 350 kPa and 0.03 m3, to a final volume of 0.2 m3, for the case where n = 1.5.
In an adiabatic process, oxygen gas in a container is compressed along a path that can be described by the following pressure in atm as a function of volume V, with V0 = 1L : p = (3.0 atm)(V/V0 )−1.2 . The initial and finalvolumes during the process were 2 L and 1.5 L, respectively. Find the amount of work done on the gas.