e)/ An open rectangular tank (8m) long, (3m) wide and (2m) deep is filled water to depth (1m), the tank is accelerated horizontally with constant value of ( 2 m/sec²), determine: 1- The angle of water surface. 2- The volume of water displacement because the acceleration.

e)/ An open rectangular tank (8m) long, (3m) wide and (2m) deep is filled water to depth (1m), the tank is accelerated horizontally with constant value of ( 2 m/sec²), determine: 1- The angle of water surface. 2- The volume of water displacement because the acceleration.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: (Buoyancy) An irregularly shaped piece of a solid material weighs 8.33 lb in air and 5.30 lb when…

Q: Determine the reactions at the supports of the beam loaded as shown below: A 10cm 12N 31/660 B 60°…

Q: Consider a linear elastic rectangular thin sheet of metal, subjected to uniform uniaxial tensile…

Q: Compute the amount of concrete for the wall footing that will be built for the property that is…

A: Given: Thickness of footing = 8 in = 0.67 ft Width of footing = 4…

Q: Material Strengths: Fy = 248 MPa, Fu = 400 M Pa The diameter of the holes in the 12 mm - thick plate…

Q: Problem Exercise: A concrete road 15m wide, 5 km long, is designed with a thickness as shown in the…

Q: During a steady right turn, a person exerts the forces shown on the steering wheel. Note that each…

Q: SITUATION E. A ship having a displacement of 20 000 metric tons enter a harbor of fresh water. The…

A: Given data: Displacement of seawater = 20,000 ton draft = 8.4 m SG of sea water = 1.025 area of…

Q: From the figure shown, consider 1 unit width of gate. W.S. 6 feet 6 feet 8. Compute the horizontal…

Q: Find the reaction at A and B L/2 Wo L/2 B

Q: With the aid of diagrams, explain the terms "wants" and "voids". Also, explain the need for…

A: Given: Voids and wants are terms used in measurements. After measuring an item of construction it is…

Q: The flanged steel cantilever beam with riveted bracket is subjected to the couple and two forces…

A: To find out the equivalent couple moment and resultant R at A.

Q: A man recorded 70, 71, 69, 73 paces in walking along a 50m course to determine his pace factor. He…

A: To Determine :- Distance AB Based on his pace factor.

Q: The distance between two points A and B measured along a slope was 270 m. Determine thehorizontal…

Q: Consider a linear elastic rectangular thin sheet of metal, subjected to uniform uniaxial tensile…

Q: The regular three-storey building has following plan dimensions 20 m* 20 m. Dead load on each floor…

A: Given- Plan dimensions- 20 m×20 m,dead load on floor-DL=5 kN/m2,dead load on roof-DL=4 kN/m2,LIve…

Q: A 2 m 1.3 mi 390 kg B

Q: What do we mean by nominal and effective interest rates?

Q: 5.2 For the calculation of net area of flat with staggered bolts, the area to be deducted from gross…

Q: A land has 3 linear boundaries GH, HI, and IJ. The fourth boundary JG is irregular. The measured…

A: Given:

Q: A concrete overhang beam with the section shown is to support a 150 mm thick concrete slab with a…

Q: A masonry dam of trapezoidal cross section has a height of 22 m, with one face vertical and a…

Q: Also need to know how calculate Ma

A: Given: A beam Required Calculate moment at A

Q: A cyclone has a dpc of 5 µm, what is the overall removal efficiency for air stream that has the…

A: Given, a cyclone with dpc of 5 µm Particle size (dj) % mass in that size range 3 μm 10 5 μm…

Q: The correct distance between points C and D is 213.5m. If a 100-m tape that is 0.025m too long is…

A: Given data Correc distance between C and D (Lc) = 213.5 m Correct tape length (l) = 100m Tape is…

Q: Calculate the design (LRFD) block shear rupture strength (kN) of a WT155X39.5, attached through the…

A: Answer Block shear rupture strength of a member using LRFD is given by ϕ.Rn =…

Q: We have gypsum rocks aSO4.2H2O and 20% de Molecular weight aSO4.2H2O = 172, CaSC aSO4.2H2O-CaSO4.1/2

A: CaSO4.2 H2 O → CaSO4·1/ 2 H2 O + 3/2 H 2 O when we heat gypsum rock it produces 1 mol of plaster of…

Q: A line is laid out using a 50-m tape. The standard error of each tape length laid out is assumed to…

A: To Determine :- Question 1. The standard error of the length of the line. Question 2. The correct…

Q: Solve for Shear the CS Scanned with CamScanner and moment diagram 10 kN/m 4m reactions and draw the…

Q: Two individuals are attempting to relocate a sofa by applying forces in the indicated directions. If…

A: The magnitude of force, F1 =540 NThe magnitude of force, F2 =300NThe angle between the two forces, θ…

Q: SITUATION D. From the figure shown, consider 1 unit width of gate. ws WS. 6 feet 6 feet 8. Compute…

Q: Problem #3 Am -2 m- OG 30 B -2 m- -2 m BKN C KN Y KN Determine the force in each member of the…

Q: A 50-m steel tape was used to measure a line and the initial pull = 5.5 kg. Pull at time of…

A: There are various correction to be applied in case of surveying done by tape or chain. In the…

Q: Determine the reactions in C member ACD as shown in figure? Q.5( B 800 KN 5 m + 4 m 6m C D 8m E 600…

Q: A triangular pipe network is shown in the figure. Q=70 r=1 B r=2 Q=30 Q=100 A C The head loss in…

Q: The dry bulb temperature and relative humidity for the conditions (WBT=12.6 and specific volume=0.85…

A: Given data, Wet Bulb Temperature= 12.6 C Specific Volume = 0.85 m3/kg of dry air We have to find the…

Q: A cyclone has a dpc of 5 µm, what is the overall removal efficiency for air stream that has the…

A: Given dpc = 5 µm

Q: The flow of glycerine (kinematic viscosity V = 5 x 104 m²/s) in an open channel is to be modeled in…

Q: Express your final answers in two decimal places. 3. What is the most probable value of a…

Q: show complete solution and formula What is the most probable value of a rectangular lot having the…

Q: Solve for Shear the and moment diagram P CS Scanned with CamScanner 10 kN/m reactions and draw the…

Q: Determine whether the truss is: a. stable b. statically determinate c. indeterminate to the first…

Q: Determine the vertical displacement of Point EI is Constant. 10 KN C. 6 kN/m A & 3m к Use E = 2E8…

A: The problem can be conveniently solved using Superposition principle. By superimposing the…

Q: 1. The sides of a rectangular parcel of property were measured and recorded as 249.50 m and 469.85…

A: Given:Measured lengthL=469.85 mMeasured widthW=249.50 mstandard length of the tapel=30 mlength of…

Q: A cyclone has a dpc of 5 µm, what is the overall removal efficiency for air stream that has the…

A: Answer We know that overall removal efficiency for air stream is given by ηo=∑ηj*mjM ηj =…

Q: The tension AB in the truss as shown in the figure below, is 100 N .Fill the following blanks: 2 m D…

Q: What is the equivalent constrained modulus in psf if the initial stress is 418 psf, the change in…

A: Given data:- The given initial stress, σ0=418 psf The given change in stress, ∆σ=1204 psf Maximum…

Q: A block of wood 0.20 m thick is floating in sea water. The SG of wood is 0.65 while that of seawater…

A: Given:Thickness of block=0.20 mspecific gravity of wood(swood)=0.65specific gravity of…

Q: Show Attempt History Current Attempt in Progress A submarine is modeled as a cylinder with a length…

Q: Compute the following: a. wall shear b. wall moment c. Deflection at mid-span

A: As per bartleby guidelines, only 1st question with 3 subparts need to be solved. So, for rest of…

Question

e)/ An open rectangular tank (8m) long, (3m) wide and (2m)
deep is filled water to depth (1m), the tank is accelerated horizontally with
constant value of ( 2 m/sec²), determine:
1- The angle of water surface.
2- The volume of water displacement because the acceleration.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The systems shown is initially at rest. Neglecting axle friction and the masses of the pulleys, determine the acceleration of the left block in m/s2.
8. A tank has a length of 2.5 m and width of 2.0 m and contains water at a depth of 1.15 m. If the tank is subjected to an linear acceleration of 4.25 m/s-2 parallel to the length of the tank, determine the height of the sides such that no water will be spilled.
Based on the provided differential-type manometer, calculate the difference in the pressure between points A and B (as in Δp = pA - pB = ?). SG of oil is 0.8 . Provide solution in finding the height.
Consider laminar flow of a Newtonian fluid in the y direction between two parallel andvertical plates with a distance between h, at steady state. The plate on the left isstationery and the other plate on right-hand side is moving vertically upwards at aconstant velocity Vo. Derive an equation for the velocity profile.
Assume the coefficient of friction = 0.22, A = 175N and B = 96N. Find the least value of P to cause impending motion and the value of θ.
Knowing that at the instant shown crank BC has a constant angular velocity of 45 rpm clockwise, determine the acceleration of Point A and Point D.
4. An open cylindrical tank 2 m in diameter and 4 m high contains water to a depth of 3 m. It is rotated about its own vertical axis with a constant angular speed. a. If w = 8 rad/s, how much water is spilled out and to what depth will the water stand when brought to rest?b.What angular speed w (in rpm) will just zero the depth of water at the center or the tank?c.If w = 100 rpm, how much area at the bottom of the tank is uncovered?
a stepladder consisting of two legs pinned together at C is resting on a rough floor. will 800 N worker be able to change the light bulb if he is required to climbed to a height of 1.3 m? The uniform legs AC and BC weigh 110 N and 70 N, respectively. the coefficient of static friction is 0.48
A wooden circular board 1m in diameter is being submerged vertically in a liquid having SG=1.15. Its topmost part is flushed in the liquid surface. Use 9.81kN/m3 as the specific weight of water. Find the: a) total hydrostatic force (kN) acting on one side of the board b) the distance (m) of the center of gravity from the liquid surface c) the location of the center of pressure measured from the liquid surface in meters Note: Do not round off intermediate values. Answer in four decimal places and do not include units in your answers.
Open cylindrical tank 1 m in diameter and 2.5 m high is three-fifth full of water. If the tank is rotated about its vertical axis, find the angular velocity in rpm so that water at the bottom is 20 cm away from the center.
The belt-driven pulley and attached disk are rotating with increasing angular velocity. At a certain 2instant the speed v of the belt is 1.5 m/s, and the total acceleration of point A is 75 m/s . For this instant determine (a) the angular acceleration of the pulley and disk, (b) the total acceleration of point B, and (c) the acceleration of point C on the belt.
Based on the provided differential-type manometer, calculate the difference in the pressure between points A and B (as in Δp = pA - pB = ?). SG of oil is 0.8