Answered: e phase angle of the complex power is…

Engineering

Electrical Engineering

e phase angle of the complex power is negative, then the circuit is said to be resistive. elect one: True False

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter22: Resistive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 9PP: In an RC parallel circuit, the true power is 780 watts and the reactive power is 560 VARs. Find the...

See similar textbooks

Related questions

Q: 5. Using Loop Analysis by applying KVL, write the loop equations. R, Rg 15V lov Ry

Q: Estimate the Power factor of a load, by considering the impedance diagram given below. 18 Q 15 0 R…

Q: In a star connected three phase circuit , the phase current is cube root of the Line current. Select…

A: An a.c circuit differs from a d.c circuit in many respects. First, in a d.c circuit we consider…

Q: 10오 1052 josz 9.

A: For this problem we need to find impedance across ab terminals.

Q: b) A 3-phase star-connected, balanced load is fed from an 11kV 50HZ supply. The load impedance per…

A: Find the power at 50 hz then find the power at frequency change. Then from obtained power consumed…

Q: In a 390V, 57 Hz, three phase system, the value of the reactive power without capacitor bank is…

A: Given in the question: The system voltage is: V = 390V The system frequency is, F = 57Hz The…

Q: For the adjacent circuit Vab=420V and the source part is balanced. Zan= j16Ω / Zbn= j24Ω / Zcn=…

Q: Given the circuit below. a A 220°n U,07t 100 -V 3-ø source b U,097s ICA Igc 22-30°n Explain why the…

Q: A load of 40 -j 30 is connected to a source of 100 V with a phase angle of 300, through a…

A: Given load impedance, ZL=40-j30° On comparing with ZL=R-jXC

Q: For a circuit in which R = 8.00 mN, X, = 7.00 mN, and Xc = 13.0 mN, find the impedance and the phase…

A: In this question we need to find a impedance and phase angle between current and voltage.

Q: 20 0 a -MW- 0.25H 100 0 230Vms 60 Hz b ind the following: ) Power factor of the load to the right of…

Q: There are two loads connected in parallel and powered from a 7200-V source. The first load is 50-kVA…

Q: The voltages are given in rms value in the circuit below. (a) Which type of configuration does this…

A: The solution is given below.

Q: Calculate the total complex impedance seen by the open terminals of the circuit below.

Q: A load of 40 + j 30 is connected to a source of 200 V with a phase angle of 30°, the total power…

Q: Given V0 = 3.5 ∠122, V1 = 5.0 ∠ − 10, V2 = 1.9 ∠92, find the phase sequence components VA, VB and…

Q: At Zr = (200 + j50) an impedance of Van is connected, (1002 = ZO) %3D %3D to the end of its…

A: Brief description: In electromagnetic theory in the process of smith chart we go for the calculation…

Q: Please very soon Both question required please For circuit A calculate the 1.complex impedance Za…

A: Part (a) Fig:Given circuit Given that f=600 KHz La=820 μHCa=6.2 nF Although for…

Q: 5 VZ90° 5 AZ0° 3Ω R, >4Ω 3Ω

Q: the source voltage is 240√2 sin (2л 50t) V, R = 10 ohms, and L = 50 mH. Calculate i. the mean and…

A: NOTE- As per the rules we can answer only 3 sub-parts, please post the remaining sub-parts as the…

Q: In polyphase generation of power simultaneous multiple voltages are generated with a phase angle of…

Q: 3. A 60 cycles current 2.8+j 0 flows in a series circuit having a resistance of 40 ohms, an…

Q: 5. A 250 V phase voltage supplies power to an unbalanced star connected load where the impedances…

A: 5) To find the total power drawn by the a 3-phase unbalanced star connected load

Q: A load of 40 + j 30 is connected to a source of 200 V with a phase angle of 300, the total reactive…

A: Given: ZL=40+j30Vs=200∠30o Determining the value of current through load. IL=VsZL =200∠30o40+j30…

Q: Circuit Impedance Z = (Ω) Phase Angle =arc cos R/Z= Calculate Es = (V) Calculate Ec=(V) Calculate Er…

Q: B). Three identical impedance are connected in delta across a 450V supply. The current in one of the…

Q: The formula to determine the total impedance of two parallel impedances is the sum of the impedances…

A: In this question , some statement given about circuits...We have to find that they are true or…

Q: The series capacitors reactive compensation methods are attractive for decreasing the power…

Q: Three impedances each of magnitude 15-j200 are connected in mesh across a 30, 400V supply. Determine…

A: Star Connection : A star connection is one in which each winding has one end connected to a common…

Q: What is the real power, reactive power and complex power delivered by the source in the given…

A: The solution can be achieved as follows.

Q: 2) A. Find the complex power delivered to the load that draw: 1) 500 VA and leading power factor of…

Q: a + E = EmZ0 XL n the circuit, R=6 Ohm, XL=12 Ohm, he voltage source amplitude and phase are E=96 V…

A: The thevenin voltage across ab is given as:…

Q: The positive sequence harmonics component will add current to the neutral wire. Select one: O True O…

A: we know that positive sequence components are displayed by 120 degrees each other and sum of…

Q: In a series-parallel circuit, the parallel branches A and B are in series with C. The impedances are…

Q: A 500 MVA, 11 kV,50 Hz, 3-phase generator feeds an infinite bus with voltage of 11kV. The transfer…

A: we need to find out maximum steady state power.

Q: Three identical loads with complex impedance are connected to a 3-phase network 230V/400V,50Hz. 1-…

A: As per Bartleby guidelines, we are allowed to solve only one question and only three subparts, that…

Q: circuit in the figure: A) the impedance seen when viewed from the source B) Flow C) Phase angle…

Q: If VAB in the below balanced load is 220 V, and if Z, is a parallel combination of a resistor 3.667…

Q: Q13. The input voltage wavef orm of single phase bridge is having only DCcomponent. O True O False

A: The input voltage waveform of single phase bridge is having only DC component?

Q: 7) For the parallel R-L Circuit, R = 20-2, XL = j 20-N and e(t) = 40 -0° V, f = 300HZ. Calculate the…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: Find the power factor of the circuit, and indicate whether it is leading or lagging. R-1.8 kn X, - 2…

A: In a RLC series circuit, the value of power factor (pf) of the circuit is given by: Where, The…

Q: For the single-phase circuit shown in the figure below, I=10Z30° A. Compute the phasors I,, I, and V…

A: The impedance of the branch through which the current I1 is flowing will be The magnitude and the…

Q: Calculate (a) total current and (b) equivalent impedance for the four - branched circuit shown…

A: A circuit with reactive elements (capacitors and inductors) can be analyzed like a resistive network…

Q: Determine the primary line current of the following three phase circuit using a 5:1 step-down…

A: Converting the star connection of resistance to delta we get (By star delta conversion ) value of…

Q: In case of a Balanced load, the impedance values in all three phases should be same in magnitude and…

A: Need to find true false

Q: Where N =5 ,theta=45 , the value of load reactance =1.5 What is the load power factor?

A: Power factor given by pf cos( phase of voltage - phase of current)

Q: Calculate the total power factor,

Q: 1- Your example deduced the total strength of the following three loads: the first load 1200VA at a…

A: Total strength of three loads

Q: As shown in the figure, two single-phase loads are connected in parallel to a voltage source of 200…

A: First calculate current in the individual loads and than calculate total current from the source.…

Q: Power factor of pure inductive load is O ZERO, Lagging O UNITY (1), Lagging O UNITY (1), Leading O…

A: As, the power triangle can be drawn as : As we know that, the power factor can be given by…

Question

The phase angle of the complex power is negative, then the circuit is said to be resistive.
Select one:
O True
O False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In an RC parallel circuit, the true power is 780 watts and the reactive power is 560 VARs. Find the power factor.
The admittance of the impedance j12 is given by (a) j2S (b) j2S2 (c) j4S
For the single-phase circuit shown in Figure 122,I=100A. (a) Compute the phasors I1,I2, (b) Draw a phasor diagram showing I,I1,I2, and V
For a complex circuit, the real power is 12 W and the power phase angle is 52 degrees. Estimate the value of the reactive power and apperent power.
a circuit of 0.8 lagging power factor behaves as a- an inductive circuit b- a capacitive circuit c- R L circuit d- R C circuit
A series circuit has 50 ohm resistance, 2.22 microfarad capacitance and inductance of 8 mH. Find the total impedance at 796 Hz frequency. a. 50-j150 b. 50+j50 c. 50-j50 d. 50+j130
If the impedance of a series RC circuit is given as (8- j6) ohms and is connected to an ac source of 200.50HZ then the value of capacitive reactance is Select one: a.3 Ohm b .None of these c. 5 Ohm d. 2 Ohm
The complex power for an ac circuit is given as S=5ej(pi/4) VA. What will be the value of the real power and what will be the value of the reactive power?
An inductive circuit draws a line current of 10A. If the reactive component of the line current is 6A, then power factor of the circuit is ___ . a. 0.6 lagging b. 0.857 lagging c. 0.5 lagging d. 0.5 leading
Find the total current, total impedance, phase angle and reactive power in the circuit in the attached image along with drawing the voltage phasor diagram. Vin10V, R1 2709.08ohm, R2 = 1761.351ohm, C 1 = 1.096µF, C2 1.038µF Please show working thanks a lot.
The following is given for a series R-L-C circuit: resistor (R) = 8 Ohms, an inductor (L) = 32 mH and a capacitor (C) = 800uF. The circuit is supplied by a voltage source of e = 120 sin (125t) Volts. What is the power factor?
A resistor of 20Ω, an inductor of 0.012H, and a capacitor of 90 μF are connected in series with a 100-V generator, with a frequency, 130 Hz. Calculate the power factor, the phase angle, and the phasor relationship between the current and the voltage in the circuit.