Thermal efficiency DETERMETHEMAXIMUMTHERMALEFFICIENCYOF DSTEAMPOIVERPLANTOPERATINGON 1AESIMPLE RANKINE CreLE ,IF THECONDENSER PRESSUREP IN MPOIs btte 16.4 mraMAINTAINED0.2bar

Given: A steam power plant working on a simple Rankine cycle. The condenser pressure is, P3=0.2…

Answered: EFFICIENCY DETERME THE MAXIMUM THERMAL…

EFFICIENCY DETERME THE MAXIMUM THERMAL OF D STEAM POIVERPLANT OPERATING ON THE SIMPLE RANKINE CreLE , IF THE CONDENSER PRESSURE MAINTAINED ar 0.2 bar P IN MPa

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Determine the discipation require ment in MW - megawatt thermal) for coal fired 1000 MWe power plant…

Q: Water enters the condenser at 20 ̊C and leaves at 35 ̊C. What is the LMTD if the condenser…

A: Condenser temperature Th=40°CCold fluid tempreture (water at inlet and exit)Tc1=20°C ,and…

Q: A Rankine cycle is executed with steam expanding initially from 20 MPaa and 100 deg SH. Condensation…

A: Given:- Rankine cycle Initially at 20MPaa and 100 deg SH Condensation at 300 mm HG vac Compression…

Q: A two cascade refrigeration system uses ammonia as the refrigerant. the mass flow rate in the high…

Q: A Rankine cycle is executed with steam expanding initially from 20 MPaa and 100 deg SH. Condensation…

Q: Steam is supplied to a two-stage turbine at 48 bar and 400 °C. It expands in the first turbine until…

A: It is required to determine specific heat input

Q: The evaporator and condenser temperatures are -20°C and 35°C, respectively, in an ammonia simple…

Q: COP of the simple vapor compression refrigeration cycle R-717 evaporation temperature is -5 ° C and…

Q: 3. An ideal reheat regenerative unit receives 18 Mpa of steam at 780°C. Reheat occurs at the first…

A: Now calculate enthalpies at all states through steam tableAt stage 1 P=18Mpa…

Q: A turbine receives steam at 8.5 MPa, 400°Cwith condensing pressure of 0.06 MPa. Determine the Cycle…

Q: A power plant is to be operated on a Rankine Cycle with superheated steam exiting the boiler at 4…

Q: The ASME evaporation units of a boiler is 24,837,500 KJ/hr. The boiler auxiliary consumes 1.5MW.…

Q: Define C.O.P. of the simple vapor compression refrigeration cycle R-134a. The evaporation…

Q: Consider a steam power cycle operating according to the simple ideal Rankine cycle. Steam enter the…

A: Pressure of steam at turbine inlet, P3=4 MPa Temperature of the steam at turbine inlet, T3=400oC…

Q: A refrigeration system using R22 is to have a refrigerating capacity of 15 Tons of refrigeration.…

A: Given data Refrigerant is R22 Refrigerating Capacity = 15 Tons of refrigeration = 52.75279 kW Cycle…

Q: Find C.O.P from simple vapor compression refrigeration cycle R717. The evaporation temperature is -5…

A: Given data: Lower temperature (TL) = -5 degrees Celsius =…

Q: Avapor-compression heat pump has a heating capacity of 500 kl/min and uses Refrigerant 134a asthe…

A: Given data Heating capacity of heat pump= 500 kJ/min = 8.33333 kJ/sThe following are the various…

Q: Steam is generated at 4.1 Mpa and 440 OC and condensation occurs at 0.105 Mpa. For a Rankine cycle…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: A vapor compression refrigeration cycle uses refrigerant-134a as its working fluid. The condenser…

Q: Find C.O.P from the simple vapor refrigeration cycle R-717. evaporation temperature is -5 ° C and…

A: Evaporation temperature = -5 C Condenser temperature = 40 C Find COP

Q: Define C.O.P. of the simple vapor compression refrigeration cycle R-134a. The evaporation…

Q: he condenser pressure is 0.035 bar. Draw the T-S diagram for the cycle and calculate the Rankin ycle…

Q: A vapour compression refrigeration cycle operates ween the condensation temperature of 20°C and…

Q: IS the worKi cycle Supe vapor at 8 MPa, 480C. The condenser pressure is 8 kPa. The net power output…

Q: Define C.O.P. of the simple vapor compression refrigeration cycle R-134a. The evaporation…

Q: An ammonia simple saturation cycle operates at 35 psia suction pressure and 172 psia condenser…

Q: A10KW couling luad is to be Seved by perating retrgeration cycle with its evapurator ad Yu0 HPasnd…

Q: eges ard Boiler tion 4. T1 T2 P2 Qioad Thermal 3 process 8. load 6. FWH 101 7. 9. Steam supply…

Q: The low pressure turbine in a regenerative cycle receives 10 kg/s steam at 600kPa, 500 C. The…

A: Given: The mass flow rate of steam, m = 10 kg/s The pressure at the entry of turbine, P1 = 600 kPa…

Q: A plant using R134a refrigerant has a cooling capacity of 352 kW of refrigeration. It evaporates at…

A: Note: According to Bartleby guideline first three subparts are solved. Please upload other parts…

Q: In an ideal Rankine cycle, steam is generated at 4.1 MPa and 480 deg. C. The condenser is at 32 deg.…

A: Given data Condition of steam entering the turbineP1 = 4.1 MPa = 41 barT1 = 480 °CCondenser…

Q: Find C.O.P from a simple vapor compression refrigeration cycle R-134 evaporation temperature is -15…

Q: An air conditioner using refrigerant-134a as the working fiuid and operating on the maintain a space…

A: Space temperature=36o CTemperature of evaporator = 36-4 = 32o C

Q: In a Rankine cycle, the steam at inlet to turbine is saturated at a pressure of 450 psia and the…

A: a. Turbine Work:- 304.74 Btu/lb b. Condenser heat flow:- 770.69 Btu/lb c. Rankine efficiency:-…

Q: In an ideal Rankine cycle, steam is generated at 4.1 MPa and 480 deg. C. The condenser is at 32 deg.…

Q: Natural gas boiler with power otput 10 kW oper with efficiency 90% without flue gas…

Q: Define C.O.P. of the simple vapor compression refrigeration cycle R-717. The evaporation temperature…

A: Note: Since you have asked multiple questions, we will solve the first question for you. If you want…

Q: I. Draw the h-s & T-s diagram of the system below CONSIDERING "WORK IN" AS PROCESS 1-2. 2 POUT…

Q: In an ideal Rankine cycle, steam is generated at 4.1 MPa and 480 deg. C. The condenser is at 32 deg.…

Q: A steem power plant operates between a boiler pressure of 52 bar and a condenser pressure of 0.045…

A: Boiler pressure, PB = 52 bar Condenser pressure, Pc = 0.045 bar

Q: which of the thermodynmic property remains constant in conenser of a steam power plant. a. enthalpy…

Q: Define C.O.P. of the simple vapor compression refrigeration cycle R-717. The evaporation temperature…

A: Given Data: The condenser temperature is, T1=40°C=40+273 K=313 K. The evaporation temperature is,…

Q: Define C.O.P. of the simple vapor compression refrigeration cycle R-717. The evaporation temperature…

Q: Beiler Py000 P "punpin' Pumpl Turbine Condenser Figure 2 (b) Determine the themal efficiency of the…

A: given; at turbine inlet pressure P2=P3=6000KPa and temperature T=6000csuperheated…

Q: Refrigerant 22 is the working fluid in a Carnot vapor refrigeration cycle for which the evaporator…

A: COP = 5.72

Q: Saturated vapor is condensed to saturated liquid in a condenser. The heat capacity ratio is The…

Q: An ammonia simple saturation cycle operates at 35 psia suction pressure and 172 psia condenser…

A: Evaporation pressure, Pe=35 psiaCondenser pressure, Pc=172 psiaCooling load, Q˙e=1600 Btu/min

Concept explainers

Forms of Energy

Energy is described as the capability to accomplish a task, like the ability to push a block by applying force on it. It is a quantitative property that is used to accomplish work on an object.

Question

Thermal efficiency

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1.

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Step by step

Solved in 7 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A bicycle tire with a volume of 0.00212 m3is filled to its recommended absolute pressure of 495 kPa on a coldwinter day when the tire’s temperature is −15 °C. The cyclist thenbrings his bicycle into a hot laundry room at 32 °C. (a) If the tirewarms up while its volume remains constant, will the pressureincrease be greater than, less than, or equal to the manufacturer’sstated 10% overpressure limit? (b) Find the absolute pressure inthe tire when it warms to 32 °C at constant volume.
Identify the state of the fluid: R134a at 400kPa, with a specific volume of 0.0223m3/kg
Amachinecomponentissubjectedtoavariablestresswhichfluctuatesbetween+300MPaand–150MPa.DeterminethevalueofminimumultimatestrengthaccordingGoodmanrelation.Takeendurancelimitas525N/mm2andfactorofsafetyas2.
ASAP Pls dont round off initial values, round off final ans only ty The pressure 24 meter below a liquid is 786.41 kPa, determine its mass density (kg/m³).
Steam generators are a type of heat exchanges that are used inpower plants to generate steam at desired pressure andtemperature (Fig. Q1.b). In a steam generator, saturated liquidwater at 30°C enters a 60-mm diameter tube at the volume flowrate of 12 L/s. After exchanging heat with hot gas, the waterchanges to steam and leaves the generator at a pressure of 9 MPaand a temperature of 400°C. During this process, the diameter ofthe water/steam tube does not change. Where necessary, assume air as an ideal gas and consider R = 287J/(kg.K), Cp = 1005 J/(kg.K), Cv = 718 J/(kg.K). (i) Calculate the steam mass flow rate and inlet velocity of the steam? (ii) What is the exit velocity of the steam? (iii) Calculate the rate of heat transfer (in MW) required tochange the phase of liquid water to steam.
Five hundred kilograms per hour of steam drives a turbine. The steamenters the turbine at 44 atm and 450C at a linear velocity of 60 m/sand leaves at a point 5 m below the turbine inlet at atmosphericpressure and a velocity of 360 m/s. The turbine delivers shaft work at arate of 70 kW, and the heat loss from the turbine is estimated to be 104kcal/h. Calculate the specific enthalpy change associated with theprocess
36. The top floor of a building is 20 m above the basement. Show that the water pressure in the basement isnearly 200 kPa greater than the water pressure on the top floor.
For the draining liquid fi lm of Fig. , what are theappropriate boundary conditions ( a ) at the bottom y 5 0and ( b ) at the surface y 5 h ?
At 86 degrees Fahrenheit (°F) and 111.83 psi absolute, R-134a boils (itchanges from a liquid to a gas). One pound of liquid R-134a occupies0.0135 cu ft of volume. When it changes to a gas, it requires 0.4132 cu ftmore space. What volume will 1 pound of R-134a occupy as a gas at 86°Fand 111.83 psi?
Consider a U-tube whose arms are open to the atmosphere. Now equal volume of water and light oil (ρ=790 kg/m3) are poured from different arms. A person blows from the oil side of the U-tube until the contact surface of the two fluids moves to the bottom of the U-tube, and thus the liquid levels in the two arms are the same. If the fluid height in each arm is 102 cm, determine the gage pressure the person exerts on the oil by blowing.
A 5L rigid container contains Acetylene initially at gage pressure and temperature of 100 KPa and 300 K, respectively. Because of the leaks in the fittings of the vessel, the gage pressure dropped to 80KPaand the temperature decrease to 200K, determine the mass of the Acetylene that leaked out.
Air at 29oC with a rate of 0.03 kg/s enters a circularpipethat is constructedunderthewater. Thewatertemperature is kept at 17oC andconvectioncoefficientforwater is hw= 1500 W/m2.K Pipeproperties k=0.15 W/m.K Do=17cm Di=15cm a) Inordertoreach an airoutlettemperature of 21oC determinethereguiredpipelength b) What is required fan powertomovetheairthroughthepipe?