Eight resistances [identical] are connected in series across 220-V line a. Identify the voltaege drop across each resistance b. Assuming that the current is 1A, what is the R of each device? c. What is the power dissipated in each?

Eight resistances [identical] are connected in series across 220-V line a. Identify the voltaege drop across each resistance b. Assuming that the current is 1A, what is the R of each device? c. What is the power dissipated in each?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter12: Batteries And Other Sources Of Electricity

Section: Chapter Questions

Problem 14RQ: 14. A 6-V lead-acid battery has an A-hr rating of 180 A-hr. The battery is to be load-tested. What...

See similar textbooks

Related questions

Q: A capacitor of capacitance 2 µF is charged. to a potential difference of 200 V. After disconnecting…

A: Given, A capacitor of capacitance, C1=2 μF Charged to potential difference of, V = 200 V After…

Q: Given the circuit below, compute for the following, (fin = 60Hz) a. Peak to peak ripple b. Filtered…

A: In this question, We need to determine the peak to peak ripple voltage and filtered dc value? We…

Q: How much equivalent capacitance in the three capacitors having capacitance of 1,000 microfarad…

Q: Give the Area of application of HPS lamps 1. 2. 3. 4.

A: HPS Lamps stands for High Pressure Sodium Lamps. It has many applications like daily usage.

Q: Q1// Si transistor to be used in cct. Shown below has a current gain ß that varies from 50 to 200 if…

Q: Consider a sampled data system y(k) 5 %o U(t) ZOH S+2 By choosing a sampling interval of T=0.2s,…

A: Transfer function: It shows the relation between the output and input of the system. This is…

Q: If the input voltage in the figure below is increased, the peak negative value of the

A: Diode- When diode is forward biased it is short circuited in a circuit ideally. When diode is…

Q: 1. Provide the outputs of Q3, Q2, Q1, and Q0 by completing the timing diagram of the…

A: Timing diagram: The timing diagram shows at what timing flip-flop works when the input signal is…

Q: QUESTION 3: The diff-amp configuration shown in Figure 11.7 is biased at 3.3 V and -3.3 V. The…

A: Given The diff-amp configuration shown in Figure 11.7 is biased at 3.3 V and -3.3 V. The maximum…

Q: Draw the voltage vm as a function of time when Zo = Ro = 500 for figure shown 50Ω S3 ↑ 5002 个个 Vs Vm…

A: In this question we need to draw Vm as a function of time

Q: A 10-hp six-pole 60-Hz three-phase induction motor runs at 1160 rpm under full-load conditions.…

A: In this question, We need to determine the the slip and the frequency of the rotor currents at full…

Q: 2. find the current i. 12 V 4Ω AM fi M 3Ω Μ 4Ω ΤΑ

A: Given,

Q: Solve for Vo = Volts. =10 mA R₁ =2kQ w

A: In this question we need to find a voltage Vo

Q: 37. A 3 Q resistor having 2 A current will dissipate the power of (a) 2 watts (b) 4 watts (c) 6…

A: A 3 Q resistor having 2 A current will dissipate the power of

Q: 3) Let's design a 1mA current source with this NMOSFET. For the circuit below, write an equation for…

Q: A 600 kVA, 1-ph transformer has an efficiency of 92 % both at full- oad and half-load at unity power…

Q: The given power triangle is for a motor. How much current is consumed by this motor if the supply…

A: Given, Power triangle Supply voltage is 230 V at 60 Hz.

Q: what is the benefits in power system of defining vector group of 3 phase transformer. ..

A: Vector group: Vector groups provide information about the winding of the high voltage side and low…

Q: Example1/ An open wire T-L with R=10 K/Km,L=3.7 mH/km, C-8.3x 10-⁹F/Km and G=0.4x 10-6U/Km, find…

A: The solution is given below

Q: QUESTION 4: Consider an idealized class-B output stage shown below. The output stage is to deliver…

A: Given Consider an idealized class-B output stage shown below. The output stage is to deliver 42 W of…

Q: Draw the following rectifier circuits with an input voltage of 12 Vrms and an RL=2K. Determine the…

A: Diodes are used in uncontrolled Rectifiers Rectifiers convert Alternating source to pulsating DC or…

Q: Draw the voltage vm as a function of time when Zo = Ro = 500 for figure shown www 50Ω O S3 个个 502 Vs…

A: In this question we need to draw Vm as a function of time

Q: A B Ca D 2 -2

A: In order to implement nmos two input AND logic it takes 3 Nmos . Nmos implementation for two input…

Q: 5- A single-phase transformer, working at unity power factor has an efficiency of 90 % at both…

Q: Two single phase alternators operate in parallel

A: For KVL equations- Summation of voltage drops in a closed loop is always zero. For KCL equations-…

Q: 4- When a 100-kVA single-phase transformer was tested in this way, the following data were obtained:…

A: The efficiency of a transformer is a measurement of the performance factor of the windings. This…

Q: In the circuit shown below, the op-amps are ideal. Then Vout in volts is 1 ΚΩ 1 ΚΩ -2 VoM Μ +15 V…

Q: (b) Consider the high-pass transitional filter: C ㅏ x1 파 R1 R2 W x1

Q: 15. A light bulb draws 300 mA when the voltage across it is 240 V. The resistance of the light bulb…

A: Given I = 300mA , V. = 240V Find R

Q: Evaluate the matrix operation

A: Given, The matrix is 164-389-27-1+-24-14-17-5618=

Q: 20cos(10t+90)+ 1092 www VA elle +₁₁ 1H 50 HI F 10cos (10t)v

A: The solution is given below

Q: (a) What must be the charge (sign and magnitude) of a 1.45-g particle be for it to remain stationary…

Q: 2- Find the transfer function of the system whose Bode diagram is given in Fig.2 MaB 20 dB/dec. 30dB…

Q: A three-phase induction motor has the following parameters: Uc 380V,

A: Three Phase Induction machine- This Induction machine comprises of rotor and stator as it basic…

Q: Determine the critical frequency for the figure below:

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: (c) Design a 3-bit synchronous counter using falling edge-triggered T flip-flops. The counter…

A: Using excitation table we filled state transition table. circuit entering 100 state analysis is done…

Q: 80022 j125022 -J4502 Vs = 100 Sin (wt) V Soive for polar & Phasor form of Ziz, VR, V₂, Vc

Q: (d) The control system, in has an open-loop transfer function, k G₁G₂H= = (1 + ST2) (1 + ST3)² 1…

A: In this question we need to check the system stability

Q: A 3 phase mesh-connected AC generator has a power angle of 15.4 degrees and synchronous impedance of…

A: The solution is given below

Q: A system is described by the following differential equation. d²y(t) dy(t)__dx(t) + dt dt = + 2x(t)…

Q: Calculate work-function difference at T=27°C between Aluminum (4.1eV) and Boron doped Silicon.…

Q: 11.43 In a three-phase balanced system, a delta-connected source supplies power to a wye-connected…

Q: 1- A 200-KVA transformer has an efficiency of 98 % at full-load. If the maximum efficiency occurs at…

Q: What is the inductor current if VL is 500 sin(50t + 20°)? 4 5 sin(50t - 70°) 5 sin(50t + 20°) 5…

A: The inductor voltage is VL=50sin50t+20°

Q: The characteristic impedance of a transmission line is 70 ohms and has a load of 35 ohms. The SWR…

A: The solution is given below

Q: FIND THE TOTAL FLUX DENSITY IN REGION: 1>=Y>=10 1>=Z>=2 X=0 If an infinite current sheet of k= 3ay…

A: In this question we will find flux density due to given infinite current sheet...

Q: (d) The control system, in has an open-loop transfer function, G₁G₂H = G₁ H G₂ k (1 + st2)(1 +…

A: The control system block diagram is shown below, The open-loop transfer function…

Q: Given two continuous time signals x(t)= et and y(t) = e 2t, which exist for t > 0, the convolution…

A: The solution is given below

Q: 10- A 10-KVA, 500/250-V, single-phase transformer has its maximum efficiency of 94 % when delivering…

Q: Find total current

A: Given circuit,

Question

Eight resistances [identical] are connected in series across 220-V line

a. Identify the voltaege drop across each resistance

b. Assuming that the current is 1A, what is the R of each device?

c. What is the power dissipated in each?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

14. A 6-V lead-acid battery has an A-hr rating of 180 A-hr. The battery is to be load-tested. What should be the test current, and what are the maximum permissible amount and duration of the voltage drop?
Given the combination circuit, determine what is required below. a. What is the voltage drop across the 16-ohm resistor? b. What is the power rating of the 8-ohm resistor?
Given the combination circuit, determine what is required below. What is the current in the 20-ohm resistor? What is the voltage drop across the 16-ohm resistor? What is the power rating of the 8-ohm resistor?
For the circuit, determine (a) the current supplied by each battery, (b) the current through the 15-ohm resistor and (c) the p.d. across the 10-resistor.
PLEASE SHOW COMPLETE SOLUTIONA. What is the current in the 20-ohm resistor? B. What is the voltage drop accross the 16-ohm resistor? C. What is the power rating of the 8-ohm resistor?
Two 25-volt batteries having an internal resistance of 0.2 ohm and 0.4 ohm repesctively supply power to a 2-ohm load. How much current is delivered by each battery? Use counterclockwise
1. Using Volt-Ohm-Multimeter (VOM), explain how would you measure the resistance of a) R1, b) resistance of R2, c) resistance of R1 + R2
A 12 V source is connected across a 10 resistor.(a) How much energy is used in two minutes?(b) If the resistor is disconnected after one minute, is the power during the firstminute greater than, less than, or equal to the power during a two-minute interval?
what is the total resistance of the circuit? what is the total current of the circuit? what is the current in 20-ohm resistor? what is the voltage drop across the 16-ohm resistor? what is the power rating of the 8-ohm resistor?
If the voltage at resistor rx is 12 volts. What is the total current and the voltages at the 5ohm and 10kohm resistors and the value of RX in ohms?
Test 1. Simply the circuit diagram showing one source and one load. Find RT Current trough 4.7k-ohm resistor Current trough 500-ohm resistor Power dissipated across 750-ohm resistor Voltage across 750-ohm resistor Voltage across 3k-ohm resistor Total current Total power If the voltage source is being doubled while keeping the resistances in its value, what happen to the total current? Explain.
Three resistors are connected in series across a 12-volt battery course. It has found to be that the first resistor has a value of 1-ohm, the second has a voltage drop of 4V and the third has a power dissipation of 12 Watts. Calculate the value of circuit current.