Electric Generator The armature in an electric generator isrotating at the rate of 100 revolutions per second (rps). If themaximum voltage produced is 310 V, find an equation thatdescribes this variation in voltage. What is the RMS voltage?(See Example 6 and the margin note adjacent to it.)

Electric Generator The armature in an electric generator isrotating at the rate of 100 revolutions per second (rps). If themaximum voltage produced is 310 V, find an equation thatdescribes this variation in voltage. What is the RMS voltage?(See Example 6 and the margin note adjacent to it.)

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter25: Electromagnetic Induction

Section25.1: Electric Current From Changing Magnetic Fields

Problem 8PP

See similar textbooks

Related questions

Q: Provide six key concepts about Inductance and briefly discuss each

A: Definition of Inductance: Inductance is the magnetic flux that is relative to the rate…

Q: Current Attempt in Progress The headlights of a certain moving car require 11 A from the 12 V…

A: Given, Current (I) = 11A. Voltage (V) = 12 V. Efficiency η = OutputInput =78% =0.78

Q: (LO-3,LO-7) An experiment is performed by using the circuit given below. In the circuit R = 110 kQ…

Q: Difference between OPEN LOOP and CLOSE LOOP?

Q: de can function as a clipper and clamper. Compare and ex erences of the output voltage waveform…

A: Clippers reduce the amplitude while clampers shift the DC level. 1 clipper limits the voltage while…

Q: Electric Current The current in an alternating circuit varies in intensity with time.If I represents…

Q: When a switch ima. Circuits is closed, the light turns on. Explain why this happens.

Q: During the winter, an electric heater runs for 10 minutes while conducting a charge of 7500C. What…

A: Basic Details The current in the circuit can be determined as the ratio of the charge and the time…

Q: A wind turbine produces 50 volts and 20 amperes at a certain wind speed. You measured the…

Q: Explain why AC current is used for power transmission.

Q: QUESTION 3: State the transmission power record if the incident power is assumed the total power…

A: The incident power is assumed to be total power received.

Q: When a 240 V power supply supplies current which changes direction 100 times per second to the…

Q: A lamp is connected in series with a capacitor. Predict your observations for dc and ac connections.…

Q: determine the health-related benefits and safetv rA trekking Dun f 3. Diagram B Series speaker A)…

Q: The transformer works on the principle of We construct and understand the working of the two types…

Q: If the reverse voltage across the varactor in Figure below is increased, the frequency will Tuned…

A: For a given varactor if the reverse bias voltage increases then we have to answer the effect of…

Q: If you had a 1 kHz signal to display, you should set the horizontal to __________.

Q: Fill in the blank with comect answers: Vo AC circuit. The voltage-current phase diagram shown in the…

A: In a given graph, it can only contain two curves of voltages of EMF and inductor. Hence the picture…

Q: Q1. We have a DC voltmeter and we want to measure an AC voltage using a fall wave rectifier. If the…

A: Here given a DC voltmeter but wanted to measure AC. The voltmeter shows 4v We have to find the value…

Q: Q3: Explain in details the Voltage Standing Wave Ratio. Support your answer with equations.

A: When two waves having the same amplitude and frequency travel through the same medium in the…

Q: Fill in the blank with correct answers: ww purely resistive RLC Series purely capacitive purely…

A: For purely resistive circuit , voltage and current are in phase. For purely inductive circuit ,…

Q: Learning Goal: To analyze op-amp circuits that invert the voltage applied to the negative op-amp…

Q: The high voltage pulse generator circuit is used to stabilize the source supply by generating…

A: Discharging:If the plates of a charged capacitor are connected through a conducting wire, the…

Q: Before World War II, some radios got power through a “resistance cord” that had a significant…

A: Electrical energy is Ee=V2R×t Heat energy is Eh=mcΔθ

Q: For the circuit in Problem 5, calculate the final current flowing through the inductor if the…

A: in this question first of all we find Requivalent and then we find IL by current division.

Q: A voltage occurs across an open switch. What is the power dissipated by the open switch?

A: Open switch

Q: + AC The voltage-current phase diagram shown in the picture is for a circuit.

A: In this phasor diagram current is leading with a phase difference Φ. Generalized sinusoidal wave…

Q: The transformer works on the principle of We construct and understand the working of the two types…

Q: Integrated Concepts Hydroelectric generators (see Figure) at Hoover Dam produce a maximum current of…

A: (a) The power output is given by, Pout=IV Here, I is the current and V is the voltage. Substituting,…

Q: A power plant produces a voltage of 6.0 kV and 150 A. The voltage is stepped up to 250 kV by a…

A: Given that The input voltage and input current to the transformer are V1 = 6.0 kV , I1 = 150 A…

Q: Transformers: *From previous question Part D- In a transformer, the primary coil contains 400 turns,…

A: The relation connecting number of turns and current is. here I1 is the primary current, I2 is the…

Q: Question 15 If the output current for the transformer in the preceding problem is 1.8 A, what is the…

Q: 1. Derive the expression for the frequency of a LC circuit.

A: For the expression for the reonant frequency of LC circuit. which is also known as resonant…

Q: Explain how AC and DC current are different in your own words. Give an example of when you might…

A: Differences between AC and DC currents: 1. DC(Direct Current) ideally has fixed values and does not…

Q: Explain RLC circuit?

A: To be very basic, an RLC circuit primarily consists of 3 components that are, a resistor, an…

Q: PARALLEL (Resis Example 11: Two resistor connected in parallel acros Determine: ( the Total C…

A: Voltage = 20 V R1 = 8 ohms R2 = 16 ohms

Question

Electric Generator The armature in an electric generator is
rotating at the rate of 100 revolutions per second (rps). If the
maximum voltage produced is 310 V, find an equation that
describes this variation in voltage. What is the RMS voltage?
(See Example 6 and the margin note adjacent to it.)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

There is a voltage across an open switch, such as in Figure 21.43. Why, then, is the power dissipated by the open switch small?
A voltage occurs across an open switch. What is the power dissipated by the open switch?
A rectangular circuit containing a resistance R is pulled at a constant velocity V away from a long, straight wire carrying a current I0 (see below). Derive an equation that gives the current induced in the circuit as a function or the distance x between the near side or the circuit and the wire.
Consider the circuit shown below. Write the three loop equations for the loops shown.
Before World War II, some radios got power through a “resistance cord" that had a significant resistance. Such a resistance cord reduces the voltage to a desired level for the radio’s tubes and the like, and it saves the expense of a transformer. Explain why resistance cords become warm and waste energy when the radio is on.
Integrated Concepts A short circuit in a 120-V appliance cord has a 0.500- resistance. Calculate the temperature rise of the 2.00 g of surrounding materials, assuming their specific heat capacity is 0.200 cal/g.°C and that it takes 0.0500 s for a circuit breaker to interrupt the current. Is this likely to be damaging?
Why is the power dissipated by a closed switch, such as in Figure 21.43, small?
Apply the loop rule to loop abcdefghija in Figure 21.52.
Integrated Concepts Cold vaporizers pass a current through water, evaporating it with only a small increase in temperature. One such home device is rated at 3.50 A and utilizes 120 V AC with 95.0% efficiency. (a) What is the vaporization rate in grams per minute? (b) How much water must you put into the vaporizer for 8.00 h of overnight operation? (See Figure 20.42.)*******
Integrated Concepts A current balance used to define the ampere is designed so that the current through it is constant, as is the distance between wires. Even so, if the wires change length with temperature, the force between them will change. What percent change in force per degree will occur if the wires are copper?