PROCEDURE B- CAPACITORS AND INDUCTORS IN DC CIRCUITS In this PROCEDURE section. you will investigate the behavior of capacitors and inductors within DC circuits. 1. Construct the circuit shown below, Assume that R = 22002, R2 - 12000, Rs = 8200, L- 100mH, and C - 0.1pF. 12 R3 Vs 1 Vae 2. Set the DC supply output voltage to 9 Volts. 3. Using theoretical analysis determine the expected currents h, IL hand I. What is the current divider equation for the current in resistor R;? h and 1. Record these values in Table 5.

PROCEDURE B- CAPACITORS AND INDUCTORS IN DC CIRCUITS In this PROCEDURE section. you will investigate the behavior of capacitors and inductors within DC circuits. 1. Construct the circuit shown below, Assume that R = 22002, R2 - 12000, Rs = 8200, L- 100mH, and C - 0.1pF. 12 R3 Vs 1 Vae 2. Set the DC supply output voltage to 9 Volts. 3. Using theoretical analysis determine the expected currents h, IL hand I. What is the current divider equation for the current in resistor R;? h and 1. Record these values in Table 5.

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 5RQ

See similar textbooks

Similar questions

a) We assume that the switch is on. Calculate the reactance values and find the charging current in the circuit below. Is the circuit capacitive or inductive? Show that the voltage across the capacitance can be slightly larger than the source voltage U. (This is called the Ferranti effect and means that we can get a voltage rise beyond overhead lines with small loads. This is mostly relevant at the highest voltage levels. The frequency f is 50Hz, and assume voltage U= √2⋅24kV
Provide 3 sample calculations involving DC circuit under transient current condition on series R-L and Series R-C circuit? Need a simple supplementary explanation, can't quite understand the definitions I have currently.
Considering that the power loss of a resistor is RI^2 and the information in the manual’s background section, derive an expression for the energy lost through Joule heating in a resistor when a capacitor completely discharges.
A current waveform in Figure Q1(a)(i) is applied to the circuit input, is, inFigure Q1(a)(ii). Assuming that the capacitors are initially uncharged, find theoutput voltage, ??(?).
The specific capacitance in F/g can be estimated by using both cyclic voltammetry curves atdifferent voltage scan rate and Galvanostatic charge-discharge curves. The following graphshows the charge-discharge curves of a typical MnO2 pseudocapacitive electrode. There is acharge drop in the voltage at the onset of the discharge curve (one such drop is denoted bydeltaV2). What is the reason behind it?
TOPIC: Combination Circuits
What do you understand by Ferranti effect? Subject Power Transmission and Distribution
An 8 μF capacitor is a 200 V DC in series with a 0.5 MΩ resistorlinked to source. According to this;a) τ =?b) Initial value of charging currentc) The time required for the voltage at the capacitor ends to become 160 V.d) 4 s after connecting to the source, i =? and Vc =? Calculate the values.
What do you think will happen to the current if the frequency is adjusted higher in the pure inductance experiment? and what will happen to the current if the frequency is adjusted lower in pure inductance experiment? explain why please
What similarities can you draw between the formulas of finding the capacitance and resistance in series and parallel circuits?
Write down the equations for the instantaneous charge and current for charging and process in a dc RC series circuit. At t = RC, find the percentage of charges and currents in both the processes? How to find the time constant from current vs. time and charge vs. time graphs.
please write introduction and conclusion of lap report about AC Circuits – Verification of Ohm’s Law