For the discrete signal shown below: Determine the following.x(n)22 3 4 5 6 7 8 9Find DFT for x(n).Find FFT for x(n) decimation in frequency DIF.

Answered: Image /qna-images/answer/42513cd7-58ca-4e35-9f16-48628cd8b8ae.jpg

Answered: For the discrete signal shown below:…

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

What is the relationship between the analog signal frequency F and the digital signal frequency f? (T is the period of the sampling period)a. F = f * Tb. F = F * Tc. No connectiond. Nothing is right
Signal and system problem.plz solve every step with formula
Ex: Find the mathima tical expression f the follaning discrete signal:- x(n) 4 Solii- 4 indicate park-part from which fun. Gming. -3 -e 5 6 raty) -ist part (from left) is va 4) but fri 2.
4. A 70 year old man was taken to hospital due to chest pain the doctors immediately took him to ICU and did the ECG. The ECG signal is analyzed on spectrum analyzer to find the problem. Assuming that spectrum analyzer internally contains DSP system to do the given task. The ECG signal taken from the patient has bandwidth of 70Hz in that the required signal bandwidth is only 60Hz remaining part of the signal represent the noise. Design a DSP system that accepts only the required signal and samples it and the sampled spectrum contains 40Hz separation between neighboring spectral components and this discrete time signal is transformed into frequency domain using 16 point DFT find the following.i. Find the cutoff frequency of the antialiasing filterii. Find the sampling frequency of the sampler usediii. Find the Frequency of X(4) and X(8) iv. Draw the block diagram of the designed system
The SNR of an AWGN channel is 41 dB. The input signal power is 424 mW. What is the channel noise power? Select one: a. 3.368e-5 W b. 0.01034 W c. 17.38 W d. 0.003779 W e. 41.42 W O O O O
Fill in your bole algebra training with karnaugh in the image.(Do not discount.)
4. A signal with power 7 mW is distorted by noise with power 0.002 mW. What is the signal to noise ratio (SNR) in dB?
One of the following is a periodic DT signal x[n]: Select one: O a. all of the given options b. sin (2 pi? n/17) O c. sin(2 pi n / 17) O d. sin(2 n /17)
[10] Compute the DTFT of the following discrete time signal and also plot the amplitude and phase spectrum of x[n]. x[n] = a"u[n] – a""u[-n]
DIGITAL COMMUNICATIONS H.W. Q1/ A) Find the sampling frequency for the following signals: 1) S1 = 20 cos(1500nt) * cos (4000nt) 2) S2 = sin (200xt. 3) S3 = sin4000nt + 5 cos(1200nt) nt B) The following waveform is the RB (return to bios) representation of the serial digital data, find the digital data code and draw the NRZ (non-return to zero) and RZ (return to zero) waveforms. C) waveform below is the PAM for the analog signal, draw the analog signal, PWM and the PPM for this signal. 02/ The following data stream (10011011 11001110 11110000 10001000 11100000 11011010 11111111 01110111 10011001 11100111 01011010) will be transmitted with signaling rate equal to 80 k bit/sec. 1- Find the data transmitted using L- parity, V- parity and L&V parity. 2- Find the Hamming code of the last byte of the data only in which two error can be detected and one error can be corrected, calculate the transmitted bandwidth? how can reduce the transmitted bandwidth? Explain and calculate the reduced…
If the signal to be analyzed is an analog signal, then we pass the signal to an antialiasing filter where B is the bandwidth of the filtered signal. What sampling frequency (Fs) should be used to make this signal discrete/digital?
Draw the expected signal waveform across R1. Draw the expected signal waveform across R2. What is the expected signal frequency of the signal across R1?

SEE MORE QUESTIONS

Recommended textbooks for you

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Fundamentals of Electric Circuits

Electrical Engineering

ISBN:

9780078028229

Author:

Charles K Alexander, Matthew Sadiku

Publisher:

McGraw-Hill Education

Electric Circuits. (11th Edition)

Electrical Engineering

ISBN:

9780134746968

Author:

James W. Nilsson, Susan Riedel

Publisher:

PEARSON

Engineering Electromagnetics

Electrical Engineering

ISBN:

9780078028151

Author:

Hayt, William H. (william Hart), Jr, BUCK, John A.

Publisher:

Mcgraw-hill Education,

SEE MORE TEXTBOOKS

For the discrete signal shown below: Determine the following. x(n) 2 2 3 4 5 6 7 8 9 Find DFT for x(n). Find FFT for x(n) decimation in frequency DIF.