In a tansistor, IC = 100 mA and IE = 100.2 mA. The value of B O50 O100 about to1 O 200

Q: What are the AC characteristics of a common base amplifier?

A: BJT is a current controlled Device in which base current control the mode of operation.  Mode of…

Q: g. Sketch the resulting fixed-bias configuration.

A: The fixed bias configuration can be designed by using the DC analysis of the amplifier circuit.

Q: Find the value of R for maximum power transfer in the network and the maximum power that can be…

A:

Q: table shown Table 4-11. ABLE 4-11 A B 1 1 1 1 1 1

A:

Q: 13. The signal conditioning used for a thermocouple is (a) a Wheatstone bridge (b) a differential…

A:

Q: A transmission line of characteristic impedance of Zo=50 ohm with length of A/4 loaded by a load…

A: Given: A transmission line is having Characteristic equation, Z0=50 Ω Length, L=λ4 Load impedance,…

Q: 5. Determine the total propagation delay from each input to each output for each circuit in Fig.…

A: The propagation delay is the time taken by the logic gate to produce output with change in input.

Q: The voltage reading from an oscilloscope shown below indicates that Vpp = volts, Vp = volts, and…

A: In this question,   We need to determine the peak to peak voltage, peak voltage and rms voltage?

Q: For the fixed-bias configuration of Fig. 118, determine: a. IBo b. Ico VCEg d. Vc- VB- f. VE- 16 V…

A:

Q: 14. A type J thermocouple is used to measure temperature with reference temperature 0 °C. If the…

A: Thermocouple: A thermocouple is made consisting of a welded 'hot' junction between two dissimilar…

Q: Determine the steady-state value of the closed-loop system in response to a unit set-point change.…

A:

Q: AC circuit contains resistor 18.7 0, inductor 18 mH, and capacitor 560 µF, where they are connected…

A:

Q: a) Refer to the circuit diagram below; R = 1K, Vcc = 20V, D1 = D2. A follow; (i) Determine the class…

A: Given: Consider the following circuit diagram: Here, R=1 kΩVCC=20 VD1=D2 To find: (i) Determine the…

Q: Given the information appearing in Fig. 119, determine: a. lc. b. Rc. Rp. d. VCE- C.

A: In this question,   We need to determine the current IC  and Rc, RB  and VCE  .  Assume forward bias…

Q: What is un-bypassed Rs and bypassed Rs?

A: In the BJT emitter resistance can be bypassed or un-bypassed. as shown in figure1 Rs is bypassed and…

Q: A 5 hp motor (mechanical power), wye connected with a 208V line: a. What is the apparent power…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 14. A type J thermocouple is used to measure temperature with reference temperature 0 °C. If the…

A: Thermocouple:  A thermocouple is made consisting of a welded 'hot' junction between two dissimilar…

Q: 4. A Normally-Open Pushbutton is used in the Micro850 PLC control system to control Lamp 1 and Lamp…

A: PLC- Programmable Logic Control. It is technique or a method which is used to automate the…

Q: (iv) The motor being delta connected rather than star connected.

A: (iv) Wehn motor is connected in star connnection then the supply voltage is 3 times than the motor…

Q: Example25/ T-L with Zo=600 0,ZR = 100 Q. Find the length and location of the %3D single stub…

A:

Q: I need to convert the drawing from a handwritten drawing to a typeface on the computer, please

A: Given handwritten circuit,

Q: Determine the percentage voltage error of a potential transformer with the system voltage of 11,000…

A: Given, system voltage or primary voltage of potential transformer=11000v Measured Secondary…

Q: 5) Determine the equivalent Impedance for the circuit below

A: In this question,   We need to calculate the equivalent Impedance for the circuit below.?

Q: Which of the following devices can storage energy: resistors, capacitors and inductors. Explain.…

A: In this question we will find capacitance with given data and equivalent capacitance....

Q: Given the open loop transfer function in a unity feedback system is K(s-1) G(s)=s(s+2)(s+3) Form the…

A: Given open loop transfer function, Gs=Ks-1ss+2s+3 Unity feedback, Hs=1

Q: Solve for the value of: ID  VG,  VGS

A: In this question,   We need to determine the Solve for the value of: Drain current ID  Voltage VG…

Q: I need to convert the drawing from a handwritten drawing to a typeface on the computer, please Vs E

A: We have to draw the image on computer.

Q: followin RMS, resistor R=900 0, find the value read by the DC (average) ammeter. (Assume ideal…

A: We need to select the correct option for current .

Q: The voltage reading from an oscilloscope shown below indicates that Vpp volts, V, = volts, and Vrms…

A:

Q: 22 RV IS used f Vary the gain. Show that vo is given by: RI Rz RI Yo =

A: The given circuit diagram is shown below: To prove: Vo=2R2R1(1+R2Rv)(Vi1-Vi2)

Q: Question No.84 Three loads, each of resistance 50 Q are connected in delta to a 400 V, 3-phase…

A: In this answer we will find the phase voltage and phase current as explained in the below solution.

Q: What is the working principle of the Permanent Magnetic Moving Coil Movement (PMMC)

A:

Q: 30. A commercial pressure sensor is used to measure gage pressure Pgage of a gas container. If the…

A: Gauge pressure of any system is referred as overpressure it is nothing but the pressure experienced…

Q: What are some of the potential complications associated with the use of communication equipment?

A: Communication Equipment- Equipment which refer to the communication process. Some equipment which…

Q: Calculate and plot the torque-speed characteristics for a four-pole induction motor. The motor…

A: Given: A 4 pole induction motor has the following parameter: rs=24.5 Ωrr =23 ΩXs = 10 ΩXr = 40 Ω Xm…

Q: True or false: Terminal A has a 50 element that is used to protect a line that is connected from…

A: A statement is given in the question. We need tell whether the statement is true or false.

Q: Open write T-L with L=30 m , ZR = Z, = 50 N , f=50 MHZ Find Z, and Za d = 10 m S

A: Provided the formula for calculating impedance at a distance x from receiving end. Substitute given…

Q: 22. A commercial strain gauge has Gauge Factor GF=2 and initial resistance Ro = 120Ω. If the strain…

A:

Q: What are the maximum rate and bandwidth of BPSK modulation?

A: Types of Phase shift keying ( PSK) PSK BPSK QPSK O- QPSK 8 PSK 16 PSK

Q: The bandgap of a semiconductor varies with temperature according to the following dependence: Ec (T)…

A:

Q: : A- An ideal class-B power amplifier uses single transistor with 1kQ load; the d.c collector…

A: Given  For a single transistor Class B Power amplifier, RL = 1kilo ohms  = 1000 ohms  Idc = 10mA =…

Q: what voltage of battery will work in 6v solar panel? can i connect 2 pieces of 6v solar panel to…

A: The solution is provided in the following section.

Q: In the power system  the magnitude of the sending end and receiving end voltages are kept at 1pu.…

A: Steps: Find total load demand and total power injected at bus bar Find angle using active power P…

Q: Example25/ T-L with Zo=600 0,ZR = 100 Q. Find the length and location of the %3D single stub…

A:

Q: Example23/ Two transformers (4) are designed to match a line having a Z. 3002 , ZR = 75N find Stable…

A:

Q: What application best suits a series-connected DC motor?

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Example23/ Two transformers (4) are designed to match a line having a Z. %3D 300.2 , ZR = 75N find…

A:

Q: 3. A type J thermocouple is used to measure temperature with reference temperature 20 °C. If the…

A: Thermocouple: A thermocouple is made consisting of a welded 'hot' junction between two dissimilar…

Q: OSA) A 480-V 375-kVA 0.8-PF-lagging Y-connected synchronous generator has a synchronous reactance of…

A:

Q: For the given network, determine lo using Thevenin's theorem. (single- phase AC circuit) 2420°v 50…

A: In this question,   We need to determine the current Io in the circuit using the Thevenin theorems.…