Problem 4. Determine the value of voltage V shown in Figure 5.6. 492 50 V- 6Ω L

Q: Use the concept of source 4Ω ΜΑ 20/0° V to find Vo 14 Ω m -201₂ Ω transformation -j3 Ω ΠΩΕ ΖΩ

A:

Q: 10 Given the potential V = sin cos . (a) Find the electric flux density D at (2, π/2, 0). (b)…

A:

Q: An EDFA amplifier has a rating of 20 dBm. However, when using an optical power meter only mW is…

A: Since you have posted multiple MCQ-type questions, we will solve the first three questions for you.…

Q: Planes x = 2 and y = - 3, respectively, carry charges 10 nC/m^2 and 15 nC/m^2. If the line x = 0, z…

A: Charge density determine the how much charge stored in a field. Charge density measure in term of…

Q: Example 10. A 3300/230 V, 50-kVA, transformer is found to have impedance of 4% and a Cu loss of 1.8%…

A: In this question we will find percentage reactance and ohmic value of resistance , reactance and…

Q: A ball is thrown vertically upward with an initial speed of 100 ft/sec from the base A of a 50 ft…

A: The given figure is shown below: It is given that: vo=100 ft/s

Q: Q2 The following reading were recorded for voltage measurement 10.1. 9.7. 10.2, 9.6 9.7, 10.1, 9.6,…

A:

Q: An RC lag circuit has a critical frequency of 10 kHz. If the resistance value is 2 kΩ,what is XC…

A:

Q: Draw block diagram 8255 I/O mode configuration according to follow- ing: • Port A mode 1, i/p mode…

A: 8255 is a  programmable peripheral device that have multiple ports. PORT A PORT B  and PORT C

Q: (a) Design an active high-pass filter circuit using op-amp and calculate the value of the capacitor,…

A:

Q: Q3) a Find laplace transform of X (t)= et sin 2t for t ≤ 0 also indicate R.O.C please solve step by…

A:

Q: 2/ Consider CMOS inverter biased at VOD = 8v a with transistor parameters of KN = Kp and VTN = - VTP…

A: For the above given question we need to calculate the critical voltage on the voltage transfer curve…

Q: 10 Given the potential V = sin cos 6, (a) Find the electric flux density D at (2, 7/2, 0). (b)…

A: In this question we will find electric flux density and work done for moving a charge with the help…

Q: 1. Sketch the output waveform for the following: a.) + 1kQ2 +8 V Si V₂ 4 V -8 V 16

A:

Q: A 3 phase AC generator have 4 poles DELTA connection with 80 turns of conductors and 0.0065 Wb flux.…

A: Types of AC Generator  Induction generator ( Rotating speed greater than synchronous speed)…

Q: A 125V Short compound, de motor has 'armature, series field and shunt field; resistance of…

A:

Q: 1. (a) A transformer coupling is used in the final stage of a multistage amplifier. If the output…

A: We need to find turn ratio of transformer

Q: This is the answer plz write white page Given, RA= 1300N RB 433N - = 50N Assume mass of man = MFx=0…

A: Answer on white paper is given as

Q: Sketch the Output waveform for the following

A: Sketch the Output waveform for the following circuit :   We know:For Si diode:VDon=0.7 Volt…

Q: (C)- Draw the mechanical characteristic of shunt and series DC motors.

A: DC series motor: The armature & field windings of series DC motor are connected in series with…

Q: The transmission line having a diameter of 4 cm and µ₁= 6 produces an internal inductance 0.12 µH/m.…

A: Given a transmission line having, Diameter, d1=4 cm Relative permeability, μr1=6 Internal…

Q: Problem 2 Find VR (t) for all time t. 202 t = 0 t = 0 • F 4 V 7. 하 2 H + VR 5 2 Ω

A: In the given circuit,  Switch are change the position across the time.  We need to determine the…

Q: The magnitude of the Complex number Z₁ Z₂ = (3+j4) (4-j3) is unity *

A:

Q: Q3) Suppose that x(t) is real-valued signal, then show that: b) if x(t) is odd, then X(f) = -2jf…

A: For the above given question we need to calculate the fourier transform of the given signal under…

Q: Feedwater economizer can recover up to 12% waste heat?  Select one: True False

A: Feedwater economizer : A feedwater economizer is used for reducing the requirement of fuel which is…

Q: What will be the resonant frequency (in kHz) of a tank circuit when the capacitance and inductance…

A: Given, A tank circuit with, Capacitance, C=0.04 mF Inductance, L=0.04 mH

Q: Balanced 3 Phase Supply A CC PC S BCN A 90 Balanced 3 Phase Load IN B The 3-phase load consumes a…

A: Methods of power measurement in three phase circuit  One wattmeter method Two wattmeter method…

Q: Problem 6. The resistance of 1.5 km of wire of cross-sectional area 0.17 mm² is 150 22. Determine…

A: Given: Resistance, R=150 Ω Length, l = 1.5 km = 1500 m Cross sectional area, A=0.17 mm2=0.17×10-6 m2

Q: Design a simple current mirror using a current of 1 µA and VGS of 1 volt.

A: Given that  I=1μA, VGS=1V The basic constant current source current mirror is shown below.

Q: Needed to be solved correctly in 30 minutes and get the thumbs up please show neat and clean work .…

A: In this question we will find susceptance of given circuit across ab....

Q: Let voltage across a load be v(t) = 20 + 40 cos(100t) volt and current through the load by i(t) =…

A: Given voltage and current equations and asked to find the RMS value of voltage and average power…

Q: A 600 kVA single phase transformer with 0.012 pu resistance and 0.06 pu reactance is connected in…

A: Given that , there are two transformer of 600 kVA and 300 KVA  We will refer the concept of parallel…

Q: (B) Solve the differential equation:- y""-3y' +2=0, y(0) = 1,y'(0) = 1, y" (0) = 0

A:

Q: Question: 2. Using mesh analysis, find vo in the circuit below. 5Α 1Ω 40 V Mw+1) Μ ΖΩ + 10 1 www 4Ω…

A: We need to find out the voltage for given circuit by using of mesh analysis

Q: Hexadecimal Subtraction: B9AC‬16  - D8BE‬16

A: Hexadecimal subtraction is calculated as

Q: B. Use open collector inverters to implement the following logic expression: X = ABCD

A: Open collector: Open collector is a defined as a current sink on a BJT transistor output. These…

Q: Q1) For the circuit shown in fig.(*), the supply voltage is v(t) = 50+ 40 sin(wt) + 30 sin(3wt-30) +…

A: In this question we need to find a power factor of the given circuit.

Q: Q3: Answer briefly: 1. A certain BJT amplifier exhibits three critical frequencies in its low…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: In the below given figure, two capacitances are in series with a 18V source. The capacitance of the…

A: Given circuit: Capacitance, C1 = 9 μF Capacitance, C2 = 3 μF

Q: Q5. Calculate the maximum and minimum collector current in (fig. 6) and find Icsat. and VCEsat. Vcc…

A:

Q: Q4) a Design a 4 input averaging amplifier.

A:

Q: Three point charges are located at the corners of an equilateral triangle as shown in the figure. b.…

A: In this question,  We need to determine the force on the charge -4uC and 2uC. Force due to 2 charge…

Q: Balanced 3 Phase Supply CC PC S B A NB N The 3-phase load consumes a totál power of 42 kW at 0.4…

A:

Q: fa A 3-phase ring main ABCD fed at A at 11 kV supplies balanced loads of 50 A at 0.8 p.f. lagging at…

A: It is given that: Section AB=1+j0.6  ΩSection BC=1.2+j0.9 ΩSection CD=0.8+j0.5 ΩSection DA=3+j2 Ω

Q: (b) The output voltage of an amplifier is 2 V at signal frequency of 3 kHz, and reduced to 0.5 V at…

A: We need to find out the output voltage for given change and we will find out change in voltage for…

Q: 10 Given the potential V = sin cos p. (a) Find the electric flux density D at (2, π/2, 0). (b)…

A: In this question we will fine electric flux density and work done for moving charge with help of…

Q: 1) A long-shunt generator running at 1000 rp.m. supplies 22 kW at a terminal voltage of 220 V. The…

A: In this question,  We need to determine the copper losses, iron and friction losses and torque…

Q: Q4. In a CE germanium transistor amplifier circuit shown in (fig. 5). Determine the 0.985. operating…

A: We need to find out the Q point coordinate for given circuit and we need to draw load line .

Q: Q3)B-A transmission line has the following per unit length parameters: L=0.2 µH/m C=300 pF/m R=5 /m…

A:

Q: A given AM broadcast station transmits an average carrier power output of 40 KW and uses a…

A: The power of the carrier wave is given by the expression as shown below:  Pc=12Ac2R Plugging the…

Z parameter

The Z-parameters that are the impedance parameters of a two-port network are defined by expressing the two-port voltages V1 and V2 in terms of two-port currents I1 and I2. The Z-parameters are calculated by open circuiting one of the two ports at a time henceforth they are called open-circuit impedance parameters.