equilibrium position and is then given an initial speed of 0.6 m/s. What are the values of the maximum speed and maximum height reached by the bob? (Take g = 9.8 m/s²) (a) hmax = 1.87 cm; vmax = 3.44 m/s (b) hmax = 2.89 cm; Vmax = 0.75 m/s (c) hmax %3D %3D = 1.87 cm; vmax = 0.75 m/s %3D

equilibrium position and is then given an initial speed of 0.6 m/s. What are the values of the maximum speed and maximum height reached by the bob? (Take g = 9.8 m/s²) (a) hmax = 1.87 cm; vmax = 3.44 m/s (b) hmax = 2.89 cm; Vmax = 0.75 m/s (c) hmax %3D %3D = 1.87 cm; vmax = 0.75 m/s %3D

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

When rowing downstream consider the following scenario. The current of the water is moving at 2 m/s in the direction you are rowing. The coefficient of drag between your boat and the water is 1.2, the area in contact with the water is 0.1 m2 and the density of the water is 1000 kg/m3. You are moving at a velocity of 4 m/s into a head wind of 4 m/s. Your coefficient of drag between you and the air is 1.4, the area in contact with the air is 0.4 m2 and the density of the air is 1.2 kg/m3. Your goal is to create a net force moving downstream that is equal to 100 N. How much force must you exert with the oar and in what direction to achieve this net force downstream?
Pumps: Two geometrically similar pumps are running at the same speed of 1000 rpm. One has the impeller diameter of 0.4 m and discharge of 30 liters/sec against a head of 20 m. If the other pump gives half of the discharge rate, then determine the head and diameter of the second pump. Answer: D=0.317 m, H=12.6 m
A chemical storage tank ruptures at a point 2 m hove the ground. Chemical leaves the tank in a jet inclined at 15 degrees to the horizontal, travelling at 10 m/s. If the flight of the chemical is ballistic and effects of air resistance are ignored, how far from the base of the tank does the jet reach? (Take g = 9.8 m/S^2). (A) 9.23 m (B) 5.10 m (C) There is not enough information to calculate the answer D) 7.61 m
13.73. A model of a motorboat is driven at 4.57 m/s by means of a jet of water 25 mm in diameter, ejected directly astern. The velocity of the jet relative to the model is 35.1 m/s. What is the driving force? Ans. 543 N
A. A motorcycle and rider have a combined mass of 350kg. The wheels each have a mass of 20kg, diameter of 500mm and radius of gyration of 200mm. The rider accelerates uniformly from 5m/s to 25m/s over a distance of 100m, whilst climbing a hill of slope 1 in 20. The average resistance to motion, including drag, is 105 N. 1. Determine the total work done as the motorcycle ascends the incline. 2. Calculate the amount of power developed during the climb. B. At another point in its journey, the motorcycle and rider travel at 80 km/h around a left-hand bend of radius 30m. Calculate: 1. The angular velocity of each of the wheels. 2. The moment of inertia of each wheel. 3. The magnitude and effect of the gyroscopic torque produced on the bike.
please answer A pump impeller rotating at 1400 rpm has an outside radius of 21 cm, the vane outlet angle β2 is 158° and the radial velocity at the outlet Cr2 is 4 m/s. Assuming radial flow at inlet, draw the theoretical outlet velocity diagram and calculate the various velocities and angles.( A)What is the theoretical head Ho, in meters, assuming that the circulatory flow coefficient η∞ = 1.,(B)In the preceding example; assume a deviation of 10° applied to β2 due to circulation after the modern theory. The flow is 30 lit/s. After drawing/illustrating the velocity diagram, find the theoretical head Ho, in meters, assuming radial flow at inlet, neglecting the deviation in inlet velocity diagram. (c)Assuming that the mechanical efficiency ηmech = 0.95, the hydraulic (or manometric) efficiency ηman = 0.8, find the required break horsepower to drive the pump.
A cylindrical tank is being filled with water flowing with constant velocity V1 through a tap (Tap 1) that has an opening of diameter D1. The tank is initially empty and contains a tap (Tap 2) placed H1 m above the bottom of the tank that drains water at a velocity of V2 = √2gh. Assuming flow through Tap 2 starts the moment Tank 1 height reaches H1 m, write the differential equation governing the change of water level inside the tank with time (dh/dt=? );i) Before water level reaches H1.ii) After water level reaches H1 up until the tank is full. Do NOT attempt to solve the differential equations!Just drive the differential equations and write the boundaries of the definite integrals.
Dynamics of Rigid Bodies Problem: 1.) A diver jumps from a height of 3.0 metres above the height of the water and touches the surface 1.0 s later. What was his velocity when he hit the water? 2.) A motorcyclist, travelling at a speed of 30 m/s, sees an obstacle 100 metres in front of him and puts on the brakes. He hits it 5.0 seconds later. If the motorcycle slows down uniformly, how fast was it going at the instant of the collision?
A 700-N marine in basic training climbs a 10-m vertical rope at uniform speed in 8 s. The power output value is 575 Watt *True or False???
Fast pls i will give u like for sure solve this question correctly in 5 min pls Consider a solid bar of length L with variable cross-sectional area given by A(x) , where x ∈ [0, L] is distance along the bar. If the sides of the bar are insulated and if A(x) varies slowly, it is reasonable to make an approximation in which the heat flows only in the x direction. Consider the rate of change of the total thermal energy between arbitrary positions x = a and b to derive a heat equation for the bar in terms of the temperature u(x, t) . You may assume the density, heat capacity and thermal conductivity are constant (i.e. constant thermal properties) and that there is no heat source.
The Texas Motor Speedway is an oval racing track with curves of radius 229 m that are banked at an angle of 24.0°. The size of the track allows for race cars to achieve speeds in excess of 400 km/h. An unintended consequence of the banked curves and high speeds is that race car drivers experience excessive G forces, especially in the "vertical" direction (with respect to their body position), causing dizziness and loss of consciousness. (a) A daring driver, pushing his car to the limit, experiences 3.52g of centripetal acceleration during one banking maneuver. What is the speed of his car during the maneuver? (Give your answer in km/h.) (b) If the driver is seated so that during the banking maneuver his upper body is aligned with the direction normal to the banked curve, what is the magnitude of the component of the centripetal acceleration along the driver's upper body? (Give your answer in terms of g.)
A river reach had a flood wave passing through it. At a given instant the storage of water in the reach was estimated as 15.5 ha.m. What would be the storage in the reach after an interval of 3 hours if the average inflow and outflow during the time period are 14.2 m3/sec and 10.6 m3/sec respectively.