?? Q1) The exhaust from an engine running on benzole was measured with the help of Orsat apparatus.Orsat analysis showed a CO2 content of 17%, but no CO. Assuming that the remainder of the exhaustcontains only oxygen and nitrogen. Benzole mass analysis is C = 88% and H2 12%. Actual Air/Fuelratio and the number of moles of oxygen required for the combustion was found to be A/F = 18.5 and%3Dwas 0.23 mole respectively. Write the chemical of the combustion of the fuel and then find the theequivalence ratio,Ø and stoichiometric ratio, 2. State wheather the mixture is rich or lean.

Here I assumed that, air contained 23% oxygen and 73% nitrogen by mass.and complete combustion of…

Answered: equivalence ratio,0 and stoichiometric…

Engineering

Mechanical Engineering

equivalence ratio,0 and stoichiometric ratio, 2. State wheather the mixture is rich or lean.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: For a mixture, the pressure and temperature are independent properities. True Fal

A: For a mixture pressure and temperature are dependent properties. It means that the boiling…

Q: Define T-v diagram for the heating process of water at constant pressure.

A: Consider the T-v diagram shown below.

Q: Enthalpy departure functions are plotted for CO2, Ar, and benzene (B) at 10 MPa pressure as a…

A: Enthalpy departure:

Q: The molar analysis of producer gas is N; 50.9%, CO 27.0%, [Example| H; 14.0%, CO, 4.5%, CH,4 3.0%,…

Q: please solve breifly In an engine test the dry volumetric analysis of the products was CO2…

A: Given data CO2 = 0.0527, O2 = 0.1338 and N2 = 0.8135 To write the complete balance chemical equation…

Q: 29- A (1 kg/s) of air with (DBT of 30 oC) mixes adiabatically with a (2 kg/s) with a (DBT of 15 oC).…

A: Calculated the mixing temperature.

Q: A gas mixture has a molar composition of 18% methane, 34% butane and the remainder is ethane. The…

Q: Identify if the following phase is saturated, subcooled, superheated, or wet-mixture. Temp Internal…

A: Given: The temperature, T = 322 The internal energy, u = 1915 kJ/kg

Q: Q1) A rigid vessel contain 5 mole of CO and 2 mole of air at 10 bar and 30 °C. Determine :- 1- the…

A: given; mole of CO(n1)=5mole of air (n2)=2pressure of mixture(P)=10bar…

Q: During the compression stroke of a certain gasoline engine, the pressure increases from 1.00 atm to…

A: Given data as per question Initial pressure =1 atm Final pressure =19.5 bar we know…

Q: A Cl engine, during suction stroke, draws Air only Mixture of diesel and air A mixture of oil and…

A: Basics of Thermodynamics are used.

Q: Define the following terms. Stoichiometric A/F ratio. Lean Mixture. Polytropic Process.

A: Stoichiometric A/F ratio Air fuel ratio is the mass of air to liquid or gaseous fuel present in the…

Q: Different sizes of vessels namely, A and B, are connected by a pipe with a valve. Vessel A contains…

Q: Determine the state of water if P= 10.0 bar and T= 179.9 C. Select one: a. Superheated Vapor b.…

A: Use of STEAM TABLE.

Q: One mol of a gaseous mixture has the following gravimetric analysis: O2 = 16%, CO2 = 44%, N2 = 40%.…

Q: 2. In the engine of a car that uses petrol as fuel, when the piston is at its highest position, air…

A: Given:P1=10 barT1=100°CT2=1500°C

Q: Asample steam has 5°C a5 the degree of superheat. Before and after throttling. its pressures 3re 40…

A: Throttling is a thermodynamic process in which enthalpy remains constant. Degree of superheat is the…

Q: volumetric analysis

A: Solution given below.

Q: 3 kg of water initially in saturated liquid 3 state at 2 bar, 25°C[vf = 0.231/m/kg, up

A: Given:m=3 kgP1= 2 barT1=25o Cvf=0.231 m3/kguf=520 kJ/kghf=510 kj/kghg=2399 kJ/kg

Q: Saturated air at 30 °C, 105 kPa is contained in 6 m tank. The mass of dry air is equal to

Q: 60% water vapor by volume. The liquid-vapor mixture is in equilibrium at 150°C. What is the quality…

Q: . For equivalence ratio of 1. Calculate (1) The volume of mixture per kg of fuel at pressure of 100…

Q: Problem(Methanol-Water Mixtures) Two methanol-water mixtures are mixed in a stirred tank. The first…

Q: Pure substance can have more than one phase, provided chemical composition is the same True False

A: It is true that pure substance can have more than one phase, provided chemical composition is the…

Q: Example A gas mixture has the following composition by volume: 20% N, 30% CO,, 50% CH. Other data:…

Q: 120 mm and stroke 180 mm under test, is supplied petrol of composition C= 82%, H, = 18% by mass. The…

Q: A pipe with a valve connects two vessels A&B of different sizes. Vessel A contains 142L of air at…

Q: INTRO THERMODYNAMIC (MAE 91/115) Moran, Shapiro, Boettner, Bailey, Fundamentals of Engineering…

A: Given data as per question

Q: Of the 3 Volume roots of the cubic equations of state which may be complex, and lying below and…

A: The problem is based on power plant and can be solved as

Q: Calculate the entropy values for a pressure of 30 bar at 300 degrees

Q: the air - Q₂) Find the stoichiometric air-fuel ratio for the combustion of C8H18 in petrol engine.…

Q: Find the specific volume and enthalpy of steam at 9 bar when the condition of steam is A) Wet with…

A: For Understanding I attached the values present in steam table at pressure=9bar.

Q: In the engine of a car that uses petrol as fuel, when the piston is at its highest position, air at…

Q: Find the enthalpy of air with wet bulb temperature of 25°C and 60% RH using psychrometric chart

A: Given data:

Q: Wet bulb temperature is 95 degrees F, RH 35%. Calculate dry bulb temperature, dew point, enthalpy,…

Q: following observations obtained in the boys gas calorimeter equipment find the gcv and ncv of the…

A: Given; V=0.08 m3∆t=9.1°Cw=29.5 kg

Q: I want the theory part about the Reid vapor pressure of petroleum products with same details

A: Introduction: Vapor pressure of any substance is the pressure exerted by the gaseous phase of the…

Q: Carbon dioxide, at 20 ° C and 1 atm, is compressed isentropicallyto 4 atm. Assume CO 2 is an ideal…

A: Given

Q: Wet bulb temperature 95 ° F, RH 35%. Calculate dry bulb temperature, dew point, enthalpy, absolute…

A: Sample procedure to identify the unknown properties of moisture air by using Psychrometric Chart.

Q: A steam generator burns fuel oil with 20% excess air. The fuel oil may be represented by C14H30-…

A: The mass of C14H30 is - 14×12 + 30×1 = 198 a) Theoretical air-fuel ratio is - AF=mass of airmass of…

Q: One mol of a gaseous mixture has the following gravimetric analysis: O2 = 16%, CO2 = 44%, N2 = 40%.…

Q: During an isentropic process of 2 of oxygen, the temperature increases from 20°C to 120°C Calculate…

Q: If state 1 is a saturated vapor. After heating, state 2 is: a. Super-heated gas b. Compressed liquid…

A: Since you have asked multiple questions in a single request we would be answering only the first…

Q: 5 mol CO, 2 mol N, and 4.5 mol Oz are brought together to form a mixture at 689.48 Kpaa, 37.8 C.…

A: As per the guidelines, 1st question is answered. Formula for partial pressure for A pA = mole…

Q: . Dry air at 25 °C and 1 bar are to be liquefied. The air is isothermally compressed to 180 bar.…

Q: Liquid water at 120°F enters a cooling tower operating at steady state with a mass flow rate of 140…

Question

Q1) The exhaust from an engine running on benzole was measured with the help of Orsat apparatus.
Orsat analysis showed a CO2 content of 17%, but no CO. Assuming that the remainder of the exhaust
contains only oxygen and nitrogen. Benzole mass analysis is C = 88% and H2 12%. Actual Air/Fuel
ratio and the number of moles of oxygen required for the combustion was found to be A/F = 18.5 and
%3D
was 0.23 mole respectively. Write the chemical of the combustion of the fuel and then find the the
equivalence ratio,Ø and stoichiometric ratio, 2. State wheather the mixture is rich or lean.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The exhaust gas analysis of an engine using octane as fuel gives equal values of CO, and unused O. Computer actual and stolchlometric air-fuel ratio. For equivalence ratio of 1. Calculate (1) The volume of mixture per kg of fuel at pressure of 100 kPa and temp 70°C.. () The volume of combustion products per kg of fuel when temp, of products is 127 c at 1 bar.
A gaseous fuel has the following percentage of composition by volume:N2: 10% ; H2: 50%CH4: 25% ; O2: 3.5%CO: 9% ; CO2: 2.5%(a) Estimate the minimum volume of air required for complete combustion of 1.0 m3of the gas.(b) If 60% excess air is supplied, give the volumes of each of the dry constituents ofthe flue gas. Air contains 21 % by volume of oxygen. Solve this problem in Tabulated Form.
2.In an engine test the dry volumetric analysis of the products was CO2 0.0527, O2 0.1338 and N20.8135. Assume the fuel is a pure hydrocarbon and that it is completely burnt.(a) Write the complete balance chemical equation on volume basis.Estimate:(b) The ratio of carbon to hydrogen in the fuel by mass.(c) The air/fuel ratio by mass.Assume the percentage of nitrogen in air is: 76.7% by mass and 79% by volume (or mole). NOTE: Do not solve this problem in tabulated form, otherwise your answer will be considered totally wrong.
Please help me (1 hour left), I will give a thumbs up Given the ultimate/gravimetric analysis of coal as follows: C=81.95%, H2 = 4.63%, S=0.96%, N2=1.3%, O2=5.75%, Ash=6.09%, Moisture = 3.05% Using ash and moisture free analysis. Determine the; theoretical air fuel ratio at 30% excess:
I will give a thumbs up. Please help me 30 mins. left Given the ultimate/gravimetric analysis of coal as follows: C=81.95%, H2 = 4.63%, S=0.96%, N2=1.3%, O2=5.75%, Ash=6.09%, Moisture = 3.05% Using ash and moisture free analysis. Determine the; theoretical air fuel ratio:
A gaseous fuel mixture has a molal analysis:H2 = 14% CH4 = 3% CO = 27%O2 = 0.6% CO2 = 4.5% N2 = 50.9%Determine the theoretical air-fuel ratio for complete combustion on molal analysis.
A fuel oil C8H18 is used in an internal combustion engine and the Orsat analysis are as follows: CO2 = 12.8% ; O2 = 3.5%; CO = 0.2% and N2 = 83.5%. Determine the actual air-fuel ratio.
A hydrocarbon fuel has the following composition of dry products of combustion by volume: 12% CO2, 0.5% CO, 4% O2, and the rest N2. Determine the air-fuel ratio. Select one: a. 19.5 b. 17.5 c. 12.5 d. 15.5
please solve breifly In an engine test the dry volumetric analysis of the products was CO2 0.0527, O2 0.1338 and N2 0.8135. Assume the fuel is a pure hydrocarbon and that it is completely burnt. Write the complete balance chemical equation on volume basis. Estimate: The ratio of carbon to hydrogen in the fuel by mass. The air/fuel ratio by Assume the percentage of nitrogen in air is: 76.7% by mass and 79% by volume (or mole). Please : Do not solve this problem in tabulated form, otherwise your answer will be considered totally wrong.
In an engine test the dry volumetric analysis of the products was CO2 0.0527, O2 0.1338 and N2 0.8135. Assume the fuel is a pure hydrocarbon and that it is completely burnt. Write the complete balance chemical equation on volume basis. Estimate: The ratio of carbon to hydrogen in the fuel by mass. The air/fuel ratio by Assume the percentage of nitrogen in air is: 76.7% by mass and 79% by volume (or mole).
1.How the analyses and calorific values of fuels can be reported? 2.Discuss crank case Ventilation, implosion and Explosion
When are mixtures termed as fuel rich in internal combustion engine?