Equivalent circuit parameters of 3 HP (HP) 220V, 50Hz, 6 poles, split phase wound induction motor are given below. The loss of the motor is = 4W. Since the slip is s=5%; Calculate the stator current, output torque, motor speed and efficiency. R1 = 2 , R2` = 3 , X1=0 , X2` =0 , Xm=∞

Q: Assume that single-input single-output (SISO) system is given as follows. Then, calculate…

A: The transfer function for the given system needs to be calculated   Based on the Bartleby…

Q: Suppose that closed-loop transfer function of a system is given as follows. 1 T(s) = s3³ +10s²…

A: In this question we need to find the lower and upper bounds of parameter k which leads the system to…

Q: 2. Calculate the following values, but do not ignore the current that is flowing into the base of…

A:

Q: A power system has 200 buses including 40 generator buses. For the load flow analysis using…

A: Total number of busbar is given in question n = 200. Number of generators given in question = 40.

Q: You visited Greece and bought a 157 W light bulb there. The operating voltage in Greece (and most of…

A:

Q: Using mesh analysis, find I, in the circuit of Fig. 3.21.

A: It is given that:

Q: Question-1) A signal with a bandwidth of 14 MHz is first passed through a low filter with a cut-off…

A: Signal bandwidth = 14 MHz.Cut off frequency, fm=5 MHz.number of bits, n=8 bits.Channel efficiency, η…

Q: Q2: For a (3-4) medium transmission line model (T cct) as shown in next figure, find the admittance,…

A:

Q: IREF=2mA, (W/L)1=4 (W/L)2=2 (W/L)3=5 (W/L)4=15 R=2kOhm VDD=24V What is Vx? ал Answer: _V002 ILEF Fyl…

A: Given IREF=2mA (W/L)1=4 (W/L)2=2 (W/L)3=5 (W/L)4=15 R=2kohm VDD=24v We need to find the value of Vx…

Q: Example: Find current across each element in the circuit shown in figure below.

A: It is given that:

Q: The equation of characteristics o the system is as follows. 1. Determine the stability of this…

A: In this question We need to check the stability of the given system and determine the number of…

Q: Part B What are the polarity and emf of the battery E, assuming it has negligible internal…

A: In this question we need to find polarity and emf of battery E.

Q: Questi Consider a plane electromagnetic wave propagating in the z-direction. The electric field…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Determine the potential difference, in V, in moving a charge from A(-4, 2, 1) m to B(-2, 4, -4) m…

A: In this question we need to find the potential difference, in V, in moving a charge from A(-4, 2, 1)…

Q: Find IN and RN For the ect. shown at 12 resistar. ? Ansi- IN=0.643A RN = 1.552 1√2 M 3V 312 212 4√2…

A: In this question we need to find the value of Norton current and Norton resistance.

Q: 5. A stepper motor has a resolution of 500 steps/rev in the 1-phase-ON mode of operation. If it is…

A:

Q: For the Feedback system below find: open loop gain, Input and output impedances (Rin, and Rout) O…

A: According to the question, for the given common gate circuit as shown below We need to calculate,…

Q: Hello! I just wanted to ask how did you get VT = 26m in the Emitter dynamic resistance in step 5?…

A:

Q: 3) If IDSS = 8 mA and VP = - 6 V in the circuit with JFET transistors given below, calculate the…

A: IDSS = 8 mA and VP = - 6 V, R1 = 910 KΩ, R2 = 220 KΩ, RD = 2.2KΩ, Rss = 1.2 KΩ, VDD = 18 V   Need to…

Q: Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be…

A: We need to find out output voltage for given operational amplifier circuit.

Q: Consider two concentric conducting spherical shells of negligible thickness separated by vacuum. One…

A:

Q: Consider the given circuit where Vx=28 V. Vz 47 0 100 22 02 7Q 70 202 ww ΦΩ 1702 mW. you will be…

A: Given: A network,  with Vx = 28 V.  To find: Power dissipated in 17Ω resistor.

Q: Create a circuit in Logisim that implements the Boolean expression: F(A, B, C, D, E) = AÐBOCODØE

A: The given boolean expression needs to be implemented in the logisim simulation software.

Q: 02A 1.11 A 0.344 A 10 V O 0,5 A + O Different answer 5Ω www Ā Khi 15 Ω Assume ideal diodes. Find the…

A: In this question,  We need to determine the current in the 15 ohm resistance.  didoes are ideal so…

Q: Why should mechanical engineers be concerned about electrical safety? Before working in an…

A: We need to discuss why mechanical engineers be concerned about electrical safety, we also need to…

Q: Problem 17. A capacitor is charged with 10 mC. If the energy stored is 1.2 J find (a) the voltage…

A: Charge on Capacitor  Q=10 mC. Energy stored, E=1.2J.

Q: 5) We usually think of wires as perfect (R=0) conductors, which is not quite accurate. Real wires…

A: Dear student, Since you have posted a question with multiple sub parts, we will provide the solution…

Q: For the system of Problem 9.11, compute the fault current and voltages at the fault for the…

A: Types of faults at 'F' are a) Single line to ground b) Line to line through fault impedance c)…

Q: A. A sinusoidally modulated AM waveform is shown below: Determine: (a) Peak amplitude of the upper…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 7.b Consider the circuit shown in Figure 7.b with i, (0)=1A and v. (0) = 1V. Solve the circuit to…

A:

Q: R₁ = ? I₁ = 500 mA P₁ = ? RT = ? PT = 300W V₁ = ? IT = 1.5A R₂ = 1000 1₂ = 1.5A P₂ = ? R₁ = ? V₁ = ?…

A:

Q: S We measured the current that appeared on the plotted screen as shown in the figure by means of…

A: The most popular form is the D'Arsonval galvanometer, which uses a light coil of wire strung from a…

Q: Find the maximum allowable value of Vin to get maximum Vout without distortion. Rin 100 Ω ww Vin Rf…

A: Op-amp with negative feedback

Q: A unit step input is applied to a unity feedback control system having open loop transfer function K…

A:

Q: C(s) D(s) (3). derive the transfer function between C(s) and D(s) (assuming that the reference input…

A: Consider the below block diagram; Here Gs is the forward path gain, Rs is the input, Cs is the…

Q: The sinusoidal signal given by v(t)=5*cos(2 pi*18"t+ 66): . a) its amplitude, . b) Frequency. . c)…

A:

Q: Q4) For the following ideal op amp: Va a) What op amp circuit configuration is this? b) Find an…

A: In this question we need to find the following What op amp circuit configuration is this ?…

Q: For the circuit below, given Vcc (a) Choose component values such that the transresistance gain has…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.

Q: 3. Determine I and Vo. Vx= 5 V for red and 3 V for blue. Blue Đ 5kQ ww V= 8 V Si Red Vo

A: In this question,  We need to determine the voltage Vo  and current I.

Q: A telephone line normally has a bandwidth of 3000 Hz (300 to 3300 Hz) assigned for data…

A: Bandwidth = 3000Hz SNR = 3162 Need to calculate the capacity of the channel.

Q: Network. Show that a model for the currents 1₁ (t) and 12(t) in Fig. 89 is f4d² 1 dt+R(I₁ - 1₂) = 0,…

A: Given Data: An RLC parallel network with, Resistor R=3 ? Inductor L=4 H Capacitor C=112F To Find:…

Q: In the single-phase power system below, determine the voltage, Vab, and current, Iab, being received…

A: Given circuit is We need to determine the voltage, Vab and the current, Iab across the load…

Q: Exercise 9. The electric field of a uniform plane wave propagating in free space is given by E = 20…

A:

Q: 3.3 The characteristic equation of a closed loop control system is s³ + 3Ks² + (K+2)s + 4 = 0. Find…

A: The characteristic equation is given as, s3+3Ks2+K+2s+4=0

Q: An induction motor having the following impedances referred to the stator side: •stator impedance:…

A:

Q: v(t)=11*cos(2*pi*116*t + 37) ile verilen sinüzoidal işaretin: • a) Genliği, • b) Frekansı, . c)…

A: The voltage equation, vt=11cos2π*116+37

Q: This is in radio wave propagation in Electronic Communication System the critical frequency at a…

A: In this question we need to find the frequency at a particular time is 11.6MHZ. What is the MUF for…

Q: What contributions are important to consider for the dissipation factor, tan 8? Please list at least…

A:

Q: For t > 0, obtain v₁ (t) and vo(t) in the circuit below. Assume Source voltage, v, = 14u(t)V, C₁ =…

A: In this question we need to find the voltage V1(t) and V0(t) for t>0

Q: 3.15 Simplify the following Boolean function F, together with the don't-care conditions d, and then…

A:

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.