Equivalent circuit parameters of a delta connected induction motor; Its equivalent impedance is (20.087+2.65i)ohm, R1=0.7 ohm, X1=1 ohm, RFe=1.6k ohm, Xm-800 ohm. The motor is powered from the mains with 50HZ, 400V effective value; a) Calculate the currents I1, I0, IFe, Im and I2.

Q: Find the voltage V, across the resistor R = 6.402 in the following circuit using superposition…

A: Superposition theorem states that a circuit with multiple sources is same as the sum of simplified…

Q: Design Problem: A pattern recognizer with a 1-bit output n accepts a 1-bit input m. Output n becomes…

A:

Q: For the circuit below, what are the output voltage and Amp-Hour measurements at the + and terminals?…

A:

Q: The feedback amplifier in Figure 1 has Rs = 20kΩ, R1 = 10kΩ, R2 = 100kΩ, R3 = 100kΩ and RL = 10kΩ.…

A: Given data:Rs = 20kΩ, R1 = 10kΩ, R2 = 100kΩ, R3 = 100kΩ RL = 10kΩOpen-loop gain a = 100,000 V/VInput…

Q: A rectangular waveguide with a=3 cm and b=5 cm as shown in the figure is filled with polyethylene…

A:

Q: A solenoid relay is operated from a DC supply. The gap forces may be taken as parallel and the…

A:

Q: determine (a) / (n² + n) 2 the z-transform ()n-¹u(n − 1) -

A: Given Data:A discrete-time signal of,To Find:Z-transform

Q: Q11 V 0.047μF R 330 Ω -O Vout Calculate the cut off frequency fe (KHz) = ?

A: C = 0.047 micro faradR = 330 ohmWe need to calculate cut-off frequency fc ?

Q: Q3. A 3-phase 20km line delivers a load of 10MW at 11KV having a lagging power factor of 0.707 at…

A: In this questionWe need to determine the regulation and efficiency of the line. We knowEfficiency of…

Q: In case of 4-pole D.C. generator provided with a two layer lap winding with sixteen coils, the pole…

A: A DC generator having,Total number of poles, P = 4.Two layer lap winding. Total number of coils =…

Q: Q5) A conventional amplitude modulated signal is given as, s(t)=[6+4 cos (4007)] cos (2800)…

A:

Q: Design a BCD ripple up counter using positive edge trigger J-K flip-flops.

A:

Q: A 100 W, 250 V lamp is connected in series with a 100 W, 200 V lamp across 250 V supply mains.…

A:

Q: In the circuit shown, If you know that the current I = 6mA and Rt = 12 kilo ohms, find the value of…

A:

Q: b) Find the secondary voltage of an iron-core transformer if the applied voltage is 20 V, and = 60…

A: An iron core transformer withPrimary voltage is given  Primary turns is given Secondary turns is…

Q: If the voltage of the carrier (Voc) is greater than from the Voltage message (Vm). Therefore the…

A:

Q: 1. For an open circuit (OC) load, the value of the reflection coefficient equal to (a) 1 (b)-1 (c)…

A: Dear student, Since you have posted multiple questions, we will provide the solution only to the…

Q: b) A 208-V three-phase power system consists of an ideal 208-V Y- connected three-phase generator…

A: A power system circuit is shown below,Line voltage, .Per phase impedance of transmission line, .Per…

Q: Q1) Short answer questions: 1. For a solid single line to ground fault the sequence networks are…

A: Faults in the power system refer to abnormal conditions which lead to disruption in the flow of…

Q: Find the charge q(t) on the capacitor and the current i(t) in the given LRC-series circuit. 1 L = h,…

A: The value of the inductor, The resistor, The cpacitor,The voltage, The initial

Q: point (i.e., Ic and VCE) of the BJT bias circuit please compute the Q-

A: For the given fixed biased BJT amplifier the Q point parameters needs to be calculated and the same…

Q: What is the total size of memory of 7 RAM memory chips where each one has a size of 64K X 8?

A: Size of each memory

Q: Obtain state-space representation for the system represented by the following differential…

A:

Q: Question 1 (a) (i) (ii) (iii) Plot the current-voltage characteristic of a p-n diode. In your plot…

A:

Q: rectangular waveguide with a=3 cm and b=5 cm as shown in the figure is filled with polyethylene hich…

A:

Q: The admittance for an inductor L is: Select one: O a. (SL) Ω-1 O b. C 1/(SL) H

A: Inductance is given as value L.

Q: Calculate the angle of refraction at the air/core interface, 0₁. critical angle, and incident angle…

A: Answer:—Given that ;Refractive index of air  ( air ) = 1Refractive index of core (core ) =…

Q: in part a are you able to explain or show the steps where the j's cancel out from…

A: It is given that:

Q: Derive a full set of equations using the nodal analysis (not actually solving them) for the circuit…

A: We need to find the current from the dependent voltages source (upwars)Circuit :-

Q: Example 7 For the circuit shown, use R1=R2=47k02, RE=5.7k 2, RC=3.3k 2, RL=10k 2 and Vcc=12V,…

A:

Q: Question 4: Determine the Currents 11 and 12 for the Network in Fig 4-4 Constructed of Standard…

A:

Q: Determine the insulation resistance of a single-core cable of length 3 km and having conductor…

A:

Q: 2. An inductor with inductance L-0.12 H carries a linearly-changing current of I(t)=5(1-2), A. What…

A: Inductance L = 0.12 H.Current

Q: Simplify the block diagram shown in Figure 2 and obtain the closed-loop transfer function C(s) R(S)…

A: The block diagram,

Q: The ___________ is the electron deficiency (or holes) at the positive pole of the applied voltage.

A: In case of the electrochemistry and semiconductor physics, There is a anode and cathode, Anode is…

Q: A parallel plate capacitor consists of two circular plates of radius 0.05 m. The medium between the…

A: Rate of change of electric field,

Q: Q1) Which one represents the bode magnitude and phase diagrams of the given transfer function H(s) =…

A:

Q: The current i of a circuit at time t is given in the table below:

A:

Q: Consider the system whose feed forward transter function is given by c 5(5+2) Design Lag…

A: The Transfer function of the uncompensated system isDesirable closed-loop pole locations are

Q: The average dc voltage of a half wave rectifier circuit is _______ of the value of the peak input…

A: Rectifier converts the input AC signal to DC signal.

Q: A single-phase to single-phase cycloconverter is supplying and inductive load comprising of a…

A:

Q: Consider the circuit below. Solve for all voltages and currents for each resistor. (V₁ to V6,1₁ to…

A:

Q: outline the operation of UJT in power electronics

A: Step-1->A unijunction transistor (UJT) is a three-terminal semiconductor device. It is a negative…

Q: Q5) A system is given as a) -3, b)-33 considering the root-locus, calculate the location of the…

A:

Q: Write an article describing the DC Generator. Provide applications of DC generator. Provide the…

A:

Q: 20 V 270 ΚΩ 1BQ VB 470 92 + + IcQ VCEQ ' 2.2 ΚΩ o Vc B=125 LOVE FIG. 4.122 Problems 8, 9, 12, 14,…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: 3. Under steady-state conditions, calculate i and v in the circuit of Figure Q3. 25 V + 10 Ω 10 F +…

A: Step-1->

Q: Q2) The single-line diagram of a three-phase power system is shown in the figure below. The inductor…

A: Solution:Given data:Synchronous generators3 rating = 1000 KVA , 750 kVA , 500 kVA and give…

Q: + www R = 60 E = 10 V 20⁰ fs Hz moo L = C=? Where : L = 10 mH, and and the resonant frequency fs =…

A:

Q: Find the charge and current in a series LRC circuit when L = 1h, R= 2002, C = 0.001 f,and E(t) = 200…

A:

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.